INFP1596Stand4000-OM 10/18/04 2:51 PM Page 1
TSS-4000
T
OTAL
S
PEAKER
S
OLUTIONS
TSS-STAND4000
Owner’s Guide
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 2
Installing the TSS-SAT4000
Step One
Remove the bottom end cap of the speaker by unscrewing the single center screw (Allen wrench included with satellite).
Step Three
Align and insert the alignment pin into the bottom of the speaker.
Satellite Speaker
Infinity Logo
NOTE: The bottom is the side closest to the Infinity logo on the front grille.
End Cap
1/4-20 x 3/4" Screw
Step Two
Attach alignment pin to stand, and run speaker wire up stand.
NOTE: Needle-nose pliers may be required.
Alignment Pin
Alignment Pin
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 3
Step Four
Tighten the bolts on the bottom as shown. It’s recommended that two people perform this step so that the speaker is supported while it’s on its side and the bolts are being tightened. Attach speaker wire as described in TSS-SAT4000 Owner’s Manual.
25"
47-1/2"
Bolts
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 4
© 2004 Harman International Industries, Incorporated
Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com
Infinity is a registered trademark, and Total Solutions is a trademark, of Harman International Industries, Incorporated. Part No. 400-OMSTN 10/04