DAEWOO ELECTRONICS | RC-300 | User's Manual | Daewoo Electronics RC-300 User's Manual

Daewoo Electronics RC-300 User's Manual
RC-300(¿
-DESUK) 99.9.23 8:28 PM ˘
` 1
VACUUM CLEANER
RC-300
,,,,,,,
,,,,,,,
,,,,,,,
OWNER’S MANUAL
CONTENTS
•Description and operation .....2,3
•Cleaning the filter and
•Changing the dustbag ...............4
•Precautions for safe use .............5
•Specifications ............................6
•Before asking for service ...........6
READ AND KEEP THIS
¡Æ Thank you for purchasing this vacuum cleaner.
¡Æ For proper operation, please read this manual before use.
RC-300(¿
-DESUK) 99.9.23 8:29 PM ˘
` 2
DESCRIPTION AND OPERATION
SUCTION POWER CONTROL
HOSE CONNECTION
• The suction power control at
the hand grib enables you to
control suction power.
• Connecting the hose :
insert the hose firmly into
the hose inlet. (“Click”)
• Disconnecting the hose:
press the button and pull
hose out of the vacuum
cleaner.
PIPE CONNECTION
• This part can be separated
from the tube when taking a
nozzle out of it.
• To Connect the nozzle, hold
the tubes and the
handle:insert the narrowed
section into the wide section.
WIDE SUCTION NOZZLE
UPHOLSTERY NOZZLE
• Use this nozzle for cleaning
both carpeted and
uncarpeted floors.
2
CREVICE NOZZLE
DUS
RC-300(¿
-DESUK) 99.9.23 8:29 PM ˘
` 3
ON/OFF SWITCH
hose:
and pull the
cuum
• Press the on/off switch.
CORD REWIND BUTTON
• Rewind the power cord by
pressing the cord rewind button.
DUST METER
DUST METER
• When the color of the dust
meter is changed to RED for
long time, change the dust
bag.
PRACTICAL PARKING
STORAGE
brush clip
rest
DUSTING BRUSH
• If you want to stop vacuum
cleaning for a while, you can
place the brush clip into the
rest.
3
• If you want to store the
cleaner, hitch the brush clip
onto the vacuum cleaner.
RC-300(¿
-DESUK) 99.9.23 8:29 PM ˘
` 4
CLEANING THE FILTER
EXHAUST FILTER
• Switch off and lift the
handle.
• Pull the filter case
upwards from the cleaner.
• Separate the filter from the
filter case and shake the
dust out of the filter.
• Hold the cover while taking
the filter out of the cleaner.
• Shake the dust out of the
filter.
MOTOR PROTECTION FILTER
• Switch off and open the
cover.
CHANGING THE DUSTBAG
• Switch off and open the
cover.
• Hold the cover while
separating the dustbag
from the dustbag holder.
• Insert the new dustbag in the
dust bag holder properly as
shown in picture.
Note: If no dustbag has been placed
into the dustbag holder, the cover
cannot be closed.
• If you cannot purchase the RC-300/RC-350 dust bag, Please note you may use the dust bag
for the Philips Model No HR6938 OSH.
4
RC-300(¿
-DESUK) 99.9.23 8:29 PM ˘
` 5
PRECAUTIONS FOR SAFE USE
This vacuum cleaner should only be used for normal dry household dust and dirt.
The manufacturer cannot be responsible for any damage caused by use or operation of the cleaner
contrary to these instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended, no liability can
be accepted for any possible damage.
• Do not vacuum areas which contain
moisture or water and inflammable matter,
needles, pins, razor blades, matches,
cigarette-ends, etc., since they may
damage the cleaner or dust bag or make
a fire.
• When rewinding the power cord, hold the
plug body before pressing the cord rewind
button to prevent whipping.
• Do not pull the power cord out beyond the
specified length.
• Make sure a dust bag and a motor
protection filter are always inserted.
• This product provided with a cable which,
if damaged, must be replaced by a repair
shop authorized by the manufacturer since
special tools are required.
5
RC-300(¿
-DESUK) 99.9.23 8:29 PM ˘
` 6
BEFORE ASKING FOR SERVICE
■ Before Asking for Service, please check each item below if you have trouble with your cleaner.
Problem
Check Point
Measure
If dust bag is dirty, replace it.
If clogged or blocked, remove the object.
Suction power is weak.
• Dust bag
• Pipe or hose
The cleaner does not work.
Check if power cord is plugged.
• Power cord
• ON/OFF switch Check if the power switch is turned on.
Power cord does not
rewind.
• Power cord
Pull the power cord out a little and press the cord
rewind button.
Switch off and unplug the cleaner and check the
dust bag, accessories and blockages, then allow
the motor to cool down. The cleaner can be
switched on again after about 30 minutes.
When the dust bag is full or
blocked or any of the
accessories is blocked, the
over-heating protection for
the motor is activated.
SPECIFICATIONS
Model
RC-300
Rating
230V/50Hz
Watts
1100W MAX.1200W
Weights(Net)
5.0kg
Dimension (L X H X D)
354 X 240 X 262mm
Cord Length
6m
• Specifications can be changed for improvement without notice.
6
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising