58 to 572°F Range • Dishwasher Safe to 190°F
• -58 to 572°F Range
• Dishwasher Safe to 190°F
• IP65 Water Resistant
• On/Off Switch
Measuring Range
Accuracy Display Resolution
Response Time
Display Size
Water Resistance
Digit Size
Probe Size
Minimum Immersion
Product Size
Operating Range
• Max/Min Memory
• °C/°F Switchable
• Includes Pocket Clip
-58 to 572˚F (-50 to 300˚C)
±1.8˚F (±1˚C) between -3.8 to 247.8˚F (-19.9 to 119.9˚C)
±3.6˚F (±2˚C) between -58 to -4˚F (-50 to -20˚C) and
248 to 572˚F (120 to 300˚C)
Approximately 15 seconds from ambient to 200 or 32˚F
0.35 H x 0.71 W inches (18 W x 9 H mm)
0.28 H x 0.14 W inches (3.5 W x 7 H mm)
0.28 dia. x 4.8 L inches (3.5 dia. x 122 L mm)
Approx. 0.25 inch (6.4 mm)
1.5 volt, type A76 (LR44) or equivalent x 1 piece (included);
2,000 hours continuous operation
7.9 H x 0.9 W x 0.8 D inches
(203 H x 24 W x 20 D mm)
32 to 190˚F (0 to 88˚C)
Instrument Operation
Press the ON/OFF button to activate the thermometer. The unit will remain in the ON
position until switched off by the user. Insert the stainless steel probe about 1 inch
(25 mm) into the object to be measured. The measured temperature will be shown
on the LCD display.
To Select ˚F or ˚C
Press the ˚C/˚F button on the back of the thermometer to select the desired
temperature unit.
Press the MIN-MAX memory button to read the last highest / maximum temperature
Press once more to read the last lowest / minimum temperature measured.
Press once more to return to normal display.
Press and hold the button for about 3 seconds then release to reset the memory.
MIN and MAX are reset when the unit is powered off.
Battery Installation
Replace the battery if the LCD display becomes dim.
Replace with 1.5 volt, type A76 or equivalent.
Use a screwdriver of suitable size to open the battery cover on the back.
Install the battery observing the correct polarity.
Close the battery cover.
Care and Cleaning
Clean the probe immediately after each measurement to avoid cross contamination.
If there is erratic operation, press the RESET button on the back of the thermometer.
Do not expose the entire thermometer to temperatures over 190˚F (88˚C).
Do not leave inside ovens. Not submersible.
Technical Support
For warranty, service, and technical assistance, please contact ThermoWorks’
Technical Services at (801) 756-7705 or email at [email protected]
For additional cooking tips and doneness temperatures, and to see the full line of
ThermoWorks tools, visit our website at www.thermoworks.com.
ThermoWorks, Inc.
Utah, U.S.A.
Ph: 801-756-7705
Fax: 801-756-8948
Follow us on:
RT600B Waterproof
Digital Thermometer
Made in China
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF