Oreck | XJ-350 | User's Manual | Oreck XJ-350 User's Manual

Operating Instructions
Using the Fabric Shaver
S I M P L Y
A M A Z I N G
®
USER’S GUIDE
ELECTRIC
FABRIC SHAVER
MODEL XJ-350
USA: 1-800-989-3535
CANADA: 1-888-676-7325
COMMERCIAL: 1-800-242-1378
www.oreck.com
www.oreckcommercial.com
•IMPORTANT•
SAVE THIS
BOOKLET!
VISIT ONE OF OUR OVER
450 STORE LOCATIONS
REGISTER YOUR PRODUCT
ON THE WEB:
WWW.ORECK.COM
Includes:
Important Safety Instructions
Warranty
Operating Instructions
• Plug A/C power adapter into adapter input (Item 5) or use fabric
shaver with batteries (see battery use below).
• Turn fabric shaver on by using the one touch sliding On/Off
switch (Item 1).
Place fabric you wish to renew on flat surface. Holding the device by its handle,
gently move it over the fabric. Pull the fabric as straight as possible to increase
the efficiency of the device and the results of the fabric repair.
Useful Tips:
• Tuck in exposed threads before shaving wool sweaters or any other
types of fabric to prevent damage.
• Test the fabric shaver on a hidden or inconspicuous area
before using it on the entire fabric surface.
• Do not press the device too hard against the fabric as it may
cause damage.
• It is recommended to put a small amount of lubricating oil on
the inner side of the metal screen cover to allow best possible
operation of the unit. Make sure lubricating oil is not present on
shaver before using to avoid fabric staining.
• After each use, or when storage box is half full, pull out the
storage box (Item 3) and dispose of the fabric shavings inside.
• When efficiency of the device becomes low, open the screen
cover (Item 4) by unscrewing it counter-clockwise. Carefully take out
the cutting blade, then clean the blade and inner compartment with
the soft brush included.
• The device is equipped with a safety switch that will disable
operation when the screen cover is loose or opened.
• Do not use this device to shave easily damaged fabric like
Angolan Fabric. Intricate designs or patterns may be damaged
during shaving process.
BATTERY USE
To insert batteries for battery use, grab both sides of the storage box at the
bottom of the unit and slide out. Open the cover of the battery compartment upward.
Using four (4) “C” size batteries, install according to positive “+” and negative “-”
signs on battery cover, and then place cover back and snap shut. Slide the
storage box back into place.
©2003 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are
owned and used under the authority of Oreck Holdings, LLC. Printed in America
40199-01 REV A
4/03
IMPORTANT
SAFETY
INSTRUCTIONS
Lubrication
• It is recommended to put a small
amount of lubricating oil on the
inner side of the metal screen to
allow optimal operation of blades.
SAVE THESE
INSTRUCTIONS
When using an electrical appliance,
basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE
USING THIS PRODUCT
Assembly
1. ON/OFF switch
2. Handle
3. Storage box
4. Screen Cover
5. A/C adapter input
1
Household Use Only
WARNING
Warranty
To reduce the risk of fire,
electric shock, or injury:
• Do not use outdoors or on wet surfaces.
• Do not expose to rain, store indoors.
• Do not allow to be used as a toy.
Close attention is necessary when
used by children.
• Use only as described in this manual.
Use only manufacturer’s recommended
attachments.
• Do not use extension cords or outlets
with inadequate current carrying
capacity.
• This device is equipped with a
sharp cutting blade. To prevent bodily
injury, do not use the device to
shave hair or skin.
• Do not incinerate or mutilate batteries
as they will explode at high
temperatures.
• Do not let the unit run while in any
one stationary position for any period
of time. Keep the unit moving while
in operation.
• Do not allow water or other liquid to
enter the inner part of the device.
Additional Safeguards
• Always disconnect cord from electrical
outlet before servicing the fabric
shaver.
• Remove batteries from compartments
if the device is not being used
for a prolonged period of time. This
will prevent possible damage
caused by leaking batteries.
• If the adapter or the interconnection
cord is damaged, it must be scrapped.
1
Oreck Corp. warrants that all new
products are free from defects in
material and workmanship under normal,
non-commercial use and service. Oreck
will remedy any such defects if they
appear within one (1) year from date of
purchase. This warranty gives you
specific legal rights, and you may have
other rights which vary state to state.
Register your product on the web:
WWW.ORECK.COM
4
2
3
Repair or Replacement
Your ORECK Fabric Shaver is a product
of precise engineering. If you require
additional information or have problems
with your Oreck product, you may call
ORECK CUSTOMER SERVICE at:
US: 1-800-989-3535
5
Canada: 1-888-676-7325
Please specify the product and model
number.
Save your sales or purchase slip. Should
your Oreck product require warranty service
in the U.S.A., present this slip to the
Authorized Service Center as your proof
of purchase date or, in Canada, call
customer service.
Accessories
Your fabric shaver comes with the following accessories:
• One (1) blade cleaning brush
• One (1) A/C power adapter
2
Download PDF