PLN-100 series
040-02-409-081-EH-0309.pdf
040-02-409-081-EH-0309
PLN-100
100W Single Output Switching Power Supply
series
Features :
Universal AC input / Full range
Protections: Short circuit / Overload / Over voltage / Over temperature
Built-in active PFC function
IP64 design for indoor or outdoor installations
UL1310 Class 2 power unit
Cooling by free air convection
100% full load burn-in test
High reliability
Suitable for LED lighting and moving sign applications
2 years warranty
110
F
M
EQUIVALENT
MODEL
DC VOLTAGE
PLN-100-15
PLN-100-20
PLN-100-24
PLN-100-27
PLN-100-36
PLN-100-48
15V
20V
24V
27V
36V
48V
7.5 ~ 15V
10 ~ 20V
12 ~ 24V
13.5 ~ 27V
18 ~ 36V
24 ~ 48V
4.8A
4A
3.55A
2.65A
2A
CURRENT RANGE
Note.6 0 ~ 5A
0 ~ 5A
0 ~ 4.8A
0 ~ 4A
0 ~ 3.55A
0 ~ 2.65A
0 ~ 2A
RATED POWER
Note.6 60W
75W
96W
96W
95.85W
95.4W
96W
150mVp-p
150mVp-p
150mVp-p
150mVp-p
150mVp-p
200mVp-p
VOLTAGE ADJ. RANGE
0% ~ -15%. Can be adjusted by internal potential meter SVR1
CURRENT ADJ. RANGE
3% ~ -25%. Can be adjusted by internal potential meter SVR2
VOLTAGE TOLERANCE Note.3
3.0%
LINE REGULATION
1.0%
VOLTAGE RANGE
3.0%
3.0%
2.0%
2.0%
60ms/230VAC 30ms/115VAC at full load
Note.5 90 ~ 264VAC
127 ~ 370VDC
FREQUENCY RANGE
47 ~ 63Hz
POWER FACTOR (Typ.)
PF>0.95/230VAC
EFFICIENCY (Typ.)
83%
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
12V:0.8A/115VAC 0.4A/230VAC
COLD START 40A/230VAC
OVER CURRENT
3.0%
2.0%
PF>0.95/115VAC at full load
85%
87%
87%
15V:0.9A/115VAC
87%
0.45A/230VAC
87%
20V ~ 48V:1.1A/115VAC
87%
0.55A/230VAC
0.5mA / 240VAC
LEAKAGE CURRENT
Note.4
PROTECTION OVER VOLTAGE
OVER TEMPERATURE
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
SAFETY STANDARDS
WITHSTAND VOLTAGE
95 ~ 100%
Protection type : Constant current limiting, recovers automatically after fault condition is removed
13 ~ 16V
16.5 ~ 20V
22 ~ 27V
27 ~ 34V
29 ~ 36V
39 ~ 48V
52 ~ 64V
Protection type : Shut down and latch off o/p voltage, re-power on to recover
90
10
(RTH2)
Protection type : Shut down o/p voltage, re-power on to recover
-30 ~ +50
(Refer to output load derating curve)
20 ~ 90% RH non-condensing
-40 ~ +80
0.03%/
, 10 ~ 95% RH
(0 ~ 50
)
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
UL1310 Class 2, UL879 ( listed in UL Sign Components Manual (SAM) ), TUV EN60950-1, EN61347-1, EN61347-2-13
CAN/CSA C22.2 No. 223-M91(except for 48V), IP64 approved
I/P-O/P:4.25KVDC
ISOLATION RESISTANCE
I/P-O/P:100M Ohms / 500VDC / 25 / 70% RH
EMI CONDUCTION & RADIATION Compliance to EN55015, EN55022 (CISPR22) Class B
HARMONIC CURRENT
Compliance to EN61000-3-2 Class C (>50% load) ; EN61000-3-3
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN61547, EN55024, light industry level, criteria A
EMS IMMUNITY
MTBF
303.1Khrs min. MIL-HDBK-217F (25 )
DIMENSION
PACKING
NOTE
3.0%
1200ms, 80ms/230VAC 1200ms, 80ms/115VAC at full load
HOLD UP TIME (Typ.)
OTHERS
IP64
5A
SETUP, RISE TIME
EMC
( except for 48V )
Note.6 5A
LOAD REGULATION
SAFETY &
( for 48V only)
PLN-100-12
RIPPLE & NOISE (max.) Note.2 150mVp-p
INPUT
LPS
12V
CONSTANT CURRENT REGION Note.7 6 ~ 12V
RATED CURRENT
OUTPUT
SELV
M
SPECIFICATION
200*70.5*35mm (L*W*H)
0.52Kg; 20pcs/11.4Kg/0.76CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Please refer to OLP characteristics.
5. Derating may be needed under low input voltage. Please check the derating curve for more details.
6. This is the maximum possible output current and power. Over load protection may be activated slightly below this level to comply with the requirement
of UL1310 class 2.
7. Constant current operation region is within 50% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please
reconfirm special electrical requirements for some specific system design.
File Name:PLN-100-SPEC 2008-08-18
040-02-409-081-EH-0309.pdf
040-02-409-081-EH-0309
PLN-100
100W Single Output Switching Power Supply
Mechanical Specification
Case No.955A
series
Unit:mm
200
22.84
6.26
2-R2.5
+V(Red)
-V(Black)
18AWG 2C
22.84
18AWG 3C
310 10
DC OUT
AC IN
AC/L(Brown)
AC/N(Blue)
FG (Greed/Yellow)
70.5
310 10
35
6.26
Output voltage and current adjustment : remove the upper case and adjust through SVR1 & SVR2
shown in the diagram.
SVR1
SVR2
SVR1 Output voltage adjustment
SVR2 Output current adjustment
Fosc : 100KHz
Block Diagram
EMI FILTER
&
RECTIFIERS
I/P
POWER
SWITCHING
PFC
CIRCUIT
RECTIFIERS
&
FILTER
+V
-V
O.L.P.
FG
O.L.P.
PFC
CONTROL
DETECTION
CIRCUIT
PWM & PFC
CONTROL
O.V.P.
Derating Curve
Static Characteristics
Ta=25
100
100
90
80
80
70
LOAD (%)
LOAD (%)
60
40
20
-30
-15
-5
0
15
30
40
AMBIENT TEMPERATURE ( )
50 (HORIZONTAL)
60
50
40
90
100
125
135
145
155 165
175
180
200
230
264
INPUT VOLTAGE (V) 60Hz
File Name:PLN-100-SPEC 2008-08-18
Headquarter Switzerland:
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Phone +41 44 877 35 00
[email protected]
Office Germany:
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Phone +49 89 260 38 47
[email protected]
We are here for you. Addresses and Contacts.
Sales Switzerland & Liechtenstein
Sales International Key Accounts
Postcode 3000 – 9999
Postcode 1000 – 2999
Basil Frei
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Eric Letsch
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Peter Felder
Pewatron AG
Thurgauerstrasse 66
CH-8052 Zurich
Phone + 41 44 877 35 18
Mobile + 41 76 279 37 26
Phone + 41 44 877 35 14
Mobile + 41 76 491 66 70
Phone + 41 44 877 35 05
Mobile + 41 79 406 49 83
[email protected]
[email protected]
[email protected]
Sales Germany
Postcode 00000 – 31999
Postcode 38000 – 39999
Postcode 80000 – 99999
Postcode 32000 – 37999
Postcode 40000 – 79999
Sales Austria
Kurt Stritzelberger
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Gerhard Vetter
Pewatron AG
Fürstenbergstraße 12
D-55422 Bacharach-Medenscheid
Kurt Stritzelberger
Pewatron AG
Neumarkter Straße 86a
D-81673 Munich
Phone + 49 89 260 52 80
Mobile + 49 171 803 41 35
Phone + 49 674 394 75 75
Mobile + 49 163 762 74 30
Phone + 49 89 260 52 80
Mobile + 49 171 803 41 35
[email protected]
[email protected]
[email protected]
Pressure Sensors
Gas sensors / Gas sensor modules
Load cells
Linear position sensors
Angle sensors
Philipp Kistler
Phone + 41 44 877 35 03
[email protected]
Thomas Clausen
Phone + 41 44 877 35 13
[email protected]
Eric Letsch
Phone + 41 44 877 35 14
[email protected]
Accelerometers
Power supplies
Current sensors
Eric Letsch
Phone + 41 44 877 35 14
[email protected]
Sebastiano Leggio
Phone + 41 44 877 35 06
[email protected]
Sebastiano Leggio
Phone + 41 44 877 35 06
[email protected]
Drive technology
CH Postcode 5000 – 9999 / DE
Drive technology
CH Postcode 1000 – 4999 / AT / IT / FR
Roman Homa
Mobile + 41 79 444 00 86
[email protected]
Christian Mohrenstecher
Mobile +41 76 444 57 93
[email protected]
Sales Other Countries / Product Management
Competitive sensor & power supply solutions worldwide
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement