- Computers & electronics
- TVs & monitors
- Flat panel wall mounts
- Epson
- 96in. Whiteboard for Projection and Dry-erase
- Operating instructions
Epson 90" Whiteboard for Projection and Dry-erase Assembly Instruction
Add to my manuals2 Pages
Meet your new Epson 90" Whiteboard for Projection and Dry-erase! Harness stunning projection capabilities with smooth dry-erase writing on this expansive 90-inch surface. Project and annotate simultaneously, enhancing your presentations and brainstorming sessions. Unleash creativity with the included pen tray and utilize the user-friendly wall-mount system for seamless installation. Experience a dynamic, interactive workspace, transforming your ideas into reality.
advertisement
of mounti
T O P M O U N T M A R K E R B O A R D S
1 Adjust bracket to match screen thickness and join with appropriate dovetail slot, as shown in picture A .
2 When the bracket is assembled, attach the Locking Clip
(thinner of the two pieces provided), as in picture B .
3 Slide edge of Bracket under frame on the back of the board, as shown in picture C , and lock by twisting towards corner, as shown in picture D .
4 Hook the inside edge of the Pen Tray to the inside edge of the frame on the back of the board, as shown in picture E .
Rotate the Pen Tray forward so that it clips to the bottom of the frame. You will feel it snap into place.
A
SPACER
B
LOCKING
CLIP
W A L L M O U N T M A R K E R B O A R D S
1 Remove bracket taped to back of EganBoard, and line up with center of mounting area as shown in picture A .
2 Fasten Bracket to wall using two suitable fasteners as shown in picture B .
3 Hang EganBoard over the bracket, picture
C with its corresponding angle, picture D .
4 Double-sided tape on the back in bottom corners ensures complete stability.
5 Hook the inside edge of the Pen Tray to the inside edge of the frame on the back of the board, as shown in picture E .
Rotate the Pen Tray forward so that it clips to the bottom of the frame. You will feel it snap into place.
A
B
BRACKET
C
PEN
TRAY
C BACK
E
BACK
FRONT
D
PEN
TRAY
E
FRONT
D
S Y S T E M E G A N B O A R D S
1 All EganBoards come with four hooks which you attach to the back of the frame, near each corner with the screws provided, picture A .
2 To ease installation position hooks so they align with the hole pattern on the slotted track.
3 To insure hooks are completely seated you can extend the hooks as shown in picture B .
Warning: Hooks must be completely seated for safe installation.
4 Hook the inside edge of the Pen Tray to the inside edge of the frame on the back of the board, as shown in picture C .
Rotate the Pen Tray forward so that it clips to the bottom of the frame. You will feel it snap into place.
A
PEN
TRAY
C
BACK
FRONT
B
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project