GE Profile DCCH485EK Installation instructions


Add to my manuals

advertisement

GE Profile DCCH485EK Installation instructions | Manualzz

DCCH480EK/485EK

GE ® 4.0 Cu. Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer

Dimensions and Installation Information (in inches)

Electric Dryer Rating

240V 3000W, 12.5A, 60Hz

Crisdklmn Dwklsmnaitw klaadxz

SENSOR DRY

W RINKLE F REE

A

CTIVE

W

EAR

D ELICATES

S PEED D RY

TIME DRY

W ARM U P

D EWRINKLE

T

IMED

D

RY

C OTTONS

A

IR

F

LUFF

80

60

50

40

30

20

T IME

A

E

M

L

B

H

L

E

M

D

D

L

D

D

T EMP S ENSOR

D S

E

D A

T

S

Circuit Requirements: An individual, properly grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required.

Note: Dryer wall outlet must be located within 36” of service cord entry and accessible when dryer is mounted in position.

Installation Information: For complete information, see installation instructions packed with your dryer.

23 1/2" 20 11/16"

25 11/16"

33 4/11"

For answers to your Monogram, ® GE Profile ™ or

GE ® appliance questions, visit our website at ge.com or call GE Answer Center ® service,

800.626.2000.

Specification Revised 10/10

Listed by

Underwriters

Laboratories

360480

DCCH480EK/485EK

GE ® 4.0 Cu. Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer

Special Installation Requirements:

Alcove or Closet Installation:

• Stacking Kit - GE24STACK (not included)

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".

• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

• The installation must conform with the local codes, or in the absence of local codes, with the National Electric Code and National Fuel Gas Code,

ANSI Z223 for gas dryers.

Minimum Clearance other than Alcove or Closet Installations:

• Minimum clearances to combustible surfaces 0" both sides, 3" rear.

For more information on venting kits and accessories, please call 1-800-GE-CARES.

Stacked Dimensions (in inches)

67 5/8”

23 3/4”

23 1/2”

S D

T D

26 5/8”

25 1/3”

23 4/11”

For answers to your Monogram, ® GE Profile ™ or

GE ® appliance questions, visit our website at ge.com or call GE Answer Center ® service,

800.626.2000.

Specification Revised 10/10

Listed by

Underwriters

Laboratories

360480

DCCH480EK/485EK

GE ® 4.0 Cu. Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer

Draining water out of the dryer

• Two options are available to drain the water out.

- Pump to a removeable water tank in the dryer.

- Drain directly out of unit into a standpipe or washstand through the included drain hose.

• The dryer drain hose and wire ties are included.

• You must have a standpipe available to drain into.

• Your standpipe or washstand cannot exceed a height of 35-1/2" above the ground.

• The dryer drain hose can drain alongside the washer hose.

• For complete information, see the installation instructions packed with your dryer.

lllll llllllllll lllll llllllllll

Specification Revised 10/10 360480

DCCH480EK/485EK

GE ® 4.0 Cu. Ft. Stainless Steel Capacity 24" Ventless Condenser Frontload Electric Dryer

Features and Benefits

• 4.0 Cu. Ft. Large Stainless Steel Basket - Handles a king-size comforter or 24 full-size bath towels with ease

• 5 Heat Selections - Offer enhanced drying performance and fabric care

• Sensor Dry ™ - Continually monitors moisture content to help prevent clothing wear and tear

• Stainless Steel Drum Interior - Smooth stainless interior helps prevent rust and protect clothes

• Multiple Dry Cycles - Deliver optimal drying results

• Delay Start - Lets you do the laundry on your terms

• Antibacterial Option - Certified by the NSF ® to reduce up to 99.9% of certain types of bacteria

• Extended Tumble Plus - Tumble clothes without heat to help prevent creasing and wrinkling

• Speed Dry - Delivers ready-to-go results in minutes

• ADA Compliant

• Model DCCH480EKWW – White on white

• Model DCCH485EKMS – Metallic silver

Crisdklmn Dwklsmnaitw klaadxz

S ENSOR D RY

WRINKLE FREE

ACTIVE WEAR

DELICATES

MIXED LOAD

COTTONS

DRYING DAMP COOLDOWN

SPEED DRY

T IME D RY

WARM UP

DEWRINKLE

TIMED DRY

DELAY CLEAN LINT FILTER

ESTIMATED TIME REMAINING

AIR FLUFF

NO HEAT

80

60

40

30

20

10

TIME

ANTI-BACTERIAL

HIGH

EXTRA DRY

MORE DRY

MEDIUM

LOW

EXTRA LOW

DRY

LESS DRY

DAMP

TEMP SENSOR

DELAY START

EXTEND TUMBLE

DAMP ALERT

SIGNAL

HOLD 3 SECS TO

CONTROL PANEL

DCCH480EK_485EK

Specification Revised 10/10 360480

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement