18286 Iss 2 HB750 multi A5
HB850 series
instructions
5
4
3
2 1
●
●
●
before using your Kenwood appliance
Read these instructions carefully and retain for future
reference.
Remove all packaging and any labels. Throw away
the blade cover from the triblade as it is to protect the
blade during manufacture and transit only. Take
care as the blades are very sharp.
Wash the parts – see “care & cleaning”.
●
●
●
safety
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Take special care when preparing food for babies, the
elderly and infirm. Always ensure that the hand
blender shaft is thoroughly sterilised. Use a sterilising
solution in accordance with the sterilising solution
manufacturers instructions.
Never touch the blades while the appliance is
plugged in.
Keep fingers, hair, clothing and utensils away from
moving parts.
Unplug from the power supply when not in use.
Never blend hot oil or fat.
For safest use it is recommended to let hot liquids
cool to room temperature before blending.
Never use a damaged hand blender. Get it checked
or repaired: see ‘service’.
Never put the power handle in water or let the cord
or plug get wet - you could get an electric shock.
Never let the cord touch hot surfaces or hang down
where a child could grab it.
Never use an unauthorised attachment.
Always disconnect the hand blender from the power
supply if it is left unattended and before assembling,
disassembling or cleaning.
Do not allow children to use the hand blender without
supervision.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Only use the appliance for its intended domestic use.
Kenwood will not accept any liability if the appliance
is subject to improper use, or failure to comply with
these instructions.
The maximum rating is based on the attachment that
draws the greatest load. Other attachments may
draw less power.
●
●
●
●
important
With heavy mixtures, don’t use your hand blender for
longer than 50 seconds in any four minute period - it
will overheat.
before plugging in
Make sure your electricity supply is the same as the
one shown on the hand blender.
Important – UK only
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by a 13A approved
(BS1362) fuse.
Note:
For non-rewireable plugs the fuse cover MUST be
refitted when replacing the fuse. If the fuse cover is
lost then the plug must not be used until a
replacement can be obtained. The correct fuse cover
is identified by colour and a replacement may be
obtained from your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it must be
DESTROYED IMMEDIATELY. An electric shock hazard
may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
This appliance conforms to EC directive 2004/108/EC
on Electromagnetic Compatibility and EC regulation
no. 1935/2004 of 27/10/2004 on materials intended
for contact with food.
key
●
●
5 speed control
ON/OFF button
power handle
metal blender shaft with fixed triblade
blender shaft release buttons
to use the hand blender
You can blend baby food, soups, sauces, milk shakes
and mayonnaise etc.
for saucepan blending
Take care when blending hot liquids - take the pan off
the heat and let it cool before blending.
1 Fit the blender shaft to the power handle –
push to lock.
2 Place the food into a suitably sized container. We
would recommend a tall straight sided vessel, larger
than the foot to allow movement of the ingredients
but tall enough to prevent spillage.
2
service and customer care
3 Plug in. To avoid splashing, place the blade in the
food before switching on.
4 Select the required speed by rotating the speed
control (Use speed 1 and 2 for slower blending).
● Don’t let liquid get above the join between the power
handle and blender shaft.
● Move the blade through the food and use a mashing
or stirring action to incorporate the mixture.
● Your hand blender is not suitable for ice crushing.
● If your blender gets blocked, unplug before clearing.
5 After use, unplug and press the release buttons to
remove the blender shaft from the power handle.
●
UK
If you need help with:
● using your appliance
● servicing or repairs (in or out of guarantee)
call Kenwood Customer Care on 023 9239 2333.
Have your model number ready - it is located
on the underside of your appliance.
● spares and attachments
call 0870 2413653.
other countries
● Contact the shop where you bought your appliance.
Optional attachment (not supplied in pack)
Mini chopper - refer to “service and customer care”
section to order.
care and cleaning
●
●
●
●
●
●
●
●
●
●
●
●
If the cord is damaged it must, for safety reasons, be
replaced by KENWOOD or an authorised KENWOOD
repairer.
Always switch off and unplug before cleaning.
Don’t touch the sharp blades.
Take special care when preparing food for babies, the
elderly and infirm. Always ensure that the hand
blender shaft is thoroughly sterilised. Use a sterilising
solution in accordance with the sterilising solution
manufacturers instructions.
Designed and engineered by Kenwood in the UK.
Made in China.
IMPORTANT INFORMATION FOR CORRECT
DISPOSAL OF THE PRODUCT IN ACCORDANCE
WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be
disposed of as urban waste.
It must be taken to a special local authority differentiated
waste collection centre or to a dealer providing this
service.
Disposing of a household appliance separately avoids
possible negative consequences for the environment
and health deriving from inappropriate disposal and
enables the constituent materials to be recovered to
obtain significant savings in energy and resources. As a
reminder of the need to dispose of household
appliances separately, the product is marked with a
crossed-out wheeled dustbin.
power handle
Wipe with a slightly damp cloth, then dry.
Never immerse in water or use abrasives.
Do not dishwash.
blender shaft
either
Part fill a suitable container with warm soapy water.
Plug into the power supply, then insert the blender
shaft and switch on.
Unplug, then dry
or
Wash the blades under running water, then dry
thoroughly.
Do not dishwash.
3
HEAD OFFICE: Kenwood Limited, 1-3 Kenwood Business Park, New Lane, Havant, Hampshire PO9 2NH
40529/1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement