Sony XS-GM6930 Operating instructions

Sony XS-GM6930 Operating instructions
2-665-620-11 (2)
Specifications
Precautions
Speaker
• Do not continuously use the speaker system
beyond the peak power handling capacity.
• Keep recorded tapes, watches, and personal
credit cards using magnetic coding away from
the speaker system to protect them from
damage caused by the magnets in the
speakers.
Peak power
Rated power
Impedance
Sensitivity
Frequency response
Mass
Supplied accessory
Coaxial 3-way:
Woofer 16 × 24 cm, PP,
cone type
Midrange 4 cm, PET, dome
type
Tweeter 0.8 cm, PET, dome
type
220 W
40 W
4 Ω
92 dB/W/m
30 – 25,000 Hz
Approx. 750 g per speaker
Parts for installation
If you cannot find an appropriate mounting
location, consult your car dealer or your
nearest Sony dealer before mounting.
Design and specifications are subject to change
without notice.
16 × 24 cm Coaxial
3-way Speaker
Installation/Connections
Unit: mm
Dimensions
194
35
118
ø 75
216
239
264
166
5.5 × 9.5
6
70
147
166
XS-GM6930
 2006 Sony Corporation Printed in China
Mounting
Parts list
Before mounting
A depth of at least 70 mm is required for flush mounting. Measure the depth of the area where you are
to mount the speaker, and ensure that the speaker is not obstructing any other components of the car.
Keep the following in mind when choosing a mounting location:
•Make sure that nothing is obstructing around the mounting location of the rear tray where you are
to mount the speaker.
•A hole for mounting may already be cut out of the inner panel of the rear tray. In this case, you need
to modify the board only.
•If you are to mount this speaker system in the rear tray, make sure that the speaker terminals, frame
or magnet do not touch any inner parts of the car, such as the torsion bar springs (when you open or
close the trunk lid), etc.
Also make sure that the speaker grille does not touch any inner fittings, such as seat belts, head rests,
center brake lights, inner covers of the rear wipers, curtains or air purifiers etc.
1
2
4
3
M4 × 70
5m
×2
5
6
×8
×8
7
×8
×2
×2
Mounting from the car interior
1
Mark the 4 bolt holes and
make them 5 mm in diameter.
2
3
3
3
3
1
6
6
217 mm
6
148 mm
Rear tray
2
Striped cord
7
2
x
7
2
ø5
To speaker cord of a car.
2
5
4
5
4
5
4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement