Extron electronic Extron Electronics Stud Sensor RFF 052 Installation guide

RFF 052 and RFF 054 False Plates for 1-inch Products Installation Guide

The Extron

®

False Plates for 1-inch Products increase the face height of 1-inch tall, quarter rack width (RFF 054) or half rack width (RFF 052) products to full single rack unit height (1U), aiding airflow management and aesthetics. Install plates as follows:

1. Clean the 1-inch tall Extron device to be rack mounted of any dust or debris.

2. Remove the protective film from the adhesive tape on the RFF 052 or RFF 054.

3. Align the plate on the top of the device so that the adhesive faces the device and the raised side runs flush with the front panel of the device.

4. Firmly press the plate onto the device.

5. Install the 1-inch tall device to the rack shelf.

2 3 4 5

Extron USA - West -

Headquarters

+800.633.9876

Inside USA/Canada Only

+1.714.491.1500

+1.714.491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA/Canada Only

+1.919.863.1794

+1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

© 2011 Extron

®

Electronics. All rights reserved. www.extron.com

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

68-2160-01

Rev. A

07 11