VX-VEB160R1 Quick Start

Quick Installation
VX-VEB160R1 Quick Start
VDSL2 (Proﬁle 30a) Industrial Ethernet Extender
+─
2
2
DIP1
DIP2
DIP3
DIP4
Side
VDSL2Proﬁle
RateLimit
SNR
OFF
OT
30a
Symmetric
9dB
ON
RT
17a
Asymmetric
6dB
LEDs for VDSL2
LED
PWR
(Green)
LNK
(Green)
Description：
DIP 1：
Slow:Idle
Fast:Training/
DataTransmiNng
RT
(Green)
OT：LAN Extender acts as the Source (OT)
RT：LAN Extender acts as the Destination (RT)
ON
OFF
DevicePower
ON
DevicePower
OFF
LinkUp
LinkDown
RT
OT
LEDs for LAN
DIP 2：
30a：VDSL2 High Speed Mode.
17a：VDSL2 Long Reach Mode.
DIP 3：
Symmetric：Support the band plan G.997 and provides symmetric
transmission on both downstream and upstream.
Asymmetric：Provides highest line rate to short ranges in asymmetric
mode.
DIP 4：
Blink
LED
Blink
ON
OFF
LNK
(Green)
AcRvity
LinkUp
LinkDown
FUL
(Green)
FullDuplex
HalfDuplex
SP
(Green)
100Mbps
10Mbps
9dB：Better channel noise protection with SNR up to 9 dB.
6dB：Original channel noise protection with 6 dB SNR.
** Power supply:
12 VDC in over terminal block . (External Power Adaptor included)
STEP 1：
Set the LAN extender to OT mode or RT
mode from the DIP switch at the front
panel. For Point to Point applications,
one unit must be set to the Source (OT)
and the other one to the Destination
(RT mode).
STEP 2：
Connect the LAN extender (RT) with a
regular Cat. 5 cable to the LAN port
from a PC or another device on LAN. STEP 3：
Power on LAN extender (RT) by
connecting the power adapter.
STEP 4：
Connect the RT and OT via a regular
Cat. 5 cable or a telephone wire using
each VDSL2 port.
STEP 5：
Connect the LAN extender (OT) with a
regular Cat. 5 cable to the LAN port and
then connect the other end of the RJ45
cable to the service equipment. STEP 6：
Power on LAN extender (RT) by
connecting the power adapter and
observe the status of VDSL2 link LED.
Setting as OT side
Setting as RT side

Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project