advertisement
▼
Scroll to page 2
Before using this system, please be sure to read, understand, and follow the instruction of this manual. 0000... hao audio” SV iMini www.h2oaudio.com Copyright Notice: This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H20 Audio is a registrated trademark of Diver Entertainment Systems Inc. iPod and iPod Mini are registrated trademarks of Apple Computers Inc. Patents 6396769. 6614722. Others Pending. 1 General Storage Procedures For long-term storage, remove T-Seal and store out of direct sunlight. If the T-Seal will not be used for a long period of time, remove it from the housing and store in a plastic bag out of direct sunlight. If the T-Seal is stored in a dry environment for a long period of time, it will develop cracks and become unusable. CAUTION: The life of a T-Seal is typically one (1) year. Contact H20 Audio for spare T-Seals or a maintenance kit. Always remember to reinstall the T-Seal before next use. Do not expose the housing to extreme heat, such as the inside of a hot car, or in hot direct sunlight, such as a beach, or boat deck. Doing so may cause damage and subsequent flooding, CAUTION: Do not store housing in following environments: * Solvents or other chemical fumes * High humidity * High Ozone * Extreme temperature fluctuations Storage in such conditions may lead to housing damage and leakage. Rinse the EXTERIOR of the system in fresh water after EACH use: 1. Make sure the housing is sealed and closed 2. Soak in clean fresh water for 30 minutes. 3. Rinse the entire system with freshwater 4. Then completely dry the entire exterior of the system using a clean soft cloth. 5. Dry face down so water can properly drain from the Scroll Wheel. Strong detergents, soaps, and chemicals MUST NEVER be used to clean the system. If you must use soap, it should be a very diluted. Introduction The H20 Audio SV iMini system enables you to listen to digital audio while active in watersports to a depth of 10 feet (3m). It houses the Apple iPod Mini . HOUSING: The housing features a simple and secure locking mechanism to keep the unit waterproof during operation. The H20 Audio SV housing allows for functional control of the player while submerged in an aqueous environment. NOTE: The iPod Mini is NOT waterproof without the H20 Audio and NOT covered under this product warranty. SPEAKERS: The speaker set is specially designed with clips for attachment around the ears and neck. The cable is removable for users who wish to be able to use other standard headphones with 3.5mm male connectors. NOTE: Using this system with any other headphone will not be waterproof. Leak Test Before utilizing the system for the first time, it is highly recommended to perform a 'Leak Test'. Follow the instructions below. DO NOT INSTALL THE MP3 PLAYER INSIDE THE HOUSING FOR THE LEAK TEST 1. Visually inspect the main housing seal by opening the unit. Verify the seal is seated as intended and the T-Seal is clean of any artifacts, then close and lock the housing using the latch. 2. Immerse the housing, without the MP3 player, in water. 3. Manipulate the controls at various depths. 4. Remove from the water, dry the exterior, and visual inspect inside the housing for any sign of leaks. 5. Only after a successful Leak Test, install the MP3 player in the housing, General Use Notice READ THIS MANUAL CAREFULLY. IF YOU HAVE ANY QUESTIONS PLEASE CONTACT H20 AUDIO CUSTOMER SUPPORT PRIOR TO USE. IMPROPER USE OF THIS SYSTEM MAY CAUSE THE USER TO MAKE MISTAKES OR DECISIONS THAT MAY LEAD TO SERIOUS INJURY OR DEATH. IMPORTANT WARNING AND DISCLOSURE: THOSE USERS THAT ELECT TO UTILIZE THIS SYSTEM AT, OR NEAR, THE WATER'S SURFACE, MUST MAINTAIN SAFETY AWARENESS OF MOVING WATER CRAFTS. ALWAYS MAKE SURE TO HAVE THE MP3 PLAYER VOLUME TURNED TO ZERO AND THE SPEAKERS AWAY FROM THE EARS WHEN TURNING ON THE H20 AUDIO SV UNIT. IF THE VOLUME LEVEL IS NOT ZERO WHEN THE H20 AUDIO SV IS TURNED ON, IT MAY CAUSE EAR INJURY DUE TO A SUDDEN BURST OF VOLUME. THE VOLUME SHOULD BE SLOWLY INCREASED WITH AN AUDIO FILE PLAYING TO SET THE SPEAKER VOLUME TO COMFORTABLE OUTPUT LEVELS PRIOR TO POSITIONING THE SPEAKERS NEXT TO THE EARS. DO NOT USE THE HEADPHONES WHILE DRIVING, CYCLING, OR OPERATING ANY MOTORIZED VEHICLE. IT MAY CREATE A TRAFFIC HAZARD AND IS ILLEGAL IN SOME AREAS. IT CAN ALSO BE POTENTIALLY DANGEROUS TO PLAY YOUR HEADSETS AT HIGH VOLUME WHILE WALKING OR ENGAGING IN OTHER ACTIVITIES, ESPECIALLY AT PEDESTRIAN CROSSINGS. YOU SHOULD EXERCISE EXTREME CAUTION OR DISCONTINUE USE IN POTENTIALLY HAZARDOUS SITUATIONS. AVOID USING HEADPHONES AT HIGH VOLUME. HEARING EXPERTS ADVISE AGAINST CONTINUOUSLY LOUD AND EXTENDED PLAY. IF YOU EXPERIENCE RINGING IN YOUR EARS, REDUCE VOLUME OR DISCONTINUE USE. THE MANUFACTURE DOES NOT WARRANT AND WILL NOT BE HELD RESPONSIBLE IN ANY WAY FOR DAMAGES TO THE AUDIO DEVICE, OR LOSS OF DATA, INCLUDING LOSS OF DATA STORED IN THE DEVICE, RESULTING FROM AN EXCESSIVE IMPACT, THUNDER, OR AN ELECTRICITY FAILURE, OR WATER DAMAGE. YOU WILL BE RESPONSIBLE FOR SAFE GUARDING ALL DATA STORED ON YOUR DEVICE. 5 T-Seal Preparation This product uses a high grade "T" seal. DO NOT USE SILICONE GREASE as this will damage the seal. Always check the T-Seal for hair, sand, lint, or other debris and wipe clean as necessary before closing the lid. Be careful not to stretch the T-Seal. If the T-Seal is cut or cracked it must be removed and replaced with a new T-Seal. If you must replace the T-Seal, visually inspect the groove in the lid and the contact surface for hair, sand, lint, or other debris and wipe clean as necessary. Also, check the contact surface for scratches, blemishes, or other imperfections. If the contact surface is damaged, do not use the housing. It is very possible the housing will flood and damage the electronics. Contact H20 Audio Customer Support for advice. CAUTION: Never use sharp or metal objects to remove T-Seals as they damage the seal or the contact surface. If you must install the T-Seal make sure that it is seated uniformly, with no twists or loose areas. Be careful not to stretch the T-Seal unnecessarily. Contact Surface Warranty Coverage H20 Audio guarantees, to the original purchaser only, that the equipment purchased (EXCLUDING THE MP3 PLAYER) is free of defects in material and/or under normal recreational use for a period of one year (1) from date of consumer purchase from an Authorized Dealer; provided that proper care and maintenance have been performed as prescribed by the owner's guide included with the equipment. Should this product prove to be defective for any reason (other than those listed as limitations below) the product will be serviced or replaced at H20 Audio's sole discretion at no charge (excluding shipping and handling). This warranty shall be void if the registration is not completed and sent to H20 Audio Customer Services within 30 days of purchase. This warranty shall be void if the equipment has been tampered with by anyone not Authorized by to perform service. The warranty is non-transferable and extends to the original purchaser only and is valid only if the equipment was purchased from an Authorized dealer. Warranty does not extend to cover damage from accident, abuse, tampering, lack of maintenance, theft, or loss. Service or modifications by anyone other than an Authorized H20 Audio agent will void the warranty. H20 Audio will not be responsible for recovery or replacement of the product in the event of loss or theft. H20 Audio, its Authorized International Distributors, and Authorized Dealers make no other warranties, either express or implied or orally, or in writing, with respect to any other warranty coverage except those expressly stated within the preceding paragraphs. H20 Audio will not be held responsible for any agreements orally or in writing with the exception of those expressly included in this warranty statement. The Warranty registration card and the terms contained herein supersede all statements contained in any and all owner's guides, instruction cards, or other equipment literature or catalogs. In no event will H20 Audio, its Authorized International Distributors, and Authorized Dealers be held responsible or liable for any personal injuries resulting from the use of the covered equipment, or for any other damages, whether direct, indirect, incidental, or consequential; even if H20 Audio has been advised of such damages. Warranty does not extend to any damages that may occur to the MP3 players or loss of any data. Returning for Service Prior to any return, a Return Authorization (RA) number must be attained. Proof of purchase from an Authorized Dealer will be required. Contact Custom Support to attain an RA number and shipping instructions. A copy of the original sales receipt and a copy of the owner's portion of the warranty card must accompany all correspondence regarding the equipment covered by this warranty agreement or in direct reference to this warranty. Customer Support is available Monday to Friday 9AM to 5PM PST. Website: http://www.h2oaudio.com Phone: 800-708-6080 or 858-623-0339 Fax: 858-225-0815 Email: [email protected] 6 SV-iMini rev.06B General Housing Operations Display | Window | Click Wheel Push Button Scroll Wheel Dial Check the seal and contact surface to make sure it is clean of all debris before closing the lid. Always make sure the lid is sealed and the latch is secure, prior to entering the water. 7 Headset Connector Operations Step 1: Align jack to connector Disconnect Step 1: Firmly grab onto rubber boot below the taper of the connector. a: = Step 2: Push jack into connector => 130 Step 3: Fully seat the rubber boot Step 2: Pull connector apart with a slight twisting motion. = Note: Do not bend the stereo jack connector during disassembly. Step 3: Wipe clean exposed parts E | (Rinse with fresh water & dry) Latch Unlock / Lock Operations Step 1: Slide latch button towards the unlock @ icon Step 2: While holding the latch button on the unlock @* icon, simultaneously push up on the side of the latch wy Step 3: Lift the top latch over the lid hooks. Compress the lid to the base if the latch does not clear the lid hooks. Step 1: Lift the top latch over the lid hooks.Compress the lid to the base if Step 2: Snap the latch downwards to lock it in place Step 3: Verify the latch button is positioned is on the lock icon @ Scroll Wheel Rotate Clockwise Previous /Rewind Button Scroll Wheel Rotate Counter-Clockwise Next/ Fast- Forward Button Select Button 11 MP3 Insertion / Removal Operations Step 1: Align audio port €) with stereo ¡Step 1: Gently rotate the player upwards. jack in the housing. Make sure to plug into the stereo jack. Be gentle. Do not bend the stereo jack. Step 2: Gently snap the player onto the audio jack. VA р LU \ (0) Step 3: Gently rotate the player downwards into place. NONE Coiled Audio Cable Ear Wrap Separation The neck band can be separated from and reattached to the ear wrap. While holding the Pull the neck band from ear wrap to separate . neck band, rotate the ear wrap 90 degrees x 19 № | : A Note: Push neckband and ear wrap together to reattach | E Position behind and swivel for best the ear fit adjustments 12 SV-iMini rev.06A
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project