Dynex | 70" Monopod - Black | Quick Setup Guide | Dynex 70" Monopod - Black Quick Setup Guide

Dynex 70" Monopod - Black Quick Setup Guide
Important safety instructions
• Make sure that all leg locks are correctly tightened and that
the leg is fully opened before use.
• Do not carry or transport your monopod with camera
equipment attached (for example, over your shoulder or
cradled in your arms).
• Do not expose your monopod to excessive heat or cold, or
use near any flame or fire.
• Do not oil or grease any part of the monopod.
• Do not use any solvents or thinners to clean your monopod.
Use only a mild detergent and wipe dry with a soft, lint-free
cloth.
• Do not exceed the load limit of this monopod.
DX-MNP70BL
70" Lightweight Monopod
Specifications
Folded length: 22.4 in. (57 cm)
Maximum height: 70 in. (177.8 cm)
Minimum height: 22.4 in. (57 cm)
Weight: 0.8 lbs (0.4 kg)
Load capacity: 8.8 lbs (4 kg)
One-year limited warranty
Visit www.dynexproducts.com for details.
Contact Dynex:
For customer service, call 800-305-2204 (U.S. and Canada) or
01-800-926-3020 (Mexico)
www.dynexproducts.com
DYNEX is a registered trademark of BBY Solutions, Inc.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2014 BBY Solutions, Inc. All Rights Reserved.
Before using your new product, please read
these instructions to prevent any damage.
V1 ENGLISH 14-0368
QUICK SETUP GUIDE
Package contents
Using your monopod
• Monopod
• Carrying case
• Quick Setup Guide
1 Adjust the foot on your monopod.
Note: For normal use, rotate the rubber foot to cover the spike. For
rugged outdoor areas, rotate the rubber foot up or remove it to enable
the spike to stick into the ground.
Features
Normal use
Rotate
rubber foot
Spike
2 Flip the leg locks open.
3 Extend the leg sections to the height you want.
Note: Extend the leg sections from the top down (thickest section first)
to give your monopod more stability and support.
4 Close the leg locks.
#
Item
Description
1
1/4" mounting screw
Use this screw to mount your camera onto
the monopod.
2
Camera mounting
plate
Mount your camera to this platform.
3
Wrist strap
Use the strap to carry your monopod.
4
Grip sponge
Grip the monopod comfortably.
5
Leg
Supports your monopod and camera.
6
Quick release leg locks Lift to adjust the leg height, then close to
lock.
7
Rubber foot with
retractable spike
Provides secure and steady footing on a
variety of surfaces.
Caution: Securing a leg lock incorrectly can cause a leg to retract
unexpectedly and could result in damage to the monopod or
equipment mounted on the monopod.
5 Attach your camera to the mounting screw.
Storing your tripod
1
2
3
4
5
Remove your camera.
Flip open the leg locks.
Collapse the legs.
Close the leg locks.
Store the monopod in the carrying case.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising