BLOCK WIRING DIAGRAM RL360 RL200
BLOCK WIRING DIAGRAM RL360
RL200
WITH DEFUSER g5
REAR
RADAR
LED/POD
BLUE
BLUE
GPS
MODULE
(GPS)
ORANGE
GRAY
PURPLE
BLACK
GRAY
FRONT
RADAR
LED/POD
BROWN
(INTERIOR
MOUNTING
ONLY)
USE THE SUPPLIED 2-WAY
TAPE TO MOUNT TO DASH,
FRONT WINDSHIELD OR
REAR WINDSHIELD DECK.
GRAY
WHITE
WHITE
GROUND
#8 X 1/2"
TEK SCREW
*NOTE: DRILL 3/16” HOLE FOR LED.
BLACK
(DO NOT TAP INTO FACTORY GROUND WIRE)
RED
2 AMP FUSE
IGNITION
SWITCHED
+12 VOLTS
IGNITION AND GROUND
SPEAKER
1. Use a test meter to locate a +12v ignition
switch source for the Host.
2. Connect the black wire to a solid chassis
ground (K40 recommends the driver’s
side kick panel) using the provided ring
terminal and silver self-tapping screw.
MUTE
VOL
VOL
VOL
VOL
HOST
REMOTE
CONTROL
(RCU)
LASER INTERFACE
MODULE
L1
CITY/HWY
CITY/HWY
POWER
L2
BROWN
YELLOW
BLACK
WHITE
WHITE
INTERFACE
CABLE
H
O
S
T
RED
GREEN
*SEE NOTE
BROWN
BROWN
GREEN
GREEN
FRONT RADAR
RECEIVER
(RLF)
BLUE
BLUE
BROWN
BROWN
GREEN
GREEN
REAR RADAR
RECEIVER
(RLR)
(RL360 MODEL ONLY)
RECEIVERS MUST BE
INSTALLED HORIZONTALLY.
DO NOT OBSTRUCT UNIT
FACE WITH METAL, CHROMEPLATED PLASTIC OR
CARBON FIBER.
RECEIVERS MUST BE
INSTALLED HORIZONTALLY.
DO NOT OBSTRUCT UNIT
FACE WITH METAL, CHROMEPLATED PLASTIC OR
CARBON FIBER.
L3
L4
(FOR OPTIONAL DEFUSER)
MARK
(INTERIOR
MOUNTING
ONLY)
*NOTE: GREEN WIRE CONNECTON
1. GREEN WIRE CONNECTED TO CHASSIS GROUND =
CONTINUOUS LASER EMITTER OUTPUT.
2. GREEN WIRE CONNECTED TO +12 FUSED IGNITION =
10 SECOND PULSED EMITTER OUTPUT.
3. GREEN WIRE NOT CONNECTED = LASER RECEIVE ONLY.
(TAPE OFF GREEN WIRE )
K40 DAYTIME TECHNICAL SUPPORT
800-323-6768
24 HR. TECHNICAL SUPPORT
800-784-9144
9/12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement