Nikon | AUTOFOCUS SB-28D | User's Manual | Nikon AUTOFOCUS SB-28D User's Manual

When using the flash off-camera
with a dedicated sync cord:
5 Aim the flash directly at the
subject.
Aiming the flash incorrectly can
cause over- or under-exposure.
6 Be careful not to cover the sensor
on the Speedlight.
This can produce unexpected
results.
Refer to the DCS 600 Series User’s
Manual (included on the documentation CD), or the SB-28 instruction
manual (included with your
Speedlight).
EASTMAN KODAK COMPANY
Rochester, New York 14650
© Eastman Kodak Company, 2000
Kodak and Kodak Professional are trademarks.
Printed in U.S.A.
P/N 4E1562
5/00
NIKON Autofocus
SB-28D and SB-28DX
Speedlight
Using with your
KODAK PROFESSIONAL
DCS 600 Series Camera
General guidelines for using the
SB-28D/SB-28DX Speedlight with
your DCS 600 Series camera:
1 Use the Sub-Command dial, not
the lens aperture ring, to set
aperture.
TTL auto flash is NOT
recommended.
3 The automatic exposure control
range of the SB-28DX Speedlight
is partially determined by the
selected ISO speed on the
camera. Closer subjects may
require lower ISO settings. The
following table specifies the
widest aperture recommended
for each camera’s minimum ISO:
Minimum Maximum
ISO
Aperture
Using the Sub-Command dial
assures that the Speedlight
receives the lens aperture setting.
2 Set Flash mode to Auto Aperture.
A
ISO
0.6 0.8 1 1.5 2 3 4 6 9 13 18 m
STBY
ZOOM
mm
ZOOM MODE SEL
FLASH
ON / OFF
DCS 620X
400
f4
DCS 620
200
f2.8
DCS 660
80
f2.8
4 For the lens focal length and
aperture in use, make sure your
subject is within the distance
indicated on the Speedlight’s LCD
panel.
Download PDF

advertising