Havis-Shields Side Slide-Out Step 1997-2007 Chevrolet Full Size Van KK-C-ST-SS User manual

Havis-Shields Side Slide-Out Step 1997-2007 Chevrolet Full Size Van KK-C-ST-SS User manual
INSTALLATION INSTRUCTIONS KK-C-ST-SS
SIDE SLIDE-OUT STEP
1997-2007 CHEVROLET FULL SIZE VAN
TOOLS NEEDED:
Open End Wrench Set
Allen Key Set
Ratcheting Wrench
Power Drill
Drill Bit Set
Marking Tool
Safety Glasses
Standard Socket Set
HARDWARE:
QTY DESCRIPTION
8
¼” Hex Nuts
8
¼-20 x 1” Hex Head Bolt
16
¼” Flat Washer
8
¼” Lock Washer
4
¼” x ¾” Hex Head Lag Bolt
PART #
GSM30005
GSM34002
GSM31005
GSM31026
GSM33060-1
ADJUSTABLE
FRAME RAIL
SUPPORT
SIDE BRACKET
SUPPORTS
SLIDER
BRACKETS
FLOOR MOUNTED
SIDE BRACKETS
SUBASSEMBLY:
1. Bolt floor mounted side brackets to the side bracket supports using the views on the following
page that is vehicle specific. Loosely attach using ¼” x ¾” carriage bolts, flat washers, lock
washers, and hex nuts.
2. Determine height of adjustable frame rail support.
• Hold floor mounted side bracket to the underside of the van floor between the frame and
the fender to determine the height.
• With the specific height determined loosely attach using ¼-20 x 1” hex head bolts, flat
washers, lock washers and hex nuts.
• This will square the backside of the step.
INSTALLATION:
1. PREP THE VAN:
• Pull up carpet along the side door of the van. To do this you must remove the plastic step
well trim piece.
• Locate the center of the side doors and make a visible mark in order to center the side
step.
2. BOLT STEP ASSEMBLY TO VAN:
Note: The frame rail support will not sit flush to frame rail on van.
•
Position assembly tight to floor of van with frame rail support tight to frame of van.
Mark and drill (4) ¼” holes through floor of van using holes in floor mounted side
brackets as a template.
Note: side bracket supports may have to be temporarily removed in order to properly position step
between fender and frame rail.
•
•
Position step assembly then loosely reattach side bracket supports.
Bolt step to floor using ¼-20 x 1” hex head bolts, flat washers, lock washers and hex
nuts.
3. FINAL INSTRUCTIONS:
• Loosen side bracket supports and position tight to fender lip.
• Mark and drill (4) ¼” holes into fender lip using side bracket supports as a template.
• Attach side bracket supports to fender lip using ¼-20 x 1” hex head bolts, flat washers,
lock washers and hex nuts. .
• Check that step slides smoothly and goes to the closed position. Replace carpet and step
sill trim.
KK-C-ST-SS-INST-9-06
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement