activePDF WebGrabber - Appliances Connection
Smart Pro XL Medical Grade UPS System
Intelligent, line-interactive power management system
Model #: SMART1200XLHG
UL 60601-1 listed
Isolated 1000VA line interactive UPS system with less than 300 microamps leakage current
Hospital-grade plug and 4 hospital-grade NEMA5-15R output receptacles
Corrects brownouts and overvoltages from 81V to 143V
Enhanced communications ports (1 USB, 1 DB9)
Expandable runtime with optional BP36V27 battery pack
DESCRIPTION
Tripp Lite's SMART 1200XLHG offers medical-grade UPS protection with built-in line-interactive voltage regulation, expandable battery
runtime and intelligent monitoring with unattended shutdown capability. UL 60601-1 listed as medical electrical equipment with less than 300
microamps leakage current for the UPS and all connected equipment. Built-in isolation transformer with Faraday shield offers full line isolation
and removes common mode noise while maintaining full AC surge suppression in all modes. Includes high quality hospital-grade plug and
outlets. Resistant to electrostatic discharge. 1000VA power handling capacity supports computers, internetworking equipment and other
critical loads during commercial power failures. External battery connector allows configuration for up to several hours of runtime during power
failures by adding one or more external battery packs (part# BP36V27). Line interactive voltage regulation corrects brownouts as low as 81V
and overvoltages as high as 143V back to normal 120V levels, saving battery reserves for use only during complete power failures. Includes
diagnostic LEDs and 2 built-in communications ports (1 USB, 1 DB9) that work with included PowerAlert Software and cabling to provide
automatic unattended shutdown of connected network and PC applications.
KEY BUYING POINTS
Ideal UPS protection for applications in medical patient-care areas where UL 60601-1 listed medical electrical equipment is required
Maintains less than 300 microamps leakage current for UPS and all connected equipment
Built-in isolation transformer with faraday shield offers full isolation and removes common mode noise while maintaining full AC surge
suppression in all modes
Provides connected equipment with continuous power during short and long duration loss of commercial power
Expandable runtime is available with the addition of one or more external battery packs (part# BP36V27)
Line-interactive voltage regulation corrects brownouts and overvoltages from 81 to 143 volts back to usable 120V output levels, without
using battery power
Hospital-grade plug and outlets offer added degree of safety and reliability to input/output connections
Full line isolation prevents shock potential and operational problems in sensitive electronic equipment
Resistant to electrostatic discharge
Supports loads up to 1000VA/750W
34 min. half-load runtime (500VA/375W), 16 min. full load runtime (1000VA/750W)
4 protected hospital-grade outlets; 6-ft. cord
USB and DB9 communication ports
PowerAlert unattended shutdown software and complete cabling included
Complete surge protection, line isolation and EMI/RFI noise filtering
5 diagnostic LEDs indicate AC present, on battery, voltage correction, overload & battery low/replace
Battery replacement door and back panel grounding lug
2-year product warranty
TYPICAL APPLICATIONS
UL 60601-1 listed UPS provides ultimate safety and reliability for patient point of care solutions, telemedicine, nurse's stations, wireless
communications systems, electronic prescribing applications, medical imaging and mission critical equipment. Not recommended for
life support applications.
OPTIONS & ACCESSORIES
External battery pack: BP36V27
Wallmount Bracket: UPSWM
Dataline protectors: DNET1, DTEL2, DCATV
Extended warranties: 3 Year WEXT3-500-1500, 5 Year WEXT5-500-1500
PACKAGE INCLUDES
SMART 1200XLHG Medical Grade Tower UPS System
PowerAlert Software and cabling
Warranty information
Instruction manual
COMPLETE SPECIFICATIONS
SYSTEM OVERVIEW
System overview:
Medical Grade tower UPS system includes built in isolation transformer with faraday shield,
line interactive voltage regulation. AC surge suppression, RS-232 & USB monitoring ports
with complete software and cabling, plus hospital-grade plug and outlets. Runtime is
expandable via separate purchase BP36V27 external battery packs. UL 60601-1 listed as
medical electrical equipment with less than 300 microamps combined leakage current for
UPS and connected loads.
Voltage compatibility:
120V AC
Frequency compatibility:
60 Hz
OUTPUT
Output volt amp capacity (VA):
1000
Output watt capacity (watts):
750
Output nominal voltage:
120V AC
Output voltage regulation:
LINE MODE: Sine wave line voltage 120V (-18% / +8%)
BATTERY MODE: PWM sine wave output 115V +/-5%
Output frequency regulation:
LINE MODE: Passes line frequency of 60Hz +/-10%
BATTERY MODE: Inverter output regulated to 60Hz +/-0.5Hz
Outlet quantity / type:
4 NEMA 5-15R HG
Overload protection:
Resettable circuit breaker
INPUT
Maximum input amps:
9.2A / 860 watts
Input connection type:
NEMA 5-15P HG
Input cord length:
6 ft., 14 gauge
Recommended electrical service:
15A 120V
BATTERY
Full load runtime:
16 min. (1000VA)
Half load runtime:
34 min. (500VA)
Expandable battery runtime:
Supports extended runtime with optional BP36V27 external battery pack (multi-pack
compatible)
DC system voltage:
36V DC
Typical battery lifespan:
3-6 years, depending on usage
Battery recharge rate:
2-4 hours to 90%
VOLTAGE REGULATION
Voltage regulation description:
Line interactive UPS offers 2 boost levels of brownout correction and a single level of
overvoltage adjustment to maintain usable, computer grade output without consuming battery
power over an input voltage range of 81 to 143V AC.
Overvoltage correction:
Input voltages between 126 and 143V AC are reduced by 9%
Direct pass through:
Input voltages between 105 and 125V AC are passed through unchanged
Brownout correction:
Input voltages between 96 and 106V AC are boosted by 10%
Severe brownout correction:
Input voltages between 81 and 95V AC are boosted by 21%
LEDS ALARMS & SWITCHES
Front panel LEDs:
Yes, includes 5 front-panel indicator LEDs to show battery charge level, AC line voltage
levels, automatic voltage regulation status, UPS load level and replace battery warning
Alarms:
3 function audible alarm indicates power failure conditions (4 short beeps every 10 seconds),
overload (continuous short beeps) and low battery (continuous tone)
Switches:
Yes, includes 2 front panel mounted push-button switches for system enable, self-test and
alarm cancel functions
SURGE / NOISE SUPPRESSION
AC surge suppression:
480 joules
AC suppression response time:
Instantaneous
EMI / RFI AC noise suppression:
Yes
PHYSICAL
Shipping weight (lbs):
49.2
Shipping weight (kg):
22.4
Unit weight (lbs):
45.2
Unit weight (kg):
20.5
Unit Dimensions (HWD/in):
12.5 x 7.5 x 9.5
Unit Dimensions (HWD/cm):
31.75 x 19.1 x 24.2
Shipping Dimensions (HWD/in):
18.25 x 11.75 x 13.5
Shipping Dimensions (HWD/cm):
46.4 x 29.9 x 34.3
Material of construction:
PVC
Form factors supported:
Tower
Cooling method:
UPS cooling via rear-exit fan
Battery Access:
Battery access door allows hot swap battery replacement without powering connected
equipment off
ENVIRONMENTAL
Operating Temperature:
+32 to +104 degrees Fahrenheit
0 to +40 degrees Celsius
Storage Temperature:
+5 to +122 degrees Fahrenheit
-15 to +50 degrees Celsius
Relative Humidity:
0 to 95%, non-condensing
COMMUNICATIONS
Network monitoring port:
Includes 2 built-in monitoring ports, 1 USB & 1 DB9
Software and cabling included:
PowerAlert UPS monitoring software is included on CD-ROM for all common network and
standalone operating systems. Ships with 2 cables, 1-USB to USB & 1-DB9 to DB9
LINE / BATTERY TRANSFER
Transfer time from line power to battery
mode:
2-4 milliseconds
Low voltage transfer to battery power:
81V (resets to line power as voltage increases to 85V)
High voltage transfer to battery power:
143V (resets to line power as voltage decreases to 139V)
CERTIFICATIONS
Certifications:
UL1778 (USA, Series AGSM1200PSR3HG), UL 60601-1 (Medical), cUL (Canada), Class A
(Emissions)
WARRANTY
Optional coverage:
3-year, 5-year, next day and on-site warranty coverage available in many areas; contact
Tripp Lite
Product warranty:
2 year product warranty
SPECIAL FEATURES
Cold Start:
Yes, inverter can be cold started to enable temporary AC output during a power failure
Appearance:
Attractive gray tower UPS
BATTERY PACK ACCESSORY (optional)
Battery Pack Accessory (optional):
BP36V27 (optional)
The policy of Tripp Lite is one of continuous improvement.
Specifications are subject to change without notice.
Therefore, your product may vary slightly from what is currently listed.
Tripp Lite World Headquarters
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support
(773) 869-1234
© 2006 Tripp Lite. All Rights Reserved.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising