HP PL4245N User manual
HP PL4245N 42" Plasma HDTV Start Here AV AV AUDIO L DVI Y Cb/Pb Y Cr/Pr R Cb/Pb Cr/Pr AUDIO L R VGA Connectors are located on the back of the TV, under the back panel. Thank you for purchasing an HP PL4245N 42" Plasma HDTV 1 Attach Brackets to Speakers 2 Attach Speakers to TV 3 Connect Speaker Cables to TV 4 Connect Subwoofer (optional) Step 1 OUT Your setup time may vary. ■ Identify the type of connectors your home entertainment equipment uses, then go to the corresponding step on this poster and follow those directions. (Example: To connect a cable or satellite set-top box which connects via S-video cabling, refer to step 7, “Connect an S-video device.”) ■ Refer to the user documentation for advanced connections. ■ Apply power to all components and then to the TV. ■ Finally, refer to the section titled “Setting Up Your Channels” in your user documentation to finalize your TV setup. Contents ■ HP plasma TV Step 2 Step 3 5 Connect a PC or an HP HD Tuner by DVI 6 Connect a Component (YPbPr) Device ■ TV stand Component Video Outputs ■ Speakerbars (2) L R Y Pb Pr Y Pb Pr 7 Connect an S-video Device 8 Connect a Composite Device S-video Outputs Composite Video Outputs DVI ■ Documentation kit ■ Remote control with AA batteries (2) ■ Speaker cables (2) AV ■ Antenna cable DVI AV AUDIO L R ■ AC power cable The information in this document is subject to change without notice. 9 Analog Video from PC 10 Outdoor Antenna 11 Remote Control 12 Power On Connection Wall TV OUT © 2004 Hewlett-Packard Development Company, L.P. Signal Coaxial Cable Printed in www.hp.com Once the power cable is connected, power on TV by pressing PWR on the remote control. Refer to the section in the user documentation titled “Setting Up Your Channels” to complete TV setup. Refer to the user documentation for advanced connections.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project