Honda P/N 08A53-S5A-100 User's Manual

Honda P/N 08A53-S5A-100 User's Manual
HandA-Accessories.com
INSTALLATION
INSTRUCTIONS
PARTS LIST
Cassette Player:
P/N 08A53-S5A-100
Accessory
Application
CD/CASSETTE PLAYER
CIVIC
2- AND 4-DOOR
Publications No.
AII 27857
Issue Date
AUG 2004
CD Player:
P/N 08A53-S5D-100
CD player
Cassette player
Owner’s Manual
4 Washer-screws, 5 x 8 mm
Owner’s Manual
Washer-screw, 4 x 8 mm
Harness clip
5 Washer-screws, 5 x 8 mm
Rubber pad
Harness clip
Adhesive pad
Rubber pad
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
8 mm and 10 mm Sockets
Ratchet
Shop towel
Utility knife
Isopropyl alcohol
Tape measure
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by “do-it-yourselfers.”
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
AII 27857 (0408)
08A53-S5A-1000-91
1 of 8
If the vehicle is equipped with a center console
armrest, go to step 6, otherwise; continue with step 3.
3.
M/T Model:
•
Remove the shift knob from the lever by holding
the plastic section above the boot down firmly
with one hand and turning the knob in a
counterclockwise with the other hand.
•
Remove the two self-tapping screws, two
screws, and two clips that fasten the center
console and remove the console.
Pull up on the parking brake lever, then remove the
console box (nine clips).
CLIPS (9)
CONSOLE BOX
SHIFT
CLIP KNOB
CLIP
PLASTIC
SECTION
SELF-TAPPING
SCREW
BOOT
CENTER
CONSOLE
PARKING BRAKE
LEVER
Pull up
completely.
4.
Remove the center console.
SHIFT LEVER
Place in the
Neutral position.
A/T Model:
•
Place the shift lever in the Neutral position.
•
Remove the two self-tapping screws, two
screws, and two clips that fasten the center
console and remove the console
•
If equipped with an optional seat armrest,
remove the console after reclining the seatback.
CLIP
SCREW
3620030K
SELF-TAPPING
SCREW
CENTER
CONSOLE
SHIFT LEVER
Place in the
Neutral position.
SCREW
3620020K
2 of 8
AII 27857 (0408)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
5.
If the vehicle is not equipped with a center console
armrest, go to step 10, otherwise; continue with step 6.
Remove the dashboard center lower cover.
Without a Cigarette Lighter and Ashtray:
6.
•
With the parking brake applied, place the gear
shift lever in the Neutral position.
•
Gently pry out on the lower cover to release the
six retaining clips.
•
Unplug the accessory power socket connector
(if equipped, unplug the fog light harness), and
remove the lower cover.
A/T Model:
•
With the parking brake applied, place the shift
lever in the Neutral position.
•
Pry up on the four retaining tabs and remove
the escutcheon.
•
Pry up on the three clips and six retaining tabs
and remove the center console trim.
RETAINING
TABS (6)
ACCESSORY
POWER
SOCKET
CONNECTOR
FOG LIGHT SWITCH
CONNECTOR
(if equipped)
Remove the escutcheon, and the center console
trim:
CENTER CONSOLE
TRIM
FOG LIGHT
SWITCH
(if equipped)
ESCUTCHEON
DASHBOARD CENTER
LOWER COVER
CLIPS (6)
CLIPS (3)
With a Cigarette Lighter and Ashtray:
•
With the parking brake applied, place the gear
shift lever in the Neutral position.
•
Remove the ashtray.
•
Inside the ashtray opening, remove the one
self-tapping screw securing the dashboard
center lower cover.
•
Gently pry out on the lower cover to release the
six retaining clips.
RETAINING
TABS (4)
ILLUMINATION
BULB
CIGARETTE
LIGHTER
CONNECTOR
ASHTRAY
RETAINING
CLIPS (6)
SELFTAPPING
SCREW
3304120W
DASHBOARD CENTER
LOWER COVER
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27857 (0408)
3 of 8
M/T Model:
7.
Remove the dashboard center lower cover.
•
Apply the parking brake.
Without a Cigarette Lighter and Ashtray:
•
Remove the shift knob from the lever by
holding the plastic section above the boot down
firmly with one hand and turning the knob
counterclockwise with the other hand.
•
Remove the two self-tapping screws that fasten
the dashboard center lower cover.
•
Gently pry out on the dashboard center lower
cover to release the rear four clips, then pull the
cover rearward to release five clips and one
retaining tab.
•
Unplug the accessory power socket connector
(If equipped, unplug the fog light harness), and
remove the dashboard center lower cover.
•
Pry up on the three clips and six retaining tabs
and remove the center console trim.
SHIFT KNOB
RETAINING
TABS (6)
PLASTIC
SECTION
FOG LIGHT SWITCH
(if equipped)
BOOT
RETAINING TAB
SELF-TAPPING
SCREW
DASHBOARD
CENTER
LOWER
COVER
CLIPS (9)
CLIPS (3)
CENTER
CONSOLE TRIM
3624030K
FOG LIGHT
SWITCH
CONNECTOR
(if equipped)
ACCESSORY
SOCKET
CONNECTOR
CENTER PANEL
KNOB
SELF-TAPPING
SCREW
4 of 8
AII 27857 (0408)
HEATER
CONTROL
PANEL
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
With a Cigarette Lighter and Ashtray:
•
•
8.
Open the center console lid, and remove the mat.
Remove the ashtray. Inside the ashtray
opening, remove the one self-tapping screw.
Remove the two self-tapping screws that fasten
the dashboard center lower cover.
•
Gently pry out on the dashboard center lower
cover to release the rear four clips, then pull the
cover rearward to release five clips and one
retaining tab.
•
Unplug the cigarette lighter connector, the
accessory power socket connector, and the
illumination bulb, then remove the lower cover.
CLIPS (2)
CENTER
CONSOLE
SELFTAPPING
SCREW
MAT
CENTER
CONSOLE LID
DASHBOARD
CENTER
LOWER COVER
RETAINING TAB
ASHTRAY
SCREW
CIGARETTE
LIGHTER
CONNECTOR
SHIFT LEVER
Move to the
Neutral position.
SELFTAPPING
SCREW
9.
ILLUMINATION
BULB
3624040K
Remove the two clips, two self-tapping screws and
three screws that fasten the center console. Move
the shift lever to the Neutral position, and remove
the center console.
CLIPS (9)
3804020K
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27857 (0408)
5 of 8
10. Remove the center panel:
13. Remove the pocket (four self-tapping screws).
•
Remove the two bolts from the bottom of the
center panel.
•
Reach through the bottom opening, and push
out on the center panel bracket to release the
nine clips.
•
Unplug the five connectors and the antenna
lead, then remove the center panel.
SELF-TAPPING SCREW
(Discard.)
POCKET
CENTER
PANEL
VEHICLE HARNESS
CONNECTORS (5)
RETAINING
CLIPS (9)
CENTER
PANEL
ANTENNA
LEAD
14. Use a tape measure to measure and mark the
rubber pad as shown. Using scissors, cut the
rubber pad into three pieces. Remove the adhesive
backing from each of the rubber pads, and attach
them to the center panel in the areas shown.
Push.
CENTER
PANEL
BRACKET
SELF-TAPPING
SCREW
(Discard.)
BOLT
11. Gently pull out on each knob to remove them from
the heater control panel.
40 mm
RUBBER
PAD
Thoroughly clean
40 mm
with isopropyl
alcohol.
CENTER PANEL
RIB
ADHESIVE BACKING
KNOB
SELF-TAPPING
SCREW
HEATER
CONTROL
PANEL
END OF CURVE
RUBBER PAD
(Cut.)
CENTER PANEL
12. Remove the three self-tapping screws that fasten
the heater control panel to the center panel, and
remove the heater control panel.
6 of 8
AII 27857 (0408)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
If you’re installing a cassette player, continue with
step 15; otherwise, go to step 17.
15. Using a utility knife, cut off the bottom rib from the
center panel at the lower edge of the audio
opening. Remove all burrs. Before attaching the
rubber pads, thoroughly clean the areas where the
rubber pads will attach with isopropyl alcohol.
17. Slide the CD or cassette player into the opening of
the center panel, then install the four screws
provided with the CD or cassette player.
CENTER PANEL
CENTER PANEL
CD OR
CASSETTE
PLAYER
SCREWS (4)
(Provided with the
CD or cassette
player.)
Install in
the lower
hole.
Cut off the
bottom
rib.
18. Attach the harness clip to the rear of the CD or
cassette player with the washer-screw provided.
Sectional
View
AUDIO UNIT
16. Remove the adhesive backing from the adhesive
pad, and attach it to the bottom of the cassette
player in the area shown.
ADHESIVE PAD
BOTTOM OF
CASSETTE PLAYER
HARNESS
CLIP
ADHESIVE
BACKING
CONNECTOR
CD OR
CASSETTE
PLAYER
WASHER-SCREW
CD player:
4 x 8 mm washerscrew
Cassette player:
5 x 8 mm washerscrew
19. Plug the connector from the CD or cassette player
into the rear of the audio unit, and secure the harness
with the harness clip.
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27857 (0408)
7 of 8
20. Reinstall the heater control panel and knobs on the
center panel.
23. Reconnect the negative cable to the battery.
24. Enter the anti-theft code, and reset the customer’s
radio station presets.
25. Reset the clock.
CENTER PANEL
26. Check operation of the CD or cassette player
according to the Owner’s Manual.
27. Reinstall all removed parts. Check that all clips
and fasteners are installed securely.
28. Place the Owner’s Manual for the CD player or the
cassette player in the glove box.
KNOB
SELF-TAPPING
SCREWS
29. Test the operation of the accessory socket/
cigarette lighter.
NOTE: Whenever the battery is disconnected, the
driver's window AUTO function is disabled.
HEATER
CONTROL
PANEL
30. Start the engine. Push down on the driver's window
switch until the window is fully open.
31. Pull up on the driver's window switch to close the
window completely, then hold the switch for 2
seconds or more.
To reinstall the
knobs, align the flat
surface on the rod
with the flat surface
on the knob.
32. Lower and raise the driver's window to check
operation of the driver's window AUTO function.
21. Plug in the five vehicle harness connectors, then
plug the antenna lead into the rear of the audio
unit.
33. Do the ECM/PCM idle learn procedure.
- Make sure all electrical items are turned off.
22. Reinstall the center panel with the two bolts.
CENTER
PANEL
- Start the engine. Hold the engine speed at
3,000 rpm with no load (in Park or Neutral) until
the radiator fan comes on.
VEHICLE HARNESS
CONNECTORS (5)
- Let the engine idle for about 5 minutes with
the throttle fully closed and with all electrical
items off.
NOTE: If the radiator fan comes on during this
step, the time it operates must not be included
in the 5 minutes.
ANTENNA
LEAD
BOLT
(reused)
8 of 8
AII 27857 (0408)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement