Havis-Shields WGI-D22 Install Instructions

INSTALL INSTRUCTIONS WGI-D22

INTERIOR WINDOW GUARDS

2005-2006 DODGE MAGNUM

TOOLS REQUIRED:

Power drill

Drill bits – 1/8”, 5/32”

T-25 tamperproof torx bit

Phillips screwdriver

1

2

8

8

4

4

HARDWARE:

QTY DESCRIPTION

1 Driver

Passenger Side Window Guard

Upper mounting bracket

#10 x ¾” Sheet metal screw

#10 x ½” Sheet metal screw

¼” x ½” T-25 Tamperproof bolts

¼” Flat Washers

WGI-D22-1

WGI-D22-6

WGI-MB-12-90

GSM33195

GSM33194

GSM34190

GSM31005

Always

!

Read all instructions before installing any Havis-Shields Equipment Corp products.

Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

Use hardware provided with install kit

SUBASSEMBLY:

1. Bend window guard so it contours the door as shown in photo #1.

2. Determine the proper window guard for each window.

3. If installing aluminum door panels refer to those instructions at this time. They will need to be installed first.

Photo 1

WGI-D22-INST-10-06

INSTALL WINDOW GUARDS

• Loosely attach upper mounting bracket to window guard using ¼” x ½” tamper proof screws and flat washers.

• Position screen to vehicle as shown in photo #2.

• Make sure you have the window guard centered on the door.

• Mark, drill 1/8” holes, and attach lower mount using #10 x ½” screws as shown in photo

#3.

Note: Be sure the upper mounting brackets go under weather stripping and the notches go around the mounting plugs.

Make sure the mounting holes will have metal material to drill into.

• Press firmly against window guard and mark door where the upper mounting brackets are located

• Drill 5/32” holes and mount to door using #10 x ¾” sheet metal screws.

Mount upper bracket using #10 x ¾” screws

Photo #2

Mounting holes. Drill 1/8” holes.

Mount using #10 x ½” screws

Press firmly against guard until bracket is under weather stripping.

Mark and drill 5/32” holes

Photo #3

WGI-D22-INST-10-06