- Computers & electronics
- Telecom & navigation
- Mobile phones
- Car kits
- Metra Electronics
- 99-7579
- User manual
advertisement
▼
Scroll to page 2
KIT FEATURES Shaft and DIN unit provisions Equalizer provisions Various mounting depth alternatives KIT COMPONENTS Radio Housing 99-7579 INSTALLATION INSTRUCTIONS APPLICATIONS CAR PAGE NISSAN Pathfinder 1996-00.................................................1-2 Faceplate Equalizer Dummy Plate Snap Spacers (4) #8 x 1" Phillips Pan-head Screws TOOLS REQUIRED Phillips screwdriver 1-800-221-0932 Rev.130103 Adjustable wrench www.metraonline.com © COPYRIGHT 2001 METRA ELECTRONICS CORPORATION 3 ALL VEHICLES Fig. A 1 Fig. B IF AN EQUALIZER WILL BE INCLUDED: Slide the aftermarket equalizer into the back of the Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit. (see Fig. A) Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) screws from the base of the radio trim bezel. Unclip the bottom edge of the radio trim bezel and disconnect the hazard light, defroster, wiper and cligarette lighter wiring. Remove the radio trim bezel. Remove (4) screws securing the factory head unit and disconnect the wiring. IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the Radio Housing. (see Fig. B) 4 2 A 5 B *OPTIONAL C Fig. A D Fig. B 2-SHAFT HEAD UNITS: Attach the Faceplate to the Radio Housing. Slide the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A) DIN HEAD UNITS: Attach the Snap Spacers* to the inner walls of the Radio Housing. Slide the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B) 1 A) Strip wire ends back ½" B) Twist ends together C) Solder D) Tape Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit). Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit assembly to the sub-dash with (4) screws previously removed in step #1. 2
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project