HP | LASERJET 2600 | User's Manual | HP LASERJET 2600 User's Manual

HP LASERJET 2600 User's Manual
HP Color LaserJet 2600 series -- Maintenance Kit Instructions
www.printertechs.com
Please note that installing the fuser in this maintenance kit is considered an
advanced installation procedure. If you have never done this before you will
want to follow the steps carefully and allow extra time for installation.
Because of the advanced nature of the fuser installation, we can only provide
limited technical support for this kit.
Here is the outline of installation steps:
Step #1 – Replace the separation pad.
Step #2 – Replace the pickup roller.
Step #3 – Replace the fuser.
Paper pickup roller removal and replacement
Use the following procedures to remove the paper pickup roller.
ENWW
1
Open the front door.
2
Remove the print cartridges.
Removal and replacement procedures
89
3
Remove two (2) screws.
1
90
Two (2) screws
4
Remove the pre-transfer guide (RC1–5419–000CN).
5
Use a small screwdriver to pull back on the tabs.
Chapter 5
Removal and replacement
ENWW
3
Remove two (2) screws from the right cover assembly (RM1–1858–000CN).
1
ENWW
Two (2) screws
4
Remove the right cover assembly, carefully disengaging the catches.
5
Unplug the control panel cable.
Removal and replacement procedures
75
76
6
Insert a screwdriver to loosen the release tab on each side of the upper face cover.
7
Remove the upper face cover (RC1–5174–000CN).
8
Remove four (4) screws from the upper cover (RC1–5176–000CN).
Chapter 5
Removal and replacement
ENWW
9
Lift up and remove the face-down cover (RC1–5173–000CN).
10 Remove the output tray by releasing the tabs.
1
Release tabs
11 Unplug the harness from the fuser motor.
ENWW
Removal and replacement procedures
77
12 Open two (2) clips and remove one (1) clip to remove the fuser connector.
78
1
Open clips
2
Remove clip
1
Fuser connector
2
Remove clip from the board by pulling up
Chapter 5
Removal and replacement
ENWW
13 Unplug two (2) 3-pin optical encoder wires.
14 Unplug the red high-voltage bias wire.
15 Remove the thermistor wire.
ENWW
Removal and replacement procedures
79
16 Remove the cables from the wiring harness.
17 Remove three (3) screws from the fuser chassis.
1
Three (3) screws
18 Gently rocking if necessary, roll the fuser (RM1–1820–00CN for 110V) or (RM1–1821–000CB for
220V) forward to remove.
80
Chapter 5
Removal and replacement
ENWW
Use the following procedure to replace the fuser.
1
Align the fuser tabs with their respective holes.
2
Complete replacement by following steps 1 through 18 above in reverse order.
NOTE When replacing the right cover, align the tabs on the upper edge of the right cover
and lower edge of the face-down cover with their respective slots.
1
Tabs
NOTE Connect the control panel cable before replacing the right cover.
ENWW
Removal and replacement procedures
81
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising