DeLonghi | DEVINTAGE90BK | Delonghi DELPREMIUMPK Cooking Package User Manual

Delonghi DELPREMIUMPK Cooking Package User Manual
EN
Manual for the installation, use and maintenance of decorative hoods
A
B
C
D
E
F
3
x.
mamm
13
5
2
4
1
3
P1
2
4
1
1
2
3
2
3
4
2
5
2
6
2
7
P2
6
P3
1
2
3
4
5
P4
7
8
IMPORTANT
Never leave frying food unattended since grease can overheat and catch fire. The risk offire is even greater in the case of used oil.
Never use the hood in areas where devices with exhaust pipes connected to the outsideare already operating unless perfect ventilation can be guaranteed.
To avoid the possibility of fire, adhere strictly to all of the recommendations included hereand to the periodic cleaning of the grease filters.
I
The appliance is not intended for use by young children or infirm persons withoutsupervision.
II
Young children should be supervised to ensure that they do not play with the
appliance.
III
Exhaust air must not be discharged into a flue which is used for exhausting fumes from
appliances burning gas or other fuels.
IV
V
VI
Applicable regulations concerning the discharge of exhaust air have to be fulfilled.
If the supply cord of this equipment is damaged, it must only be replaced by theman
ufacturer or its service agent or similarly qualified person in order to avoid a hazard.
No food must be flambé underneath the hood.
In the unlikely event of a breakdown, you will have access to professional help fromDe’Longhi
by simply calling this number:
Australia: 1800 126 659
New Zealand: 0508 200 300
9
EN
Four-speed panel - Digital display (Fig. P2)
DECORATIVE EXTRACTOR HOOD
1- Lighting on and off.
2- Extractor fan on and off.
3- Decrease extractor fan speed.
Dear Customer,
4- Extractor fan speed display panel.
Thank you for buying our hood. Please read these instructions carefully for its
optimum installation, use and maintenance.
5- Increase extractor fan speed.
6- Enable extractor fan turbo speed.
Notes: The figures mentioned in this manual are in the first pages.
Hood installation on walls (look for the symbol in
7- Enable and disable extractor fan timer.
the figures)
Timer: the extractor fan works for 5 min. at the current speed and another 5 min.
at each of the lower speeds until it stops and the lighting switches off.
Warning: consult local regulations regarding fumes outlets. Do not
connect the hood to a fume, ventilation or hot air duct. Confirm that
room ventilation is appropriate with the local authorities. Make sure
the maximum air extraction flow rate for the appliances in the room does
not exceed 4 Pa (0.04 mbar).The room must have adequate ventilation if an
extractor hood is used simultaneously with appliances that run on gas or other
fuels. The evacuated air must be extracted through ducts that are used for
evacuating fumes from appliances that run on gas or other fuels. Regulations
regarding air extraction must be complied with.
Touch panel (Fig. P3)
1- Filter clean warning display/button. Warning of the need to replace the
filter – press to deactivate once the filter has been cleaned or replaced.
2- Enable and disable extractor fan timer.
3- Lighting on and off. Keep pressed down to adjust the lighting intensity.
4- Extractor fan on and off.
Use a rigid PVC pipe with a min. Ø l20 mm to evacuate fumes outside.
5- Extractor fan speed - button: speed 1, 2 and 3/4
The above restrictions do not apply to hoods with no fumes outlet to outside
(recirculation system with activated charcoal filter).
Install the hood in line with the instructions on the template
hood in line with the instructions on the template
Timer: the extractor fan works for 5 min. at the current speed and another 5
min. at each of the lower speeds until it stops.
Install the
provided.
Sliding touch panel (Fig. P4)
For gas cooking appliances only: the minimum distance to the hood must be
at least 65 cm.
1- Extractor fan on and off.
2- Sliding touch panel for extractor fan speed control. Also used in combination
with button -3-.
Warning: Failure to install the screws or fixing device in accordance with
these instructions may result in electrical hazards.
3- Lighting on and off. Press the button and, while it is flashing, adjust the
lighting intensity using the sliding touch panel -2-.
4- Enable and disable extractor fan timer.
Connecting the hood to the grid
5- Filter clean warning display/button. Warning of the need to replace the
filter – press to deactivate once the filter has been cleaned or replaced.
Warning: before connecting the hood: switch off the electricity supply
and check that the supplied voltage and frequency coincide with that
indicated on the appliance nameplate.
Timer: the extractor fan works for 2 min. at the current speed and another 2 min.
at each of the lower speeds until it stops and the lighting switches off.
If the extractor hood has a plug, connect it to a power socket in line with
applicable regulations, located in an accessible area.
Hood maintenance
If the hood does not have a plug, connect it directly to the electrical grid,
protected by a separator device accessible for disconnection, in line with local
regulations.
Warning: always switch off the electricity supply before carrying out
maintenance work on the hood. In the event of a fault, contact an
official distributor or authorised dealer.
Use of the hood – Safety
Exterior cleaning: use non-corrosive, liquid detergent and avoid the use of
abrasive cleaning products.
Warning: the hood may stop working during an electrostatic discharge
(e. g. lightning). This involves no risk of damage. Switch off the electricity
supply to the hood and reconnect after one minute.
Grease filters: to avoid fires, clean thoroughly once a month or whenever the
display pilot light indicates as such. To do so, remove the filters and wash with
hot water and detergent. If using a dishwasher, position the filters vertically to
prevent solid remains from depositing on them.
Do not allow the hood to be used by children or persons with reduced
(physical, sensory or mental) capabilities or lack of experience and knowledge,
unless they have been given instruction concerning use of the appliance by a
person responsible for their safety.
Activated charcoal filters: replace the every 3 months.
Important: increase the filter cleaning/replacement frequency if the hood
is used for more than 2 hours a day. Always use genuine filters from the
manufacturer.
Children should be supervised so that they do not play with the appliance.
To avoid the risk of fire, clean the metal filter regularly, permanently control
pans containing hot oil and do not flambé food underneath the hood.
Do not use the hood if it shows signs of damage or imperfection. Contact an
official distributor or authorised dealer.
Bulb replacement (look for the
Important: use new bulbs according to that indicated on the hood
nameplate.
electrical hazards.
Accessible parts may heat up when using cooking appliances.
Use of the hood - Control panel (look for the
symbol in the figures)
Warning: do not handle
the bulbs until the electricity supply has
been switched off and they have cooled.
Warning: Failure to install the screws in accordance with the installation
instructions may result in
Use bulbs with an aluminium reflector to replace halogen bulbs. Do not use
dichroic bulbs - risk of overheating.
symbol in the figures)
The different control panels are described below. Check the panel model
installed on your hood and see the figure indicated in each case.
Legal information
The manufacturer:
Panel with electronic button (Fig. P1)
- Declares that this product meets all basic requirements regarding low-voltage
electrical equipment established in Directive 2006/95/EC of 12 December 2006
and electro-magnetic compatibility established in Directive 2004/108/EC of 15
December 2004.
1- Lighting on and off.
2- Lighting operating control pilot light.
3- Extractor fan speed - button: speed 1, 2 and 3 Press the current speed again
to switch off the extractor fan.
- Is not responsible for any failure to observe the instructions given in this manual
and current safety regulations for the correct use of the equipment.
4- Extractor fan operating speed control pilot light.
- R eserves the right to make any modifications to the equipment or this manual
without prior notice.
Timer: keep the chosen speed button pressed down for two seconds until the
display flashes. The extractor fan stops after 15 min. and the lighting switches
off. To cancel the timer: press the chosen speed button once.
Contact our official distributor should you require technical assistance or
additional information on our products.
10
60806120.19.06.2013
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising