DAEWOO ELECTRONICS | RC-400B | User's Manual | Daewoo Electronics RC-400B User's Manual

Daewoo Electronics RC-400B User's Manual
VACUUM CLEANER
OWNER'S MANUAL
CONTENTS
•Names of parts and operation technique .........2
•Replacing the dust bag .....................................4
•Replacing the hepa filter ..................................4
•Empty the dust box ..........................................5
•Important safety instructions ............................6
•Before asking for service ..................................7
READ AND KEEP THIS
• Thank you for purchasing this vacuum cleaner.
• For proper operation, please read this manual before using.
NAMES OF PARTS AND OPERATION TECHNIQUE
EXTENSION PIPE
PIPE/BRUSH CONNECTION
Pull(Press)
DUST INDICATOR
Slide
Suction
control
• See the next page for
instruction on replacing
the dust bag or cleaning
the dust box.
Hose
• Press the button in the direction shown by
the arrows and pull(or push) the pipe.
Press
Press
Press
Press
Press
• IF RED : Dust bag(or
dust box) is full. Change
bag or clean dust box.
Pipe
Button
ON/OFF SWITCH
• Turn the unit off(on) by pressing the
ON/OFF switch button on the unit.
• Slide the knob to control the suction
power.(RC-400B Series model)
• Rotate the pipes in the direction shown by the
arrows and pull pipes(or floor nozzle) apart.
• If you slide the suction control on the hose, you can
control the force required to push the floor nozzle.
CORD REWIND
STORAGE
Nozzle holder
Clip
Slide
Press
Press
Press
Press
Press
Cord
Nozzle holder
• Press the cord rewind button to rewind
the cord.
CLEANING THE FILTER
Clip
• Insert nozzle holder in the clip which is
built onto the unit.
Lift
Dust cover
Motor protection filter
Pull
FLOOR NOZZLE
HANDLE RELEASE BUTTON
Press
Press
Press
Press
Press
Carpet
Hard Floor
Press
Press
Button
Hose adapter
Hose
Press
• Select the appropriate setting of the pedal
according to the surface to be cleaned.
• Press the button and pull the hose adapter
out of the unit.
2
3
• Lift the dust cover upward toward you
and take out the motor protection filter.
• Shake the filter to remove the dust.
• Place the motor protection filter in the
correct.
• Press the dust cover firmly.
REPLACING THE DUST BAG
1
EMPTY THE DUST BOX
1
• Lift the dust cover upward toward you.
and pull the hose adapter out of the unit.
Lift
2
Lift
Hook
Dust cover
Dust cover
Left
Hose adapter
2
• Push the dust bag holder in the direction of the arrow
mark and gently pull the used dust bag upward.
Push
Throw away the used dust bag.
Pull
Pull
Hose adapter
Dust bag holder
Press
Hard board of the
new dust bag
3
Used Dust bag
• When positioning the dust bag over the dust bag holder,
you place the hard board of the dust bag between the two
guides and insert the lower part of it into the bottom of the
holder.
Push the dust bag holder in the direction of the arrow mark
in the first position. Check to see that the dust bag holder
is positioned properly in the unit.
Push
Guides
REPLACING THE HEPA FILTER(OPTIONAL)
1
2
3
Filter
• Pull the hose adapter out of the unit and lift
the dust cover upward toward you.
• When releasing the dust cover,
turn the hook to left.
3
4
Dust box
• Empty dirt into garbage container.
• The dust box may be washed in water.
Make sure it is completely dry before using
again.
5
6
Dust cover(Catchs)
Dust box
Press
Lift
Press
Press
Pull
Press
Unit
Right
Hose adapter
Filter Cover
• Pull the filter cover toward you.
• Lift the end of filter upward.
and throw away the used filter.
4
• Insert the end of new filter into
the unit and press the filter
cover toward unit.
• Please the dust cover down so that two catches.
• Press the dust cover firmly and insert the hose
adapter into the unit.
5
IMPORTANT SAFETY INSTRUCTIONS
BEFORE ASKING FOR SERVICE
This vacuum cleaner should only be used for normal dry household dust and dirt. The manufacturer
cannot be held responsible for any damage caused by use or operation of the cleaner contrary to these
instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended, no liability can be
accepted for any possible damage.
■ Please check each item below if you have trouble with your cleaner.
■ Before checking, ensure the cleaner is unplugged from the power supply.
PROBLEM
Suction power is weak
• Do not use the cleaner to pick up sharp hard
objects, small toys, pins, etc. They may damage
the cleaner or dust bag.
• Do not pick up anything that is burning or
smoking, such as cigarettes ends, matches or
hot ashes.
• Do not pick up flammable or combustible
liquids, such as gasoline, or use in areas where
they may be present.
• Hold plug when rewinding onto cord reel.
Do not allow plug to whip when rewinding.
• Do not pull the power cord out beyond the
specified length.
CHECK POINT
Dust bag
If it is filled with dust,change it.
Floor nozzle
Remove hair, string and lint build-up
in the floor nozzle area.
Hose,Pipe, Accessories
If clogged or blocked, remove the
object.
The cleaner does not work.
Plug
Power cord does not rewind.
Plug
Plug in firmly, push
On/Off switch
On/Off switch to On.
When the dust bag is full or
openings are blocked, the
over heating protection for
the motor is activated
automatically.
Switch off and unplug the cleaner and
check the dust bag, openings and
blockages.
The cleaner can be switched on
again after about 30 minutes.
Power cord
Pull the power cord out a little and
press the cord rewind button.
Power cord is not pulled out
of the cleaner.
Do not pull it by force rewind it a little
by pressing the cord rewind button
and pull it out.
Cord
• Never use a damaged dust bag.
• Do not use without dust bag and motor
protection filter in place.
• This product provided with a cable which, if
damaged, must be replaced by a repair shop
authorized by manufacturer since special tools
are required.
Dust bag
Filter
• When you pull the cord out,
you must hold the plug.
6
SOLUTION
7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising