UHF Wireless Guitar Transmitter and Receiver
With 6.5mm Mono Plug
User Manual
Specifications:
Transmitter:
Frequencies:
Freq stability:
Range:
Receiver:
Sensitivity:
Signal/noise:
Dimensions:
Flyout:
1. Telescopic Antenna
2. 3 x LED Indicators
3. Channel Selector
4. Power Input
5. Audio Output
6. On/Off Switch
7. Transmit Volume
8. Battery Compartment
9. LED Indicator
CH1: 520.5MHz
CH2: 532.9MHz
0.002%
60m max
2µV (12dB)
90dB
115(W) x 80(D) x 25(H) mm
Installation and Operation (Receiver)
For best results, the receiver should be placed at least 1m off the ground, and should not be placed directly in front of the speaker system.
- Position the receiver on a stable platform and attach the AC adaptor.
- Plug one end of the provided lead into the AF output connector of the receiver, and the other end to the input jack of your amplifier or PA system.
- Plug the power adaptor into a suitable electrical wall socket and turn the power on.
- Select the channel you would like to use.
Installation and Operation (Transmitter)
- Open the battery compartment, insert 1 x AAA battery and close the battery cover.
- Plug the transmitter plug into your instrument and turn the power switch on.
- The signal level indicator on the receiver should now light up indicating that the signal is being received. It will only light up for a few seconds.
- Adjust your instrument and amplifier controls to the desired volume and tone.
- Please ensure you select the same channel (CH1 or CH2) as the receiver on the transmitter.
- When finished, turn the power switch off before removing from the instrument.
