GSM Power Socket Quick Start Guide
GSM Power Socket Quick Start Guide
Ensure unit is switched off, remove the SIM cover and insert a SIM card. Refit the
cover, insert the temperature sensor, switch the unit on and plug the unit into a
standard 13A socket.
Once the green power LED and blue GSM LED are lit, the device is ready to be
programmed.
The first step is to set the master number. To do this, send an SMS to the SIM with
the command #00#. The device should reply with Welcome to the GSM socket.
Your password is 1234
To turn the output on
Send an SMS with the command #01#
Successful SMS reply: The socket power output has been switched on
To turn the output off
Send an SMS with the command #02#
Successful SMS reply: The socket power output has been switched off
The output can also be switched by pressing the manual override button for
approximately 0.5 seconds.
To check the operating status
Send an SMS with the command #07#
Successful SMS reply example: Number +447823123456
Status: OFF
TEMP: 22
Temp control: function OFF
Schedule control: function OFF
Delay control: function OFF
To check the socket output status
Send an SMS with the command #000#
Successful SMS reply example: Status OFF Temp: 22
To factory reset the GSM Power Socket
Send an SMS with the command #08#
Alternatively, press and hold the manual override button for 5 seconds.
LED indicators
Power LED
(Green)
GSM LED
(Blue)
Output LED
(Red)
Off
On
Off
On
Flashing
Off
On
GSM Power Socket not powered
GSM Power Socket powered
No SIM inserted or power switch is off
GSM Power Socket is registered on the mobile network
Searching for mobile network or sending SMS
Output is off
Output is on
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement