MARINE ACTIVE SUBWOOFER

MS-AB108

SPECIFICATIONS

MAX POWER RATING 210 Watts

FREQUENCY RESPONSE 30Hz – 250Hz

LOW PASS FILTER (VARIABLE) 30Hz – 250Hz

TUNING

WOOFER SIZE

FUSE

DIMENSIONS

Bass Reflex

8” down firing

10 Amp

Length 515mm - 20 1/4”

Width 233mm - 9 3/16”

Height 190mm - 7 1/2”

PRODUCT CONTENTS

1x MS-AB108 Active subwoofer

1x Power / GND/ Remote-ON wire loom

1x RCA Cable

Mounting Hardware

Manual

Warranty Card

CONTROL DESCRIPTIONS

LEVEL

This allows the adjustment of the amplifier input level. Turn clockwise to increase the level. If the sound becomes distorted reduce the level.

LOW PASS FILTER (LPF)

This allows the adjustment of the highest frequency the Marine Active

Enclosure will produce.

This should be adjusted to blend with your main speakers. Typically, this will be set to around 100Hz (approximately the central position of the control knob).

»

»

»

»

»

INSTALLATION

Make sure the Marine Active Enclosure is firmly secured.

Check before drilling or cutting holes.

DO NOT work near gas tanks, fuel lines, hydraulic lines or electrical wiring.

DO NOT mount the Marine Active Enclosure in such a way as to pinch or damage the wires.

Make sure everything is firmly connected, before attaching the +12V wire. Make sure the +12V wire is fused as close as possible to the battery. ALWAYS use a fuse with the recommended rating.

(Wiring diagram on reverse)

RECORD YOUR PURCHASE DETAILS HERE:

MODEL NUMBER

DATE OF PURCHASE

AFFIX RECEIPT HERE

WARNING! Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss! www.fusionelectronics.com

PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.

YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.

v 1.0

WIRING

»

»

»

Be sure to use the supplied power extension cable.

» Connect the ground wire (Black wire) to the negative of the vessel

»

(Ground) Note: clean dirt, corrosion and paint to bare metal.

Connect the 12 volt (red wire) to the positive battery terminal of the

» vessel; Make sure the fuse is close to the battery.

Connect the remote on (blue wire) to the remote turn on lead of the

Headunit. - If your head unit does not have a remote turn-on lead, connect a switched 12v power lead to the unit.

Connect the RCA cables to source

Check all connections.

Finally, connect the power plug end of the power harness to the unit.

RCA cable

Connect to subwoofer pre-out on source.

LOW INPUT LEVEL

LEFT

L.P.F

RIGHT MIN MAX 30Hz 250Hz

POWER

REM

+12 GND

FUSE

MS-AB108

Connect red wire to positive

(+12V) battery terminal

Connect blue wire to source unit’s accessory lead or switched 12 volt source

(Remote)

Power Plug

Fuse

+12 Vessel Battery

Connect black wire to negative of vessel

(Ground)

www.fusionelectronics.com

PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.

YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.

v 1.0