ML620 Ethernet Access Device

The ML620 Ethernet Access Devices (EADs) from

Actelis® enable delivery of high-speed carrier Ethernet services over the existing copper and fiber infrastructure. The ML620s are intelligent, compact EADs that deliver up to 100 Mbps of symmetrical Ethernet traffic with fiber quality over existing copper pairs.

Available in either 2, 4 or 8 copper pairs with optional SFP fiber configurations*, the ML622/ML624/ML628 EADs can be deployed in a Point-to-Point configuration, optional copper Add-Drop chain, or as the CPE in a Point-to-Multi-Point configuration with Actelis’ EFM switches. With its superior performance, extensive functionality and low cost, the ML620 EAD platforms offer rapid service delivery and allow for complete utilization of the existing network infrastructure.

The ML620 EAD platforms are interoperable with any standard

Ethernet switch, router or hub. Compliant with Metro Ethernet Forum

(MEF) specifications, ML620 EAD systems seamlessly integrate into carrier Ethernet networks. Equipped with four 10/100Base-T

Ethernet interfaces and an optional 100Base-FX Small Form Factor

(SFP) port, the ML620 EAD platforms allow assignment of a service or a customer per port. A DS3/E3 uplink can be used to connect to legacy networks instead of the 100Base-FX SFP.

The ML620 EAD models let service providers create an intelligent

Ethernet access edge with bandwidth limiting per ingress port and traffic shaping on the Ethernet Access uplink (HSL). The ML620 is fully compliant with the MEF 9 and 14 specifications.

Powered by Actelis Networks’ award-winning EFMplus™ technology, the rate, reach and reliability are increased significantly using advanced Dynamic Spectrum Management (DSM) and Dynamic Rate

Boost (DRB) techniques. This technology doubles the rate/reach in real-world field deployments. Combined with Actelis industry-leading

XR239 EFM Repeaters, the reach can be extended even further.

All ML620 EAD models provide 802.1q VLAN-aware wirespeed bridging, double tagging (VLAN stacking) for end-user

VLAN transparency, L2 (Ethernet priority) and L3 (ToS/Diff-Serv) classification with four traffic classes, RSTP/STP, bandwidth monitoring, and Multicast/Broadcast limiting.

The ML620 EADs provide proactive and dynamic tools for enhanced trouble shooting and monitoring capabilities. Advanced Carrier-class

EFM OAM, including 802.3ah, CFM (802.1ag) and Y.1731 (ITU), are incorporated, offering both physical link as well as service level endto-end advanced troubleshooting mechanisms.

The ML620 EAD platforms can be managed In- and Out-of-Band by the MetaASSIST™ View graphical craft application and via the multi-platform Element Management System, MetaASSIST EMS. The management protocols include standard command line interface and

SNMP using standard MIBs for seamless integration with third-party

Network Management Systems (NMS).

Highlights

• IEEE 802.3ah Ethernet in the First Mile (EFM) 2Base-TL Solution

• CE 1.0 - MEF 9, 14

• Rapid Service Deployment

• Superior Rate, Reach & Reliability

• Low Delay and Jitter for Voice and Video Transmission

• Worldwide Spectral Compliancy

• OSMINE, NEBS III, FCC, UL, CE

• Environmentally Hardened

Applications

• IP-based Traffic Controllers

• Dynamic Message Signs

• HD Video Cameras & Streaming

• Vehicle Detection

• Smart Parking

• Emergency Response

• Supports & Complements City Wi-Fi Access

Specifications

Interfaces

Ethernet (Network/User)

• 10/100Base-T: 4 ports, Connector: RJ45, Auto-

MDIX

• 100Base-FX Connector*: 1 port (option) SFP

Based, MSA compliant

High Speed Link (Bonded Copper Pairs)

• Protocol: IEEE 802.3ah 2Base-TL

• Line code: ITU-T G.991.2 rev. 2

• Bandwidth: Up to 100 Mbps (symmetrical)

• Number of Copper Pairs: 2-8, Connector: RJ45

(per modem/pair)

• End-to-end Delay: 2-4 ms (typical)

• Spectral Compliance: ITU-T G.991.2 (Annex A,

B, F, G), ETSI TS 101 524 (Annex E), ANSI T1.417,

T1.426, Per-country regulatory, compliant spectral modes

• Spectral Friendliness: Dynamic Spectral Shaping

(DSS)

• Cross-talk Cancellation: Dynamic Rate Boost

(DRB)

• Sealing Current: 48VDC/1.5mA nominal

Environmental Parameters

Management (Out-of-Band)

• 10/100Base-T Connector: RJ45, Auto-MDIX

• Craft: EIA RS-232 (DCE),Connector: DB9

LAN Protocols

• Dynamic Bridging: IEEE 802.1, 8K MAC addresses

• Discovery Mechanisms: LLDP

• VLAN Tagging: IEEE 802.1Q

• Double Tagging: Q-in-Q

• RSTP, STP: IEEE 802.1d

• Link Aggregation: IEEE 802.3ad

• Provider Bridges: IEEE 802.1ad

• OAM: IEEE 802.3ah clause 57 (EFM OAM),

IEEE 802.1ag, ITU Y.1731,

Ethernet loopback with MAC swap

Advanced Service Provisioning and Traffic

Management

Quality of Service

• Classes of Service: 4

• Scheduler: WFQ, SP

• Classification: L2 802.1p/Q priorities, L3 ToS/

DiffServ

Management

Protocols

• SNMP: SNMP V3, V2C, V1

• IP addresses: IPV4 and IPV6

• Command Line Interface : TL1, Industry

Standard CLI

• Remote Access : Telnet

• Secure Access (option): SSH v2

• Time Synchronization : SNTP v3

• Web Access : HTTP

• File transfer : FTP, TFTP

• IEEE 802.3ah EFM OAM: Dying Gasp

• User Authentication: RADIUS and/or local passwords

Applications

• EMS: MetaASSIST EMS

• Craft GUI: MetaASSIST View

Front Panel Indicators (LEDs)

• Power

• Status

• Alarm

• MLP per modem/pair

• ACT (Activity)

• LNK (Link) per Ethernet/HSL port

Alarm Contacts

• Terminal Block: 2 Input, 1 Output Physical

Physical

• Dimensions: Height: 1.6” / 40mm (1U), Depth:

11.0” / 280mm, Width: 8.4” / 213mm

• Weight: 3.75 lbs / 1.7 Kg

• Mounting Rack: 2 units in 19”, 23” or ETSI racks

Desktop, Wall Mount

• Power DC: -48/-60 VDC nominal, 13.5-17 Watt (per model) AC: 90-264 VAC, 47-63 Hz, 17-21 Watt (per model)

Environmental

• Operating Temp. -40° to +74°C

• Storage Temp. -40° to +74°C

• Relative humidity: Up to 95%, non-cond.

Regulatory Approval/Certifications

Metro Ethernet Forum

• CE1.0 - MEF 9, 14

Safety

• UL 60950, CSA C22.2 60950

• EN 60950, IEC 60950

EMC

• FCC Part 15 Class B

• ICES-003 Class B

• ETSI EN 300 386 Class B

• ETSI ETS 300 132-2

• ITU-T K.20, K.21

NEBS

• Level III (GR-1089-CORE, GR-63-CORE)

CE

• EMC and Safety

Environmental

• GR-63-CORE

• ETSI ETS 300 019

Corporate Headquarters

Actelis Networks, Inc.

47800 Westinghouse Drive

Fremont, CA 94539 t. +1 510-545-1045 or toll-free in U.S. 1-866-ACTELIS

Company and General Information: [email protected]

Asia Pacific Sales: [email protected]

Central and Latin America Sales: [email protected]

Europe, Middle East and Africa Sales: [email protected]

North America Sales: [email protected]

Actelis Networks® is the leading global supplier of IP-based, Ethernet over Copper broadband solutions, which enable cities, counties and other local government agencies to quickly and cost effectively upgrade to a more efficient and flexible next-generation ITS network. All content included in this document is the exclusive property of Actelis Networks, Inc., and protected by U.S. and international copyright laws. Specifications are subject to change without notice. Actelis® and Actelis Networks® are registered trademarks. EFMplus™ and MetaASSIST™ are trademarks of Actelis. Any other trademarks used herein are the property of their respective owners. Copyright ©2013. All Rights Reserved. Learn more at www.Actelis.com.

03.14.13