WinSystems PPM-GIGE PC/104-Plus Dual Gigabit Ethernet module Datasheet
WinSystems PPM-GIGE, your newly acquired PC/104-Plus compliant Gigabit Power over Ethernet (POE) module, offers high-speed data transfer capabilities. Connect to networks ranging from 10 to 1000 Mbps using standard CAT 5 twisted pair copper cables. It supports Windows, Linux, and other x86-compatible operating systems, making it versatile for various applications. The onboard RJ-45 connector simplifies Ethernet connection, while LEDs provide clear status indication. Experience reliable data transmission with features like Auto-Negotiation, flow control support, and adaptive equalization.
Advertisement
Advertisement
PPM-GIGE-1-POE
PC/104-Plus Gigabit Controller with Power over Ethernet
Features
• IEEE 802.3 support for 1000BASE-T, 100BASE-TX, and
• Automatic switching from 1 Gbps to 100 or 10 Mbps
and full- and half-duplex operation
• Realtek RTL8110 Gigabit Ethernet PCI controller
• Auto-Negotiation with Next Page capability
• IEEE 802.3x-compliant full duplex fl ow control support
• Adaptive equalization supported
• 64Kbyte Rx and 8K Tx packet FIFO
• PHY supports 2-pair and 3-pair cable downshift
• IEEE 802.3at/af POE compliant
• Up to 40W for single port PSE applications
• RJ-45 Ethernet interface connector on board
• Support for Windows®, Linux, and other x86 RTOS
• LEDs provide status indication
• Small size, 3.6 x 3.8 inches (90 x 96mm)
• Single +5V supply
• Operates from -40°C to +85°C
PPM-GIGE-1-POE Block Diagram
Product Description
The PPM-GIGE-1-POE is a high-performance, PC/104-Plus compliant Gigabit Power over Ethernet (POE) module. This add-in module allows connection to 10, 100, and 1000
Mbps networks using standard CAT 5 twisted pair copper cables. It is based upon the popular Realtek RTL8110 controller that is supported by a wide range of operating systems including Windows, Linux, and other x86-compatible operating systems.
The Realtek RTL8110 Gigabit Ethernet controller combines a triple-speed IEEE 802.3 compliant Media Access Controller (MAC) with a triple-speed Ethernet transceiver, 32-bit
PCI bus controller, and embedded memory. With stateof-the-art DSP technology and mixed-mode signal technology, it off ers high-speed transmission over CAT 5
UTP or CAT 3 UTP (10 Mbps only) cable. Functions such as
Crossover Detection & Auto-Correction, polarity correction, adaptive equalization, cross-talk cancellation, echo cancellation, timing recovery, and error correction are implemented to provide robust transmission and reception capability at high speeds.
The device supports the 32-bit PCI v2.2 interface for host communications and is compliant with the IEEE 802.3 specifi cation for 10/100 Mbps Ethernet and the IEEE
802.3ab specifi cation for 1000 Mbps Ethernet.
WinSystems | 715 Stadium Drive, Arlington, TX 76011 USA | Tel 817-274-7553 | [email protected] | www.WinSystems.com
PPM-GIGE-1-POE - PC/104-Plus Gigabit with Power over Ethernet
Integrated PHY - The PHY supports 10/100/1000 Mbps full- and half-duplex operation. IEEE 802.3ab Autonegotiation support provides automatic link confi guration of speed, duplex, and fl ow control.
Ethernet Connection - The PPM-GIGE-1-POE is hooked to the network through an onboard RJ-45 connector.
Power over Ethernet (POE) - This board supports powersourcing equipment (PSE) for POE applications. An external power supply unit supplies -48 volts which is injected at the magnetics and can supply up to 40W of power. An onboard controller provides input under voltage lockout, input overvoltage lockout, over temperature detection, output voltage slew-rate limit during startup and LED status indication on each port. This protection operates automatically with out the need of any software programming.
Monitor LEDs - Light emitting diodes (LEDs) provide a visual indication of the link status, network activity, network speed, and PSE status.
Software - Most PCI-compatible drivers, utilities and
10/100/1000 Ethernet supported operating systems based on the RTL8110 will work directly with this module.
Power Supplies - There are three independent power supplies on this module for use by the RTL8110 controller.
They are 3.3V, 1.8V, and 1.2V. The PPM-GIGE-1-POE requires only a single +5 volt input. The +5V input power and ground for the board is supplied from both the PC/104 and
PC/104-Plus connectors.
PC/104-Plus Interface - The PPM-GIGE-1-POE module is designed to off er fl exible, high-performance Ethernet networking capability. It provides 32-bits of addressing and data, as well as the complete control interface to operate on the PC/104-Plus Bus. The chip has a PCI Bus master interface and is compliant with the PCI Bus Specifi cation
Revision 2.2.
The PPM-GIGE-1-POE is designed to support 3.3V PC/104-
Plus signaling. There is a jumper block on board to select the module slot position and system resources. Also, there is a PC/104 connector on the board. It feeds the signals through the connector to the next module in a stack.
Other Confi gurations - WinSystems also off ers a dual channel Power over Ethernet version of this board called the PPM-GIGE-2-POE. Visit our website for the detailed specifi cations.
Front and Back Picture of PPM-GIGE-1-POE
Electrical
Data rate
Technical Specifi cations
10/100/1000 megabits per second
Power Requirements
Vcc = +5V ±5% @ 250 mA typical
Connectors
Ethernet
PC/104-Plus
PC/104
RJ-45
120-pin (4 x 30; 2mm) stackthrough
16-bit stackthrough (feed through only)
Environmental
Operational from -40°C to +85°C
Non-condensing relative humidity 5% to 95%
RoHS compliant Yes
Mechanical
Dimensions
Weight
3.6 x 3.8 inches (90 x 96mm)
2.9 oz. (83 gm)
Ordering Information
PPM-GIGE-1-POE PC/104-Plus Gigabit Ethernet module
WinSystems reserves the right to make changes to products and/or documentation without further notifi cation.
Product names of other companies may be trademarks of their respective companies.
WinSystems | 715 Stadium Drive, Arlington, TX 76011 USA | Tel 817-274-7553 | [email protected] | www.WinSystems.com

Public link updated
The public link to your chat has been updated.
Advertisement