Human Touch | HT-7450 | User's Manual | Human Touch HT-7450 User's Manual

12/27/08
REPLACING THE HT-7450 AIR PUMP TUBING
HT-7450
FITTING
To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: Phillips-head screwdriver, nail clipper or other instrument suitable for cutting zip ties,
new zip ties, small needle-nosed pliers, large paper clip
NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
SERVICE LEVEL: 2
Fitting
REMOVING THE FITTING
Top connector
1. Power off the chair and unplug it.
2. Locate the backrest connection panel on the back of the left-hand armrest, then unplug the top connector (Fig.1).
3. Locate the fitting piece that broke off and, if possible, remove it. It is most likely lodged in the fitting receptacle
on the backrest connection panel. You may need to bend a large paper clip as shown in Fig.2, then use this tool to
dislodge the broken fitting piece from the receptacle (Fig.3).
(Fig.1)
Broken fitting piece
Large paper clip
(Fig.2)
(Fig.3)
1
4. If you cannot remove the broken fitting piece from the receptacle, you will need to remove the left-hand side panel,and remove the broken piece from the inside:
a. Using two hands, pull the left-hand side panel cover outward to separate it from the chair (Fig.4).
b. Using a nail clipper or other instrument suitable for cutting zip ties, cut the zip tie that secures the tubing to the white fitting receptacle, then remove the tubing
from the receptacle (Fig.5).
c. Use a small needle-nosed pliers or other similar tool to remove the broken fitting piece from the receptacle.
d. Place the tubing back onto the fitting receptacle, and secure it using a new zip tie.
e. Align the posts on the chair base with the corresponding post guides on the side panel cover, then gently tap the cover into place.
5. Using a Phillips-head screwdriver, remove the two screws that secure the fitting to the air pump tubing connector (Fig.6).
White fitting receptacle
X1103
Left-hand side panel cover
Tubing
Inside of the left-hand
Fitting
side panel cover
(Fig.4)
(Fig.5)
(Fig.6)
INSTALLING THE NEW FITTING
1. Place the new fitting into the air pump tubing connector, and secure it using the two screws.
2. Connect the air pump tubing connector to the corresponding receptacle on the backrest connection panel (located on the back of the left-hand armrest).
3. Plug in the chair and power it on.
4. Verify that the massage comfort control is now working properly.
Please send any questions or comments regarding these instructions to: documentation@humantouch.com
© 2008 Human Touch®, LLC.
2
Download PDF