Dell W-620 Installation guide

620 Desk Stand Kit

Installation Guide

The 620 Desk Stand allows you to install your 620 controller vertically, reducing the amount of space it occupies.

This kit includes: z z z z z

1x Stand

1x Base

1x Lock

4x T10 Torx screws

1x T15 Torx screw

Installation

1. Attach the base to the stand as shown in Figure 1

.

a. Align the posts on the stand with corresponding holes in the base.

b. Secure the stand to the base using the four T10 Torx screws provided in this kit.

Figure 1 Attaching the Base to the Stand

0510692-02 | July 2010 1

2. Orient the controller as it is shown in

Figure 2 .

3. Insert the controller into the desk stand.

Figure 2 Placing the Controller in the Stand

2 620 Desk Stand Kit | Installation Guide

4. Complete the installation by securing the controller to the stand as shown in Figure 3 .

a. Insert the lock into the opening in the right side of the stand.

b. Insert the T15 Torx screw into the lock and tighten it until secure.

Figure 3 Securing the Controller

5. Complete the installation by connecting all the necessary cables.

620 Desk Stand Kit | Installation Guide 3

© 2010 Aruba Networks, Inc. All rights reserved.

4 July 2010 | 0510692-02