Memorex VX3038 User's Manual

Memorex VX3038 User's Manual
SIZE:74x105mm
VX3038
STEREO CASSETTE PLAYER
CONTROLS
PRECAUTIONS
1. PHONES jack
2. VOLUME control
3. DC IN 3V jack
4. PLAY button:
5. STOP button:
6. F.FWD buttons:
POWER SUPPLY
Batteries: 2 x " AA" batteries (UM-3/R6)
(not included with this unit)
NOTE:
Replace the batteries if you hear
distortion.
Incorrectly using batteries can cause
them to leak or burst, and may
damage your unit.
Note the following precautions:
Be sure that the plus (+) and
minus (-) poles are facing in the
correct directions.
Do not mix battery types.
Do not mix new batteries with old
ones.
Never leave dead batteries in the
battery compartment.
Remove batteries when not using
the unit for extended periods.
Never try to recharge the batteries
that are specified for the power
supply of this unit.
Do not expose batteries to direct
heat, let them become shorted or
try to take them apart.(If a battery
leaks, clean out the battery
compartment of the unit
immediately, taking care to avoid
letting the battery fluid come into
direct contact with your skin.)
IMPORTANT
Avoid continuous high volume setting
when using headphones! Your
normal hearing ability may otherwise
be seriously affected!
OPERATING INSTRUCTIONS
3
4
Frequency
response:
60-10,000 Hz(Normal tape)
Dimensions: 111 x 84 x 31 (WHD)
Weight:
136g (with out batteries)
FOR ADDITIONAL SET UP OR OPERATING
ASSISTANCE, PLEASE CONTACT
CUSTOMER SERVICE AT (954) 660-7100
PLEASE KEEP ALL PACKAGING MATERIAL
FOR AT LEAST 90 DAYS IN CASE YOU
NEED TO RETURN THIS PRODUCT TO
PLACE OR PURCHASE. FOR PARTS AND
ACCESSORIES, CONTACT FOX
INTERNATIONAL AT 1-800-321-6993
SUBJECT TO MODIFICATION WITHOUT NOTICE!
6
7
2
CASSETTE TAPE OPERATION
PLAYBACK
1.Plug the headphones to the
PHONES jack.
2.Adjust the VOLUME control to the
lowest position.
3.Open the cassette compartment.
4.Insert a pre-recorded cassette tape
into the cassette compartment
so that the open edge faces up.
5.Press the PLAY button.
6.Adjust the VOLUME control to your
comfortable listening level.
7.To stop the tape, press the STOP
button.
5
FAST FORWARD
1.To fast wind a tape, push the
F.FWD button.
2.When the desired location has
been reached push the STOP
button.
SPECIFICATION
DC:
AC:
3V, 2 x AA (R6P) batteries
with AC adapter (1.3 plug,
center pin negative, DC 3V)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement