Serial Port / Parallel Port PCIe Card Installation Guide

Serial Port / Parallel Port PCIe Card Installation Guide
Serial Port / Parallel Port PCIe Card
Installation Guide
Introduction
The Serial Port / Parallel Port PCIe Card easily adds
serial port(s) or parallel port(s) to your system.
Specifications
•
•
•
•
•
Bus connector: PCI Express x1
Compliant with PCI Express 1.1
Baud rate (serial port): Up to 115.2 Kbps
FIFO (serial port): 256 Bytes
UART (serial port): 16C550
System Requirements
•
•
•
•
04-1054A
Desktop PC with one available PCIe slot
Windows® 10 (32-/64-bit) / 8.x (32-/64bit) / 7 (32-/64-bit) / Vista (32-/64-bit) /
XP (32-/64-bit)
Windows Server 2012 R2 / 2012 (32-/64bit) / 2008 R2 / 2008 & 2003 (32-/64-bit)
Linux kernel 2.6 and later version
1
Package Contents
•
•
•
Serial Port / Parallel Port PCIe Card
Driver CD
Installation guide
Hardware Installation
Static Electricity Discharge may permanently
damage your system. Discharge any static
electricity build up in your body by touching your
computer case for a few seconds. Avoid any
contact with internal parts and handle cards
only by their external edges.
1.
2.
3.
4.
5.
2
Turn OFF the power to your computer and
any other connected peripheral devices.
Unplug the power cord from the computer.
Remove your computer cover.
Remove the slot bracket from an available
PCIe slot.
Carefully align the card's bus connector
with the selected PCI Express slot on the
motherboard. Push the card down firmly,
but gently, until it is well seated.
6.
7.
Replace the slot bracket holding screw to
secure the card.
Replace the computer cover and reconnect
the power cord.
Windows Driver Installation
Follow below instructions to install the driver for
the Serial Port / Parallel Port PCIe Card:
1.
After Hardware Installation, start the
computer and insert the driver CD.
2.
Browse the driver CD and choose the folder
for Win32 or Win64 according to your OS
(32-bit or 64-bit).
3.
Run StnSetup.exe, and follow the on-screen
steps to install the driver.
4.
When "Installation completed" message
shows, click Exit.
5.
Restart the computer and it's ready for use
now.
To Verify Installation
1.
Right click This PC, Computer or My
computer on the desktop, click Manage,
then click Device Manager.
3
2.
Double click Ports (COM & LPT), and below
should be displayed.
Serial Port: PCIe to High Speed Serial Port
(COMx)
Parallel Port: PCIe to Multi Mode Parallel
Port (LPTx)
Changing COM / LPT Port Number
Some serial (parallel) devices need a specific port
in order to work. If your device works properly,
do not make any changes.
1.
Double click PCIe to High Speed Serial
Port (COMx) or PCIe to Multi Mode
Parallel Port (LPT1). Refer to Verify
Installation section for more details if
needed.
2.
Click the Port Settings tab.
3.
Click the down arrow next to the COM
(LPT) Port Number. Select a COM (LPT)
port that is not in use, then click OK.
4.
Restart your system to take effect.
For more details, please go to the Support section at www.siig.com.
4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising