Jaguar Twister Bagless
Vacuum Cleaner
KBV50
KBV50.indd 1
Issue 1/07
9/5/07 11:42:15 AM
Kambrook Safety
vacuum up acids, asbestos or asbestos
dust.
Read all instructions
before operating
and save for future
reference
This vacuum cleaner is not intended
for use by young children or infirm
persons unless they have been adequately
supervised by a responsible person to
ensure that they can use the vacuum
cleaner safely.
Welcome to Kambrook and your new
Jaguar Twister Bagless Vacuum Cleaner.
At Kambrook we believe that the safe
performance of our products is the first
priority in any consumer product so that
you, our valued customer, can confidently
use and trust our products.
3
2
1
Do not leave the vacuum cleaner
unattended when in use. Young children
should be supervised to ensure that they
do not play with the vacuum cleaner.
Close supervision is required at all times
when operating the vacuum cleaner near
children.
We ask that any electrical appliance that
you use be operated in a sensible fashion
with due care and attention placed on the
following important operating instructions:
This vacuum cleaner is suitable for
domestic use only. Do not use this
vacuum cleaner for anything other than its
intended use.
Read all instructions thoroughly before
activating the appliance and retain them
for future reference.
Do not use or store outdoors.
Ensure that the power source to be used
is the same as the voltage requirements of
the product.
Fully extend the cord (to the red tape
mark) whenever the vacuum cleaner is in
use.
Always switch vacuum cleaner to off, then
switch off at the power outlet, then unplug
the vacuum cleaner when not in use and
prior to cleaning the dust container or
filters.
The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.
Never use the vacuum cleaner without a
dust container and motor protection filter
in place.
Never use the vacuum cleaner to vacuum
hot ashes, broken glass, sharp objects or
liquids.
Regularly inspect the supply cord, plug
and actual appliance for any damage. If
found damaged in any way, immediately
cease use of the appliance and return the
entire appliance to the nearest authorised
Kambrook service centre for examination,
and/or repair.
Never use in the presence of explosive
liquids or vapours.
Never vacuum up inflammable or
poisonous liquids such as petrol, copier
toner or other volatile substances. Never
KBV50.indd 2-3
FEATURES OF YOUR Kambrook
Jaguar Twister Bagless Vacuum Cleaner
4
7
5
6
particles at 98% efficiency. Ideal for
allergy sufferers
1. Bagless canister for easy removal
of dirt and dust with no need for
replacement bags
5. Quality multi-terrain floor tool ideal for
carpet and hard floors
2.Horizontal parking for easy and
convenient storage
3. Powerful 1800 watt motor for superior
suction and fast and effective cleaning
6. Crevice and brush tools ideal for
picking up dust from hard to
reach places
4. 6 stage HEPA filtration system filters
dust particles including mites, pollen,
fungus, spores and most air suspended
7. Telescopic chrome steel wand is easily
extendable or retractable for varying
height requirements
9/5/07 11:42:19 AM
Using Your Kambrook
Jaguar Vacuum Cleaner
ALWAYS ENSURE THAT THE
DUST CONTAINER AND THE
MOTOR PROTECTION FILTER
ARE CORRECTLY FITTED. NEVER
OPERATE WITHOUT THE DUST
CONTAINER AND FILTERS IN
PLACE.
When unpacking the vacuum cleaner unit
check to see you have received all the
required components, such as the hose
and other accessories before discarding
the packaging.
Turn off the vacuum cleaner when
changing any attachments.
IMPORTANT: DO NOT USE THE UNIT
WITHOUT A DUST CONTAINER IN
PLACE
Dust container indicator
and dispensing the dust
container
Cleaning and replacing
filters
Filters must
fromdown
time to time
on/offbe cleaned
cord
up
to remove the fine dust particles that have
been collected.
Variable Power Control
Ensure that the dust container and filters
are correctly fitted.
The power booster dial on the unit is to
be used for variable power control. Turn
the control clockwise for maximum power
for vacuuming hard floor and carpet
surfaces. Turn the control anti-clockwise
for minimum power when using the
crevice and brush tools.
Locate the crush proof hose and push
the connection point into the hose inlet
connection on the front side of the unit,
until a “click” sound is heard.
Connect the wide end of the metal wand
to the hose end, and push together firmly.
1.Removepress
the dust container from the unit & lift down on the “Press and Lift” by pressing
button
The dust container should be emptied
when the dust and dirt reaches the MAX
level.
Always switch the appliance off, then
switch off at the power outlet and unplug
the appliance prior to replacing
filtersupor
on/off
cord
emptying the dust container.
Fit the floor tool to the narrow end of the
wand and push together firmly.
Fully extend the power cord by pulling
the power plug (situated at the rear of the
unit) out from the unit, until the yellow
tape on the cord is shown.
ENSURE THAT YOU DO NOT OVER
EXTEND THE POWER CORD - DO
NOT EXTEND PAST THE RED
WARNING TAPE ON THE CORD
Crevice and brush tool
accessories
2.Then press the “Push to Empty” button. The bottom of the container will release. Take off the filter bracket by holding onto the shaft and turning the filter in an anti-clockwise direction and the filter and its bracket will be released.
down
3.To remove the metal filter bracket, simply lift it vertically. The filter bracket can be rinsed in luke warm water. Ensure you let the filter bracket completely dry naturally before next use.
To remove the dust container, ensure the
unit is down on its wheels;
press Remove the
& lift down on the
dust container by pressing
“Press and Lift” button on the dust
container. Once released slowly pull the
container upwards.
4.Shake and tap the HEPA filter until
all the fine dust particles are removed.
However, after approximately 6 months
the HEPA filter should be replaced.
Plug into a 230/240v power point and
switch the power on.
on/off
cord
To commence vacuuming
push up
downdown
on
the on/off button at the top of the unit.
When vacuuming is complete, push down
press to switch off. Turn
on the ‘on/off’ button
& lift
the power off at the
outlet and then
remove the power cord from the power
outlet. When removing plug from the
power outlet grasp the plug not the cord.
The crevice tool is ideal for vacuuming
hard to reach places such as the edges
along skirting boards.
To empty the dust container simply place
it above the rubbish bin; press the “push
to empty” button. The bottom of the
container will release and the dust and
compiled dirt will be dispensed.
6.Simply place the filter unit in the dust container lid and turn the filter unit in a clockwise direction until it is clicked in place. Close the bottom of the container.
The brush tools can be used to vacuum
delicate surfaces and areas such as shelves
and venetian blinds.
on/off the
cord
up
down on the
To retract
cord push
down
‘cord rewind’
to retract the cord.
IMPORTANT: HOLD THE PLUG END
WHENpress
RETRACTING THE CORD TO
PREVENT
& lift IT FROM STRIKING YOU OR
THE VACUUM.
7.Place the dust container back in the vacuum cleaner for next use.
Set the variable speed control between
minimum and medium power when using
the tool accessories.
KBV50.indd 4-5
5.To place the filter back in the dust container simply place the metal filter
bracket directly over the HEPA filter,
ensure that the metal filter holder is completely dry before use. Ensure that the grooves on the HEPA filter holder and metal filter bracket fit into place.
9/5/07 11:42:25 AM
Motor protection filter
Notes
Notes
The motor protection filter must always
be in place when operating the vacuum
otherwise damage to the motor may
occur.
To replace the motor protection filter
- remove the dust container. The motor
protection filter is located at the bottom
of the inner chamber. Pull the filter
upward to remove then simply replace the
new filter.
Exhaust filter
The exhaust filter should be cleaned every
six months. Simply unclip the grill at the
back of the vacuum cleaner and shake
and tap the filter to remove any dust
accumulated. Then relocate the filter and
reattach the grill.
Care and Maintenance
Always switch appliance off, then switch
off at the power outlet and unplug the
appliance prior to cleaning or replacing
either filter.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never
use an abrasive cleaner.
Check and replace both
the motor protection
and HEPA filters
approximately twice
a year or when visibly
clogged.
KBV50.indd 6-7
9/5/07 11:42:25 AM
KAMBROOK 12 MONTH REPLACEMENT WARRANTY
If the product includes one or a number of
accessories only the defective accessory
or product will be replaced. In the event of
Kambrook choosing to replace the appliance,
the guarantee will expire at the original
date, i.e. 12 months from the original date of
purchase.
Kambrook warrants the purchaser against
defects in workmanship and material for a
period of 12 months from the date of purchase
(3 months commercial use).
Guarantee and purchase receipt for this
product are to be retained as proof of
purchase and must be presented if making a
claim under the Kambrook guarantee.
In Australia, this KAMBROOK Guarantee is
additional to the conditions and guarantees
which are mandatory as implied by the Trade
Practises Act 1974 and State and Territory
legislation.
Kambrook reserves the right to replace or
repair the appliance within the warranty
period,
Warranty does not apply to any defect,
deterioration, loss, injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions. The guarantee excludes breakages
and consumable items such as kneading blades.
For service, spare parts or product information
in Australia, please call KAMBROOK on the
Customer Service Line; 1300 139 798.
For service, spare parts or product information
in New Zealand, please call KAMBROOK New
Zealand; 0800 273 845. For spare parts phone
0800 273 845.
This warranty is void if there is evidence of the
product being tampered with by unauthorised
persons.
If claiming this guarantee the product must be
returned freight prepaid.
KAMBROOK 12 MONTH REPLACEMENT WARRANTY
YOUR PURCHASE RECORD (Please complete)
Attach a copy of the purchase receipt here.
DATE OF PURCHASE ___________________
MODEL NUMBER ______________________
SERIAL NUMBER ______________________
PURCHASED FROM ____________________
(Please don’t return purchase record until
you are making a claim)
Register your warranty at www.kambrook.com.au/service.asp
Kambrook - Australia
461 Plummer Street, Port Melbourne, 3207, Australia
Customer Service Line 1300 139 798
Customer Service Fax 1800 621337
Kambrook - New Zealand
Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 271 3980
Customer Service Fax 0800 288 513
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the illustration in this book. Issue 1/07
KBV50.indd 8
9/5/07 11:42:26 AM
">