Read Me First - Transition Networks

Read Me First - Transition Networks
Read Me First
MIL-SM8DPA Packing List:
Before you start installing MIL-SM8DPA Managed Switch, please verify that the package
contains the following items:




6-Port 100/1000 Dual Speed SFP + 2-Port RJ-45/ 100/1000SFP Managed Switch
AC Power Cord
User’s Guide CD-ROM
RJ-45 Transform RS-232 Cable
Please notify your sales representative immediately if any of the aforementioned items is
missing or damaged.
Power Requirements:
Voltage
Frequency
Consumption
AC Line
:
:
:
100240 VAC
5060 Hz
40W
Quick Installation:
1. Install the switch in the rack with mounting accessory.
2. Connect the MIL-SM8DPA switch to an AC power source.
3. The port 1–8 connector is LC SFP on the switch. Use Single-mode or Multi-mode Fiber
cable to connect between MIL-SM8DPA and end station.
4. The port 7, 8 includes two types of media --- TP and (100/1000M) SFP fiber module; they
support TP or fiber with auto-detected function.
5. Use RJ-45 interface to pre-configure MIL-SM8DPA for network management.
For example: IP address, VLAN, Port Trucking, STP, etc.
MIL-SM8DPA switch’s serial port default settings are listed as follows:
Baud rate
115,200
Stop bits
1
Data bits
8
Parity
N
Flow control
none
The default values of MIL-SM8DPA switch are as follows:
IP Address
: 192.168.1.77
Subnet Mask
: 255.255.255.0
Default Gateway
: 192.168.1.254
Username
: admin
Password
: root
User also can use telnet or web to pre-configure MIL-SM8DPA with the default IP
address and username/password in the first configuration. Please refer to User’s Guide
contained in CD-ROM for details on the setting of parameters. MIL-SM8DPA user’s
manual is filed under the path: \manual of the CD-ROM.
MIL-SM8DPA ReadMe First
Warning:







Self-demolition on Product is strictly prohibited. Damage caused by self-demolition will
be charged for repairing fees.
Do not place product at outdoor or sandstorm.
Before installation, please make sure input power supply and product specifications are
compatible to each other.
The SSL only provide the CLI for switch management and SSH default
enable without UI for management.
The TACACS+ feature for management authentication purpose.
Before importing / exporting configuration please make sure the firmware
version is always the same.
After firmware upgrade, the switch will remove the configuration
automatically to latest firmware version.
10900 Red Circle Drive
Minnetonka, MN 55344
Tel.: +1.952.941.7600
techsupport@transition.com
Date: March 2011
Revision A0
2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising