Dell W-7200 Installation Manual


Add to my manuals

advertisement

Dell W-7200 Installation Manual | Manualzz

Dell PowerConnect W-7200 Series PSU-350-AC

Installation Guide

This document describes how to install a 350W AC Power Supply (PSU-350-AC) into a Dell PowerConnect W-

7200 Series Controller. In this document, the W-7200 controller is referred to as the “device.”

Installing a Power Supply

CAUTION: Never insert or remove a power supply while the power cord is connected. Verify that cord has been disconnected from the power supply before installation or removal.

NOTE: Use standard ESD precautions when installing or removing a power supply module.

The power supply modules are hot-swappable. Hot swapping allows you to replace a failed power supply without powering down the device during the replacement process. This makes it unnecessary to shut down the device during the replacement procedure.

NOTE: If you are adding an additional power supply module, removing the pre-installed power supply module blanking plate. If you are replacing a failed power supply, see

“Removing a Power Supply” on page 2 before you continue.

1. With a Phillips Head screwdriver, turn the hinged captive screw counter-clockwise until it is loose (they cannot be completely removed).

2. Firmly grasp both of the hinged captive screws and pull the spring loaded hinge down until you are sure the hinges are disengaged.

3. Grasp the power supply blanking plate by the hinged captive screw and slide the plate out.

4. Align the new power supply module with opening in the device, as shown in Figure 1 .

5. Pull down the hinged captive screw on the power supply module and align its tab with the slot on the left side of the opening.

6. Slide the power supply module into the device.

7. Lift the hinged captive screw and secure the power supply module by tightening the screw with a Phillips

Head screwdriver. Take care not to over-tighten the screw.

0511261-01 | January 2013 1

2

Figure 1 Installing a Power Supply

8. Insert the power cord and secure it by lowering the power cord retaining clip over the power cord.

Removing a Power Supply

1. Lift the power cord retaining clip from the power cord.

2. Remove the power cable connected to the power supply module.

3. Using a Phillips head screwdriver, loosen the hinged captive screw on the front of the power supply module.

4. Lower the hinged captive screw as far as it can go.

5. Using the power supply module’s handle, pull the module out.

6. If you are not replacing the removed power supply module, install a blanking plate that was include with your device by following the installation procedure under

“Installing a Power Supply” on page 1

.

Dell PowerConnect W-7200 Series PSU-350-AC | Installation Guide

This page is intentionally left blank.

Dell PowerConnect W-7200 Series PSU-350-AC | Installation Guide 3

Contacting Support

Website Support

ain Website

Main Site

Support Site

Documentation Site dell.com

dell.com/support dell.com/support/manuals

Copyright

© 2013 Aruba Networks, Inc. Aruba Networks trademarks include registered Aruba the Mobile Edge Company logo, and Aruba Mobility Management System trademarks of Dell Inc.

, Aruba Networks ® , Aruba Wireless Networks ® , the

® . Dell™, the DELL™ logo, and PowerConnect™ are

All rights reserved. Specifications in this manual are subject to change without notice.

Originated in the USA. All other trademarks are the property of their respective owners.

Open Source Code

Certain Aruba products include Open Source software code developed by third parties, including software code subject to the GNU General

Public License (GPL), GNU Lesser General Public License (LGPL), or other Open Source Licenses. The Open Source code used can be found at this site: http://www.arubanetworks.com/open_source

Legal Notice

The use of Aruba Networks, Inc. switching platforms and software, by all individuals or corporations, to terminate other vendors’ VPN client devices constitutes complete acceptance of liability by that individual or corporation for this action and indemnifies, in full, Aruba Networks, Inc. from any and all legal actions that might be taken against it with respect to infringement of copyright on behalf of those vendors.

4 Dell PowerConnect W-7200 Series PSU-350-AC | Installation Guide

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement