Victron energy Skylla-i remote on-off cable Owner Manual

13-05-2014

Skylla-i remote on-off cable (ASS030550400)

This cable is intended for on/off control of the Skylla-i when the source signal is high when the

Skylla-i must be on, and low or free floating when Skylla-i must be off.

This cable can for example be used for on-off control of the Skylla-i by the VE.Bus BMS, see example below:

Specifications:

Maximum input voltage: 70 V

Minimum input voltage needed for switch on: approximately 6 V

Switch off level: input voltage must be less than 1 V or must be free floating