Fisher-Price | H5341 | Instruction Sheet | Fisher-Price H5341 Instruction Sheet

Fisher-Price H5341 Instruction Sheet
H5341
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AAA” (LR03) alkaline
batteries (not included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
1
One-Time Assembly
Upper Skull
CAUTION
This toy contains small parts in
its unassembled state.
Adult assembly is required.
Lower Skull
Frame
#4 x 3/8" Screw - 8
Shown Actual Size
• Fit the pegs in the upper and lower skull into the holes
in the frame.
• Insert eight #4 x 3/8" screws into the back of the frame
and tighten. Do not over-tighten.
2
Battery Installation
Battery Safety Information
In exceptional circumstances, batteries may leak fluids
that can cause a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
1.5V x 3
“AAA” (LR03)
BOTTOM VIEW
• Locate the battery compartment on the skull assembly.
• Loosen the screw in the battery compartment door
with a Phillips screwdriver. Remove the battery
compartment door.
• Insert three, "AAA" (LR03) alkaline batteries,
as indicated inside the battery compartment.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
• If this product begins to operate erratically, you will
need to reset the electronics. Slide the power switch
off and then back on.
• When sounds or lights from this toy become faint or
stop, it’s time for an adult to change the batteries!
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities (Europe only).
3
1
2
7
8
4
Let’s Build It!
3
4
9
10
5
5
6
11
12
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA
6
H5341b-0920
13
14
17
18
7
Let’s Build It!
15
16
19
20
8
• Slide the power switch inside the
skull ON .
• When you are finished playing with
this toy, slide the power switch OFF
21
9
.
Make T-Rex Come to Life!
WARNING
CHOKING HAZARD – Small Parts.
Not suitable for children under 3 years.
• Press a button on top of the skull to make the eyes light up
and “swallow” intruders.
• Press the other button for chomping sound effects and
glowing eyes.
• Press the claw print target to activate the claw trap.
• Place boulders into the chutes and watch them tumble out at
the bottom.
• Press the button to topple the prehistoric plant.
IMPORTANT: Only use projectiles supplied with this toy.
Do not launch at people or animals or at point blank range.
10
Consumer Information
FCC Statement (United States only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly approved
by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Care
• Wipe this toy with a clean cloth dampened with a mild
soap and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not
take this toy apart.
ICES-003
• This Class B digital apparatus complies with Canadian
ICES-003.
• Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée seulement aux
conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
11
Consumer Information
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising