VACUUM CLEANER

OWNER'S MANUAL

CONTENTS

•Names of parts and operation technique

•Replacing the dust bag

•Empty the dust box

.....................................

•Replacing the hepa filter ..................................

..........................................

•Important safety instructions

•Before asking for service

.........

............................

..................................

2

4

4

5

6

7

READ AND KEEP THIS

• Thank you for purchasing this vacuum cleaner.

• For proper operation, please read this manual before using.

NAMES OF PARTS AND OPERATION TECHNIQUE

EXTENSION PIPE

Pull(Press)

PIPE/BRUSH CONNECTION

Slide

Pipe

Button

• Press the button in the direction shown by the arrows and pull(or push) the pipe.

Suction control

Hose

• Rotate the pipes in the direction shown by the arrows and pull pipes(or floor nozzle) apart.

• If you slide the suction control on the hose, you can control the force required to push the floor nozzle.

STORAGE

Nozzle holder

Clip Nozzle holder

Clip

• Insert nozzle holder in the clip which is built onto the unit.

FLOOR NOZZLE

Carpet Hard Floor

Press

Press

• Select the appropriate setting of the pedal according to the surface to be cleaned.

2

DUST INDICATOR

• IF RED : Dust bag(or dust box) is full. Change bag or clean dust box.

• See the next page for instruction on replacing the dust bag or cleaning the dust box.

ON/OFF SWITCH

Slide

• Turn the unit off(on) by pressing the

ON/OFF switch button on the unit.

• Slide the knob to control the suction power.(RC-400B Series model)

CORD REWIND

Cord

• Press the cord rewind button to rewind the cord.

CLEANING THE FILTER

Motor protection filter

Lift

Dust cover

Pull

HANDLE RELEASE BUTTON

Hose adapter

Hose

Button

Press

• Press the button and pull the hose adapter out of the unit.

3

• Lift the dust cover upward toward you and take out the motor protection filter.

• Shake the filter to remove the dust.

• Place the motor protection filter in the correct.

• Press the dust cover firmly.

REPLACING THE DUST BAG

1

Dust cover

Lift • Lift the dust cover upward toward you. and pull the hose adapter out of the unit.

2

3

Hose adapter

• Push the dust bag holder in the direction of the arrow mark and gently pull the used dust bag upward.

Push

Throw away the used dust bag.

Guides

Press

Hard board of the new dust bag

Push

Pull

Dust bag holder

Used Dust bag

• When positioning the dust bag over the dust bag holder, you place the hard board of the dust bag between the two guides and insert the lower part of it into the bottom of the holder.

Push the dust bag holder in the direction of the arrow mark in the first position. Check to see that the dust bag holder is positioned properly in the unit.

REPLACING THE HEPA FILTER (OPTIONAL)

1 2

Filter

Lift

3

Press

Pull

Unit

Press

Filter Cover

• Pull the filter cover toward you. • Lift the end of filter upward. and throw away the used filter.

• Insert the end of new filter into the unit and press the filter cover toward unit.

4

EMPTY THE DUST BOX

1

Lift

Dust cover

2

Pull

Hose adapter

• Pull the hose adapter out of the unit and lift the dust cover upward toward you.

3

Dust box

• When releasing the dust cover, turn the hook to left.

4

Hook

Left

• Empty dirt into garbage container.

5

Press

Dust cover(Catchs)

Dust box

6

• The dust box may be washed in water.

Make sure it is completely dry before using again.

Press

Right

Hose adapter

• Please the dust cover down so that two catches.

• Press the dust cover firmly and insert the hose adapter into the unit.

5

IMPORTANT SAFETY INSTRUCTIONS

This vacuum cleaner should only be used for normal dry household dust and dirt. The manufacturer cannot be held responsible for any damage caused by use or operation of the cleaner contrary to these instructions.

If the cleaner is wrongly operated for a purpose other than that for which it is intended, no liability can be accepted for any possible damage.

• Do not use the cleaner to pick up sharp hard objects, small toys, pins, etc. They may damage the cleaner or dust bag.

• Do not pick up anything that is burning or smoking, such as cigarettes ends, matches or hot ashes.

• Do not pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.

• Hold plug when rewinding onto cord reel.

Do not allow plug to whip when rewinding.

• Do not pull the power cord out beyond the specified length.

Plug

BEFORE ASKING FOR SERVICE

■ Please check each item below if you have trouble with your cleaner.

■ Before checking, ensure the cleaner is unplugged from the power supply.

PROBLEM

Suction power is weak

CHECK POINT

Dust bag

Floor nozzle

Hose,Pipe, Accessories

SOLUTION

If it is filled with dust,change it.

Remove hair, string and lint build-up in the floor nozzle area.

If clogged or blocked, remove the object.

The cleaner does not work.

Power cord does not rewind.

Power cord is not pulled out of the cleaner.

Plug

On/Off switch

When the dust bag is full or openings are blocked, the over heating protection for the motor is activated automatically.

Power cord

Plug in firmly, push

On/Off switch to On.

Switch off and unplug the cleaner and check the dust bag, openings and blockages.

The cleaner can be switched on again after about 30 minutes.

Pull the power cord out a little and press the cord rewind button.

Do not pull it by force rewind it a little by pressing the cord rewind button and pull it out.

• Never use a damaged dust bag.

• Do not use without dust bag and motor protection filter in place.

Dust bag

Filter

Cord

• This product provided with a cable which, if damaged, must be replaced by a repair shop authorized by manufacturer since special tools are required.

• When you pull the cord out, you must hold the plug.

6 7