Kambrook | Jaguar KBV40 | User's Manual | Kambrook Jaguar KBV40 User's Manual

Kambrook Jaguar KBV40 User's Manual
Kambrook 461 Plummer Street, Port Melbourne 3207, Australia
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 271 3980 Customer Service Fax 0800 288 513
UE GO
UE GO
OD VAL
OD VAL
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/06
OD NA
ME GO
ME GO
OD NA
Jaguar Bagless
Vacuum Cleaner
KBV40
Issue 1/06
Welcome to Kambrook
and your new Jaguar
Bagless Vacuum Cleaner.
This vacuum cleaner is not intended for
use by young children or infirm persons
unless they have been adequately
supervised by a responsible person to
ensure that they can use the vacuum
cleaner safely.
At Kambrook we believe that the safe
performance of our products is the first
priority in any consumer product so that
you, our valued customer, can confidently
use and trust our products.
Features of your Kambrook Jaguar Bagless Vacuum Cleaner
Do not leave the vacuum cleaner
unattended when in use.Young children
should be supervised to ensure that they
do not play with the vacuum cleaner.
We ask that any electrical appliance that
you use be operated in a sensible fashion
with due care and attention placed on the
following important operating
instructions:
11
Close supervision is required at all times
when operating the vacuum cleaner near
children.
2
This vacuum cleaner is suitable for
domestic use only. Do not use this
vacuum cleaner for anything other than its
intended use.
Read all instructions thoroughly
before activating the appliance and
retain them for future reference.
Ensure that the power source to be used
is the same as the voltage requirements of
the product.
3
12
1
8
4
7
Do not use or store outdoors.
Fully extend the cord (to the red tape mark)
whenever the vacuum cleaner is in use.
Always switch vacuum cleaner to off, then
switch off at the power outlet, then
unplug the vacuum cleaner when not in
use and prior to cleaning the dust canister
or filters.
The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.
Never use the vacuum cleaner without a
dust canister and motor protection filter
in place.
Never use the vacuum cleaner to vacuum
hot ashes, broken glass, sharp objects or
liquids
Regularly inspect the supply cord, plug and
actual appliance for any damage. If found
damaged in any way, immediately cease
use of the appliance and return the entire
appliance to the nearest authorised
Kambrook service centre for examination,
replacement or repair.
Never use in the presence of explosive
liquids or vapours
Never vacuum up inflammable or
poisonous liquids such as petrol, copier
toner or other volatile substances. Never
vacuum up acids, asbestos or asbestos dust.
2
6
5
10
9
1. Powerful 2000 watt motor
7. Dust indicator
2. Auto cord rewind with 7 metre
power cord
8. 360 degree crush proof hose
3. On/off button with variable speed
control
10. HEPA Klean-Air 6™ stage filtration
9. Fresh air boost
11. Crevice tool & brush attachments
4. Park tool
12. Adjustable telescopic chrome steel
wand
5. Transparent dust canister
6. Multi-terrain floor tool
3
Using Your Kambrook Jaguar
Vacuum Cleaner
To retract the cord push down on the
‘cord rewind’ pedal.
Remove all packaging from the unit, hose
and other accessories; ensure that you
have removed all of the accessories before
discarding the packaging.
IMPORTANT: HOLD THE PLUG END
WHEN RETRACTING THE CORD TO
PREVENT IT FROM STRIKING YOU OR
THE VACUUM.
Ensure that the dust canister and filters
are correctly fitted.
ALWAYS ENSURE THAT THE
DUST CANISTER AND THE
MOTOR PROTECTION FILTER ARE
CORRECTLY FITTED. NEVER
OPERATE WITHOUT THE DUST
CANISTER AND FILTERS IN PLACE.
Locate the crush proof hose and push the
connection point into the hose inlet
connection on the front of the unit, until a
“click” sound is heard.
Variable Power Control
The On/off button, on the top of the unit,
is also to be used for variable power
control. Turn the control clockwise for
maximum power for vacuuming hard floor
and carpet surfaces.Turn the control anticlockwise for minimum power when using
the crevice and brush tools.
Connect the wide end of the metal wand
to the hose end, and push together firmly.
Fit the floor tool to the narrow end of
the wand/s and push together firmly.
Fully extend the power cord by pulling
the power plug (situated at the rear of the
unit) out from the unit, until the yellow
tape on the cord is shown.
Crevice and brush tool accessories
The crevice tool is ideal for vacuuming
hard to reach places such as the edges
along skirting boards.
ENSURE THAT YOU DO NOT
OVER EXTEND THE POWER CORD
– DO NOT EXTEND PAST THE RED
WARNING TAPE ON THE CORD
Plug into a 230/240v power point and
switch the power on.
The brush tools can be used to vacuum
delicate surfaces and areas such as shelves
and venetian blinds.
To commence vacuuming push down on
the on/off foot pedal, at the top, rear of
the unit.
Set the variable speed control between
minimum and medium power when using
the tool accessories.
When vacuuming is complete, push down
on the ‘on/off’ pedal to switch off.
Turn the power off at the outlet and then
remove the power cord from the power
outlet (when removing plug from the
power outlet grasp the plug not the cord).
Turn off the vacuum cleaner when
changing any attachments.
Dust canister indicator and
dispensing the dust canister
The dust canister should be emptied
when full.The dust canister indicator
window will gradually turn red as the
4
canister fills up.When the dust canister
indicator displays ‘red’ it is time to empty
the canister. Otherwise you can look
at the canister at the back end of the unit
and decide when you would like to empty
it.
4.To remove the HEPA filter rotate the
filter in an anti-clockwise position until
released.Then lift the HEPA filter
vertically to remove.
5.Tap and shake the filter until all the fine
dust particles are removed. However
after approximately 6 months the filter
should be replaced.
Always switch appliance off, then switch
off at the power outlet and unplug the
appliance prior to replacing filters or
emptying the dust canister.
6.To place the filter back in the dust
canister simply place the HEPA filter in
the dust canister lid and turn the filter
in a clockwise direction to lock it
in place.
To remove the dust canister, ensure the
unit is down on its wheels; Remove the
dust canister by clasping the handle and
pressing down on the button above the
dust canister. Once released slowly pull
the canister toward you.
7.To place the mesh filter bracket back in
place, ensure that it is completely dry
before use. Simply place the filter on
top of the HEPA filter and ensure the
indents in the mesh filter holder meet
with the grooves in the dust canister
lid.This will ensure that the mesh filter
bracket is locked in place.
To empty the dust canister simply place it
above the rubbish bin; lift the “lift and
press” lever and then press the button.
The bottom of the canister will release
and the dust and compiled dirt will be
dispensed.
IMPORTANT: DO NOT USE THE
UNIT WITHOUT A DUST CANISTER
IN PLACE
8. Place the complete filter assembly back
on top of the dust canister. Place the
dust canister back in the vacuum
cleaner for next use.
Cleaning and replacing filters
Filters must be cleaned from time to time
to remove the fine dust particles that have
been collected.
Motor protection filter
The motor protection filter must always
be in place when operating the vacuum
otherwise damage to the motor may occur.
1. Remove the dust canister from the unit
To replace the motor protection filter –
remove the dust canister.The motor
protection filter is located at the rear of
the inner chamber. Pull the plastic filter
holder toward you to remove. Replace
the filter and push the holder back in
place once filter replacement been made.
2. Lift the lid of the dust canister
3.Take off the mesh filter by lifting it
vertically; this filter can be washed in
luke warm water. Ensure you let the
filter completely dry naturally before
next use.
5
KAMBROOK
2 YEAR REPAIR
WARRANTY
Fresh Air Boost control
Within the air filter covers on both sides
of the unit, there are scent canisters.To
remove the canister, simply press down on
the top end of the canister and pull it
away from the filter cover. Lift the lid of
the canister and place three scent balls in
the canister and close it.To place the
canister back in the filter cover, simply
position the bottom end of the canister in
the indented area and push on the top of
the lid of the canister and then release.
The canister will be secured within the
filter cover. Repeat the process for the
other side of the vacuum cleaner.
KAMBROOK warrants the purchaser
against defects in workmanship and material,
for a period of 2 years from the date
of purchase (3 months commercial use).
Guarantee and purchase receipt for this
product are to be retained as proof
of purchase and must be presented
if making a claim under the terms of the
KAMBROOK guarantee.
KAMBROOK reserves the right to repair
the appliance within the warranty period.
Warranty does not apply to any defect,
deterioration, loss or injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions. Items subject to wear and
tear, such as filters, bags, accessories and
drive belts, are not covered by this
warranty.The guarantee excludes
breakages and consumables.
When you turn the vacuum cleaner on
and commence vacuuming a Fresh scent
will be released in the air.Three scent
balls in each canister will last
approximately six months. A bag of scent
ball is enclosed for your perusal.
Care and Maintenance
Always switch appliance off, then switch
off at the power outlet and then unplug
the appliance prior cleaning or replacing
either filter.
This warranty is void if there is evidence
of the product being tampered with by
unauthorised persons.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never
use an abrasive cleaner.
If the product includes one or a number of
accessories only the defective accessory
or product will be replaced.
Note: Cleaning of building and industrial
material will not be covered by warranty.
In Australia, this KAMBROOK Guarantee
is additional to the conditions and
guarantees which are mandatory as
implied by the Trade Practices Act 1974
and State Territory legislation.
For service, spare parts or product
information in Australia, please call
KAMBROOK on the customer Service
Line (free call) 1800 800 634.
For service, spare parts or product
information in New Zealand,
please call KAMBROOK New Zealand,
Greenmount, Auckland Phone 09 271 3980
Fax 0800 288 513. For spare parts phone
09 271 3980.
If claiming under this guarantee the product
must be returned to freight prepaid.
YOUR PURCHASE RECORD (Please complete)
Check and replace both the motor
protection and dust filters on a regular
basis.
Attach a copy of
purchase receipt here.
DATE OF PURCHASE______________________________________________________
MODEL NUMBER ________________________________________________________
SERIAL NUMBER (If applicable) ______________________________________________
Please don’t return purchase record
unless you are making a claim
PURCHASED FROM ______________________________________________________
6
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising