A projector with outstanding characteristics

A projector with outstanding characteristics
Specifications
DMD Panel*
Lamp
Lamp Life**
Lens
Throwing angle
Throwing Distance
Image Size
Light Output
Relative Illumination Greater
Maximum Resolution
Contrast Ratio
Optical Unit
Horizontal
Synchronization Range
Vertical
Video Bandwidth
Colour Reproduction
1 RGB Input
Component Input
(Sharing with
RGB Input)
Input Terminals
1 Video Input
1 S-Video Input
1 Audio Input: For RGB,
Component, Video, S-Video
Built-In Speaker
Keystone Correction
Operational Temperatures
Storage Temperatures
Environment
Power Requirements
Power Consumption
Input Current
Available languages
Regulations
Dimensions (W x H x D)
Net Weight
·
1 Stereo Mini jack
MultiSync LT170
·
·
Horizontal Resolution
Micro Portable Projector
LT170
1chip DMD (0.7-inch) reflective type, 1,024x768 pixels
145W DC (Normal Mode) / 130W (Eco Mode)
1,500hrs. (Normal Mode) / 2,000hrs. (Eco Mode)
Manual zoom / Focus (range: 1 to 1.1)(F2.0 to 2.13)(focal length: 25.7mm to 28.3mm)
9.5(Wide) / 8.6(Tele) @60 inches
1.1m to 8.1m
30 inches to 200 inches
1,500 ANSI lumens (Normal Mode)/1,350 ANSI lumens (Eco Mode)
80% or over
UXGA (1,600 x 1,200 pixels) with Advanced AccuBlend
1,000:1 (White:Black)
Time multiplex colour wheel method with white segment
15kHz to 100kHz (RGB:24kHz or over)
50Hz to 120Hz
RGB:100MHz (-3dB)
540 TV Lines: NTSC / NTSC 4.43 / PAL / Y Cb Cr
300 TV Lines: SECAM
Full colour,16.7 million colours simultaneously
RGBHV
VGA, SVGA, XGA, SXGA, UXGA
RGB
0.7Vp-p/75Ω
1 Mini D-Sub 15-pin
H/V Sync
4.0Vp-p/TTL polarity
Composite Sync
4.0Vp-p/TTL level
Sync on G
0.3Vp-p/75Ω negative polarity
Y
1.0Vp-p/75Ω (with sync)
Cb Cr ( Pb Pr)
0.7Vp-p/75Ω
1 Mini D-Sub 15-pin
1125i (1080i), 750p (720p), 525p (480p), 525i (480i) /60Hz
(Sharing with RGB Input)
1080i/50Hz, progressive PAL-scan/50Hz
DVD component video signal (15kHz)
NTSC/NTSC 4.43/PAL/PAL-N/ PAL-M/PAL-60/SECAM
1 RCA pin
Composite video
1.0Vp-p/75Ω
Y
1.0Vp-p/75Ω
1 Mini DIN-4-pin
C
0.286Vp-p/75Ω
·
Stereo L/R
0.5Vrms/22kΩ or over
0.5W
V max ±30 degrees
41° to 95°F (5° to 35°C), 20 to 80% humidity (non-condensing)
14° to 122° F (-10° to 50°C), 20 to 80% humidity (non-condensing)
100 to 240V AC, 50Hz / 60Hz
196W (Normal Mode) 170W (Eco Mode) 4.0W (Standby)
2A (100 to 120V AC) / 1A (200 to 240V AC)
English, German, French, Italian, Spanish, Swedish, Japanese, Korean, Simplified Chinese, Polish, Hungarian, Russian, Greek, Turkish, Dutch, Norwegian, Finnish, Portuguese, Czech, Arabic.
UL approved (UL 60950, CSA 60950)
Meets EN60950
Meets DOC Canada class B requirements
Meets FCC class B requirements
Meets AS/NZ CISPR22
Meets EMC directive (EN55022:1998 class B, EN55024-1998, EN61000-3-2, EN61000-3-3 )
Meets Low Voltage Directive (EN60950, TUV GS approved)
123mm x 85mm x 280mm (Not including protrusions)
1.8kg
* Effective pixels are more than 99.99% of total pixels.
** Lamp life is defined as the average time span for the brightness of the lamp to be reduced by half. It does not refer to the warranty period for the lamp.
All specifications are subject to change without notice.
Remote Control Unit
Terminal Panel Features
Dimensions (mm)
Lens centre
COMPUTER / COMPONENT INPUT (Mini D-Sub 15-pin)
VIDEO IN (RCA Phono)
S-VIDEO IN (Mini D-Sub 4-pin)
AUDIO IN MINI JACK (Stereo Mini)
MAINTENANCE PORT
Lens centre
Throwing Distance and Screen Size
Screen size
Wide
Tele
Screen height from projector base (cm)
Height of base H (cm)
Optional Accessories
Throwing distance L (m)
Model
LT70LP
Products
Replacement lamp
●The values shown above were calculated at the time of design and thus have a possible margin of error of ±5%.
CAUTION
Screen height from
projector base
Screen centre
Lens centre
Base of projector
Base of screen
Care should be taken when handling a tripod. Using a tripod on an unstable surface may result in the tripod falling
over or the projector falling, which may result in damage to the projector and personal injury. Read the instructions
supplied with your tripod for handling directions and cautionary notices.
● Use a tripod that can fully support the weight of the projector (approximately 5.5lb/2.5kg including attachments).
● Place the tripod with its legs fully open and weight evenly distributed for stability.
● When using a tripod with a geared elevator, do not extend the geared elevator.
● When displaying an image in portrait mode (with the projector on its side), be sure that the tripod is balanced
and stable. Failure to ensure balance and stability may result in the tripod falling over.
A projector with outstanding characteristics
KDLP-0310-161KR
for more information
www.nec-pj.com
The DLP logo and DLP medallion are trademarks of Texas Instruments.
XGA is a registered trademark of International Business Machines Corporation.
From Digital Cinema to Mobile Convenience — NEC Projector is the Best Solution
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement