Fisher-Price Imaginext System T-Rex Mountain, Imaginext H5341, H5341 User manual

Fisher-Price Imaginext System T-Rex Mountain, Imaginext H5341, H5341 User manual
Welcome to the Imaginext™ System
Younger children
& those new to
the Imaginext™
Use our step-by-step
instructions to build
the structure shown
on the cover of this
booklet. Encourage
your child to assist
you with some of the
simple steps. This
assembly is ideal for
active play and it can
be used as a playset
rather than a
building toy.
Older children and experienced Imaginext™ System users
The more your child plays with this toy, and development and skill increases, the less
assistance your child needs! Experienced Imaginext™ users will enjoy using all parts of
this toy to build their own structures or try building an alternate assembly shown below.
The colors and decorations of the product may sometimes vary from these instructions.
One-Time Assembly
This toy contains small parts in its unassembled state.
Adult assembly is required.
• Fit the pegs in the upper skull into
the matching holes in the frame.
• Insert four, screws into the back of
the frame and tighten them to
secure the upper skull. Do not
• Repeat this procedure to attach the
lower skull.
#4 x 3/8" Screw - 8
Shown Actual Size
Upper Skull
Lower Skull
Battery Installation
• Locate the battery compartment on
the upper skull.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Insert three, "AAA" (LR03) alkaline
batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• When sounds or lights from this toy
become faint or stop, it’s time for an
adult to change the batteries!
1.5V x 3
“AAA” (LR03)
Shown Actual Size
Battery Safety Information
Batteries may leak fluids that can cause
a chemical burn injury or ruin your toy.
To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of
batteries safely. Do not dispose of
batteries in a fire. The batteries may
explode or leak.
• Never short circuit the battery
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
• Remove rechargeable batteries from
the toy before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Let’s Build It!
Let’s Build It!
Let’s Build It!
Let’s Build It!
Let’s Build It!
Let’s Build It!
• Locate the On/Off switch on the underside of the
upper skull.
• Slide the switch to the position to turn the toy on
and to the position to turn it off.
Hint: If your child is not actively playing with this toy,
it turns off automatically (sleep mode).
• When your child is finished playing with this toy,
slide the on/off switch to the off position.
The Predators vs. the Ecovores!
• Press claw print target to activate the claw trap.
• Press one button on top of the skull to make
the eyes light up and “swallow” intruders.
• Press the other button for chomping sound
effects and glowing eyes.
• Press the button to topple the
prehistoric plant.
IMPORTANT: Only use projectiles supplied
with this toy. Do not launch at people or
animals or at point blank range.
• Place boulders into the chutes and watch
them tumble out at the bottom.
• Wipe this toy with a clean cloth dampened with a mild soap and water solution.
Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this toy apart.
Warning – Choking Hazard. Not recommended for children under 3 years
because it contains small parts that can be swallowed.
Please keep this instruction sheet for future reference, as it contains important information.
Requires three “AAA” (LR03) alkaline batteries (not included).
For children 4-10 years. Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance
could void the user's authority to operate the equipment.
Questions? We'd like to hear from you!
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437, 8 AM - 6 PM EST
Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470. Or, Visit us on-line at
Write to us at:
Fisher-Price® Consumer Relations, 636 Girard Avenue, East Aurora, New York 14052, U.S.A.
For other countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2;
GREAT BRITAIN: Mattel UK Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302.
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312. NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2005 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF