E-Tool Mobile Manager 8 Drawer - Rugged

E-Tool Mobile Manager 8 Drawer - Rugged
E-Tool Mobile Manager
8 Drawer - Rugged Managed
Part # 563-2000-F01-00
Part # 563-2000-F02-00
Part # 563-2000-F20-00
Publication # 095-2025-000-00 Rev. 0
www.tracewell.com/platforms/ietm/ietmlanding.php
1
614-846-6175 - 800-848-4525
Table of Contents
Cabinet Description ……………………………………………… 3
Rear Cabinet Connections ……………………………………… 4
Drawer Connections …....................................…………….. 5
Rear View with the Cover on ………………………………….. 6
Rear View with the Fan Cover opened ..….…………………. 7
Rear View with the Switch Cover removed ………....….. 8-9
Preventive Maintenance ……………………………………….. 10
Ethernet Switch Specification ………………………………… 11
Parts List …………………………………………………………… 12
Dimensions ………………………………………………….… 13-14
Warranty …………………………………………………………… 15
www.tracewell.com/platforms/ietm/ietmlanding.php
2
614-846-6175 - 800-848-4525
Chassis Description
General Specification
•
•
•
•
•
•
•
•
•
8 drawers accommodate 8 notebook computers, 1 per drawer.
o Each drawer has a 120 VAC outlet and 1, RJ45 Ethernet connection.
o Drawers provide full extension for ease of installing computer chargers and
computers.
o Drawers are vented to allow warm air to escape.
o Each drawer has a high-security lock.
Power surge protection is provided to protect all the laptops from voltage spikes.
The unit has a durable finish.
The F01 version is equipped with a Cisco Ethernet Switch, allowing a single
connection to your server.
The F02 version is equipped with a Juniper Ethernet Switch for a lower cost
system.
The F20 version has no Ethernet Switch installed, but is fully wired and tested so
the user can install a switch.
3 External Ethernet ports. One port directly to the Ethernet switch, the second
Ethernet port will allow for daisy chaining the units, and the third is used as a
console port for the managed switch.
A Single power cord provides power to all the drawers and plugs directly into a
standard 120VAC, 50-60Hz wall outlet.
Fans are provided to insure sufficient cooling while charging.
Construction Material
• Lightweight aluminum.
Cabinet Maximum Dimensions
• F01: Depth – 25.0”, Width - 21.7”, Height 61.4” (with casters)
• F02: Depth – 25.0”, Width - 21.7”, Height 61.4” (with casters)
• F20: Depth – 25.0”, Width - 21.7”, Height 59.8” (with casters)
• Without castors: Subtract 5.2” from height
Drawer Dimensions
• Depth -17.75”, Width – 17.2”, Height – 6.00”
Weight
• 160 lbs. (Without Notebooks)
www.tracewell.com/platforms/ietm/ietmlanding.php
3
614-846-6175 - 800-848-4525
Cabinet Rear Connections
Ethernet Connections to Server
ON/Off Switch
Line Cord Receptacle
www.tracewell.com/platforms/ietm/ietmlanding.php
4
614-846-6175 - 800-848-4525
Drawer Connections
(Caution! Open Only 1 Drawer at a Time)
Ethernet Connection
AC Receptacle for
Notebook
www.tracewell.com/platforms/ietm/ietmlanding.php
5
614-846-6175 - 800-848-4525
Rear View (F01 shown)
(Caution! Unplug Unit Before Removing Cover)
Fan Cover and Filter
Fan Cover and Filter
www.tracewell.com/platforms/ietm/ietmlanding.php
6
614-846-6175 - 800-848-4525
Rear View with Fan Filter Cover Opened
www.tracewell.com/platforms/ietm/ietmlanding.php
7
614-846-6175 - 800-848-4525
Top Views with Network Switch Cover Removed
(F01 version, Cisco 3560)
www.tracewell.com/platforms/ietm/ietmlanding.php
8
614-846-6175 - 800-848-4525
Top View with Network Switch Cover Removed
(F02 version, Juniper SRX 100)
www.tracewell.com/platforms/ietm/ietmlanding.php
9
614-846-6175 - 800-848-4525
Preventive Maintenance
(Caution! Unplug Unit Before Removing Rear Cover)
Schedule
The cabinet is designed for years of reliable operation with minimal upkeep. To maintain
sufficient cooling air flow through the drawers, the air intake filters must be kept clean. The
filter material is reusable, and should be cleaned periodically.
The following are the maximum recommended intervals for typical installations. These
intervals must be shortened in environments with significant airborne dust, pollen, etc.
Filter inspection: Monthly
Filter removal and cleaning: 6 Months
Procedure
Tools: none.
1.
2.
3.
4.
5.
6.
7.
8.
Turn off the cabinet and remove the AC power cord.
Locate the fan cover on the rear panel (page 7).
Loosen two (2) thumbscrews at the top of the fan cover.
Open the fan cover as shown on page 8.
Remove the filter material, rinse out the trapped dirt with warm water.
Dry the material by pressing it between two paper towels.
Allow sufficient time for the filter material to dry completely.
Replace the filter material in the fan cover, close the cover, and tighten the two
thumbscrews.
9. Attach the AC line cord and turn on the cabinet.
Drawer Slides
The drawer slides can collect dirt over time and lose mobility. To correct this, apply a spray
lubricant sparingly as needed.
Slides inspection: 6 months
Lubricant: Liquid Wrench White Lithium Grease, p/n L606, available at Lowes, Home Depot,
etc.
www.tracewell.com/platforms/ietm/ietmlanding.php
10
614-846-6175 - 800-848-4525
Ethernet Switch Specification (F01 version)
Network Ports:
• 8, 10 or 100 Mbps RJ-45 ports
• 1 3G USB port
Performance (64 byte packets):
• Store-and-forward packet switching
• Forward rate 700 Mbps
• MAC addresses unlimited
• Queue buffer 512 MB DRAM
Weight:
• 1.2 kg (2.5 lb)
Dimensions:
• W 216 mm (8.5")
• D 147 mm (5.8")
• H 36 mm (1.4")
AC Power:
• 30 W maximum, 10 W average
• Auto-sensing 100 to 240V, 50/60 Hz
• Localized plug for North America, Japan, UK, Europe, Australia
Standards Compliance:
• IEEE 802.3i 10BASE-T Ethernet
• IEEE 802.3u 100BASE-TX Fast Ethernet
• Compatible with all major network software
Status LEDs:
Unit:
• system, RPS, link status, link, duplex, link speed
• Per network port :10 or 100 Mbps operations, Rx/Tx and collision, link, half/full duplex
Electromagnetic Emissions:
CE mark, commercial
FCC Part 15 Class B
EN 55 022 (CISPR 22), Class B
GOST
CNS13438 Class B
MIC
Environmental Specifications:
Operating temperature:
• 0°C to +40°C
Operating humidity:
• 90% max. relative humidity, non-condensing
Safety Agency Approvals:
• UL listed 60950-1, First Edition
• TUV licensed EN60950-1
www.tracewell.com/platforms/ietm/ietmlanding.php
11
614-846-6175 - 800-848-4525
Parts List
Part Description
Part Number
Caster, 4”, swivel, with lock
015-2063-000-0P
Caster , 4”, fixed with lock
015-2064-000-0P
Line Cord, AC, black, 15 amp.
Switch, 24 Port, 10/100, Cisco 3560
023-9022-000-0P
076-0204-000-0P
Switch, 8 Port, 10/100, Juniper SRX 100
076-0205-000-0P
Fan Assembly
163-0046-000-0C
Fan Filter Material
015-2364-000-0P
www.tracewell.com/platforms/ietm/ietmlanding.php
12
614-846-6175 - 800-848-4525
Dimensions – F01 version
www.tracewell.com/platforms/ietm/ietmlanding.php
13
614-846-6175 - 800-848-4525
Dimensions – F20 version
www.tracewell.com/platforms/ietm/ietmlanding.php
14
614-846-6175 - 800-848-4525
Limited Warranty
The EMMC is warranted for a period of 1 year from the ship date against electrical defects in workmanship
and component failure, and 3 years for mechanical defects in workmanship or component failure. For a list
of Field Replaceable Parts (FRP’s), see page 11.
For replacement parts contact Tracewell Systems Repair Center.
Please have the serial number of the EMMC and the address of where you would like the
replacement parts shipped before you call.
Replacement parts will be shipped from our plant within two working days and failed parts should be
returned to Tracewell Systems Repair Center, 567 Enterprise Dr., Westerville, OH 43081 using the carton
and packing material the replacement parts are shipped in.
An RMA (Return Material Authorization) number will be given to you when you call as well as a specified
shipping method.
( Extended warranties are available, please contact the factory for specifics.)
Service:
For warranty and non-warranty service, contact
Tracewell Systems Repair Center at: 1-614-846-6175
Fax us at 1-614-846-4450, or contact us via the web at www.tracewell.com .
www.tracewell.com/platforms/ietm/ietmlanding.php
15
614-846-6175 - 800-848-4525
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising