EdgeStar AP550Z User's Manual
Add to my manuals5 Pages
EdgeStar AP550Z is a powerful and versatile portable air conditioner that is perfect for cooling small to medium-sized rooms. With its 14,000 BTU cooling capacity, it can quickly and efficiently cool rooms up to 550 square feet. The AP550Z also features a built-in dehumidifier that helps to remove excess moisture from the air, making it a great choice for humid climates.
In addition to its cooling and dehumidifying capabilities, the AP550Z also has a number of other features that make it a great choice for portable air conditioning. These features include:
- Three fan speeds to choose from, so you can customize the airflow to your liking.
advertisement
Troubleshooting and reconnecting wires to the “compressor capacitor” on the
AP550Z
Tools required:
Phillips screwdriver
The problem:
If the AP550Z was recently shipped or roughly moved, it may have one of two problems:
• The fan to the interior of the room turns on, but the air blown out of it is room temperature. Or,
• The unit blows the circuit breaker it is run on
Warnings:
• Make sure the unit is disconnected from the power supply prior to working on it
• Do not attempt this repair if you do not feel comfortable with any procedures
• If you require any assistance, please call EdgeStar Service at 866-319-5473
The repair:
1. Make sure the unit is unplugged
2. Face the rear of the unit
3. Remove the filter frame:
Pull up on the filter frame, then pull down and away from the un it to remove it
4. Once the filter frame has been removed, remove the lower portion of the back of the unit:
Remove these four screws
Once the screws have been removed, this portion comes right off
5. Now remove the left side of the unit (left, assuming you are facing the rear of the unit)
Step A.
Remove these two screws from the rear of the unit
Step B.
Remove these two screws.
Step C.
Pull the panel down and off the unit
6. Locate the “compressor capacitor”. It is a silver cylinder that is about 4” long.
Make sure that the unit is not plugged in prior to touching any wires
Compressor capacitor
7. Look at the wires going into this capacitor- there should be four wires and one bare terminal.
A view of the capacitor from below
A close-up of the capacitor
8. If any wires are not connected, connect them. The three blue wires all connect to one terminal, and the one red wire connects to a terminal all by itself.
This image shows the capacitor removed (not a required step) in order to show greater detail
Blue wires all connect here
Red wire connects here
Bare terminal
9. Finally, put the unit back together by reversing the above instructions.
10. Once the unit is completely reassembled, plug it in. Select the cool mode, and lower the thermostat settings all the way. The compressor should kick on after no more than 3 minutes. If so, congratulations on the repair! If not, call EdgeStar service at 866-319-5473 for further assistance.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project