KitchenAid | 311 | User's Manual | KitchenAid 311 User's Manual

®
HOME APPLIANCES
Installation Instructions and
Use and Care Guide
Kitchen Faucets
Model Series
KKFV01SP
Model Series
KKFV01LP
Model Series
KKFV01PP
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
FOR RESIDENTIAL USE ONLY.
IMPORTANT:
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
8559765A
INSTALLATION
REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
INSTALLATION
INSTRUCTIONS
1. Before installing the faucet, flush water supply pipes
thoroughly. Shut off water supply valves.
2. Remove nut, metal washer and rubber washer from faucet.
Do not remove rubber o-ring in bottom of faucet base.
Tools needed
■
■
■
■
A
Adjustable wrench
Slip joint pliers
#2 Phillips screwdriver
Basin wrench (optional)
B
C
Tools needed
Remove parts from carton. Check that all parts are included.
All models:
■ Faucet assembly
■ Plastic base
■ ⁵⁄₆₄" (2 mm) Allen wrench
Model series KKFV01SP & KKFV01PP:
■ Weights
■ Check valve assembly
– 2 fiber seals
A. Rubber washer
B. Metal washer
C. Nut
3. Feed tubing through hole in sink or countertop and then insert
faucet assembly into hole.
4. Reinstall the parts onto the threaded shank of the faucet in
the following order: rubber washer, plastic base, metal washer
and nut. Hand-tighten nut.
A
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ Check location where faucet will be installed. Proper
installation is your responsibility. Make sure you have
everything necessary for correct installation. It is the
responsibility of the installer to comply with installation
specifications and with state and local plumbing codes.
Protect faucet and water lines leading to faucet against
freezing. Damage from freezing is not covered by the warranty.
■ Faucet requires a 1³⁄₈" (3.5 cm) diameter opening in sink or
countertop. If hole is not available for mounting it is
recommended that a qualified installer be contacted to drill the
hole for your installation in a sink deck or countertop.
Thickness of sink or countertop hole must not exceed 1³⁄₄"
(4.4 cm).
■ Hot and cold water supply lines must be available and if they
are not it is recommended that a qualified plumber install the
necessary piping.
■ Faucet hoses are equipped with compression type seals and
do not require sealing compounds to prevent leaking.
■ As with all metal objects, follow proper handling techniques.
■ It is recommended that a qualified plumber/installer install the
faucet. The faucet installation must comply with national and
local plumbing codes and ordinances.
■ The faucet should be examined for damage prior to
installation. Do not install a damaged faucet. Instead, return
the faucet to the dealer from whom you purchased it. Failure
to do so will void the warranty.
2
B
C
D
A. Rubber washer
B. Plastic base
B. Metal washer
C. Nut
5. Align faucet and securely hand-tighten the nut to prevent
faucet base from turning when moving operating lever. For
Model series KKFV01SP and KKFV01PP, be sure the control
lever is pointed toward the right side of the sink.
6. Model series KKFV01SP and KKFV01PP only: Connect the
sprayer hose to the supply hose using the check valve
assembly and fiber seals. Be sure the check valve assembly
is positioned correctly; the arrow should be pointing down
away from the faucet. Insert a fiber seal between sprayer
hose and check valve assembly and attach them. Insert a
fiber seal between the check valve assembly and supply hose
and attach them.
OPERATION
full hot
full on
full cold
off
A
B
C
D
E
A. Supply hose
B. Fiber seal
C. Check valve
D. Fiber seal
E. Sprayer hose
7. Connect the red-striped braided hose to the hot water supply
valve. Connect the blue-striped braided hose to the cold
water supply valve. Be sure to hold the supply hoses in place
when tightening the nut to prevent the hoses from twisting.
8. Model series KKFV01SP and KKFV01PP only: Be sure the
sprayer hose is fully inserted into the faucet body. Under the
sink, use the screws provided to attach the weight(s) onto the
sprayer hose on the spout side of the hose loop, just above
the bend in the hose.
For model series KKFV01PP attach one weight.
For model series KKFV01SP attach both weights.
Model series KKFV01PP:
■ The flow of water can be a stream or spray. A stream is the
default water setting.
spray
■ Change to spray by pushing the diverter
button on top of the spray assembly.
■ Change to stream by shutting the faucet off.
The spray assembly automatically resets.
■ The spray assembly can be drawn
approximately 20 inches out of the faucet
spout.
Model series KKFV01SP:
■ The flow of water can be a stream or spray. A stream is the
default water setting.
■ Change to spray by pushing the large
diverter button on top of the spray
assembly.
spray
■ Change to stream by pushing the small
stream
diverter button just below the large
button or by shutting the faucet off.
■ The spray assembly can be drawn approximately 20 inches
out of the faucet spout.
Cleaning
A
B
A. Weight
B. Spray hose
9. Move the faucet lever to the closed (forward) position and
open supply valves. Check connections for leaks.
10. Remove aerator from faucet and flush the hot and cold lines
until water is clear.
The aerator is in the end of the faucet. Loosen with a wrench
to remove.
11. Reinstall the aerator into faucet after flushing the water lines
and tighten with a wrench.
Aerator:
The aerator should be removed periodically and cleaned out
under running water. If it is very dirty it should be put in common
household vinegar and allowed to soak overnight. Reinstall and
tighten with a wrench.
Chrome faucet:
model series
KKFV01SP
A
A. aerator
Use liquid cleansers or soapy water. Polish with a soft cloth.
NOTE: Anti-lime or acidic cleansers such as scouring agents or
abrasive sponges are to be avoided.
Stainless Steel faucet:
Use a cloth and clean water or a very diluted washing liquid.
Polish with a soft cloth.
NOTE: Anti-lime or acidic cleansers such as scouring agents or
abrasive sponges are to be avoided.
3
Troubleshooting guide
PROBLEM
Slow or No water flow.
CHECK THE FOLLOWING
■ Assure that water supply valves are fully open.
■ Assure braided faucet hoses are not twisted and are free from kinks.
■ Assure household main water supply is not shut off.
■ Assure faucet aerator is free of debris that could cause a plugged condition.
See “Cleaning” section.
Faucet leaks at spout.
■ Check that faucet lever is in the off position.
■ Faucet may drip for up to a minute after shutting off. This is the natural construction of the faucet.
■ Check that lock nut under faucet lever is tight.
To check this:
- Remove faucet lever, lever base assembly and cap to expose lock nut. Tighten lock nut. If
leak persists, the cartridge under the lock nut should be replaced.
4
Faucet lever loose.
■ Tighten set screw in lever with supplied Allen wrench.
Pullout spray head does
not pull out to a
satisfactory distance.
■ Check that area under sink cabinet is free from any articles that may impede the travel of the hose.
■ Check the position of the weight(s) on the hose that will allow desired travel. Move weight(s)
position to allow more travel when spray head is pulled out.
KitchenAid™ Faucets Warranty
One Year Limited Warranty
For one year from date of purchase, when this faucet is installed, operated and maintained
according to instructions attached to or furnished with the product, KitchenAid will replace this
faucet with an equivalent faucet supplied by KitchenAid if this faucet is found to be defective in
materials or workmanship under conditions of normal use. This warranty extends to the original
purchaser only.
Second through Third Year
Limited Warranty on Stainless
Steel Finish
(residential installations only)
In the second through third year from date of purchase, when this faucet is installed and
maintained according to instructions attached to or furnished with the product, KitchenAid will
replace the faucet with an equivalent faucet supplied by KitchenAid if the stainless steel finish on
this faucet is found to be defective in materials or workmanship under conditions of normal
household use. This warranty extends to the original purchaser only.
Second through Fifth Year
Limited Warranty on Chrome
Finish
(residential installations only)
In the second through fifth year from date of purchase, when this faucet is installed and
maintained according to instructions attached to or furnished with the product, KitchenAid will
replace the faucet with an equivalent faucet supplied by KitchenAid if the chrome finish on this
faucet is found to be defective in materials or workmanship under conditions of normal
household use. This warranty extends to the original purchaser only.
Second through Tenth Year
Limited Warranty on Faucet
Cartridge
(residential installations only)
In the second through tenth year from date of purchase, when this faucet is installed and
maintained according to instructions attached to or furnished with the product, KitchenAid will
replace the faucet cartridge with a faucet cartridge supplied by KitchenAid if the faucet cartridge
is found to be defective in materials or workmanship under conditions of normal household use.
This warranty extends to the original purchaser only.
KitchenAid WILL NOT Pay for:
1. Service calls to correct the installation of your faucet, instruct you how to use your faucet, or to repair or replace household
plumbing.
2. Limited warranty repairs after the first year when your faucet is used in other than normal, single-family household use.
3. Damage resulting from accident, alteration, unauthorized modification, misuse, abuse (such as heavy impact), fire, floods, acts
of God, improper installation or installation not in accordance with local plumbing codes, or use of products not approved by
KitchenAid.
4. Damages resulting from improper care or maintenance.
5. Damages resulting from improper applications, such as exposure to corrosive chemicals, photographic solutions, etc.
6. Any unauthorized modifications made to the product after it leaves KitchenAid (or its suppliers) premises whether performed by
a contractor, service company, or you.
7. Any labor costs during the limited warranty periods.
8. Repair or replacement parts for units operated outside the United States.
9. Transportation and labor costs associated with removal or reinstallation of covered parts.
KITCHENAID SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES
Some states do not allow the exclusion or limitation of incidental or consequential damages, so this exclusion or limitation may not
apply to you. This warranty gives you specific legal rights and you may also have other rights, which may vary from state to state.
Outside the 50 United States, this warranty does not apply. Contact your authorized KitchenAid dealer to determine if another
warranty applies.
If you believe you have a warranty claim, contact KitchenAid through your Dealer, Plumbing Contractor, Home Center or E-tailer. Or
call our Customer Interaction Center at 1-800-422-1230 from anywhere in the USA, or write: KitchenAid Brand Home Appliances,
Customer Interaction Center, 553 Benson Road, Benton Harbor, MI 49022-2692. In the event of a warranty claim, the owner will be
required to provide proof of purchase, model and serial number, finish, a copy of the original invoice showing the seller and date
the product was purchased, and a complete description of the problem. KitchenAid reserves the right to inspect any faucet
reported to be defective prior to replacement of the faucet. All decisions are final.
This warranty supersedes all other warranties, expressed or implied.
5
Replacement parts list
9
8
4
9
3
2
10
11
1
4
8
13
5
6
12
3
7
2
1
5
10
6
14
11
Model Series
KKFV01LP
Item
Description
7
Item
19
16
17
18
20
Description
Lever base assy
Spring
3
Lever
4
Screw
5
Cap
Part Number
6
Nut
*
*
*
*
*
*
7
Cartridge
8
Spout assy
*
9
Aerator set
8211403
10
Base
11
Mounting assy
1
2
Lever base assy
Spring
3
Lever
4
Screw
5
Cap
6
Nut
7
Cartridge
8
Spout assy
9
Plastic insert
10
Screen
11
Pull down spray
12
Aerator set
13
Screw
14
O-ring
15
Base
16
Fiber washer
8211404
17
18
Check valve assy
Weight
8211410
8211407
19
Mounting assy
8211411
20
Hose
8211405
*This part not serviceable.
6
1
2
Model Series
KKFV01SP
15
Part Number
8211401
*
8211417
8211406
Stainless - 8211402
Chrome - 8211416
8211403
*
*
*
*This part not serviceable.
*
*
*
*
*
*
8211409
*
8211411
Replacement parts list
4
3
2
1
5
6
15
7
14
13
12
8
Model Series
KKFV01PP
Item
9
11
10
20
17
16
Description
Part Number
1
2
Lever base assy
Spring
3
Lever
4
Screw
5
Cap
6
Nut
7
Cartridge
8
Body
9
O-ring
10
Base
11
Teflon ring
12
Insert
8211418
13
Screen
14
Pull-out assy
15
Aerator set
8211406
Stainless - 8211408
Chrome - 8211415
8211403
16
Check valve assy
8211410
17
Fiber washer
8211404
18
Hose
8211405
19
Weight
8211407
20
Mounting assy
8211411
*
*
*
*
*
*
8211401
*
*
*
*
*This part not serviceable.
19
18
7
®
HOME APPLIANCES
8559765A
© 2005 KitchenAid
® Trademark of KitchenAid, U.S.A., KitchenAid Canada licensee in Canada.
Printed in U.S.A.
09/2005
Download PDF

advertising