MCD196
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Quic
Remove the plastic
protective sheet
1
k St
art
Guid
e
CLOCK
Quick Start Guide
Composite Video Cable
Remote control with
battery
2
User Man
ual
MW antenna
MCD196_98 QUG_Eng
FM antenna
1
User Manual
13/2/07, 14:41
1
Connect the speaker cables.
2
Connect the FM and MW antennas.
Tip
3
See the User Manual for other TV
connection options.
Connect the composite video cable to a TV.
4
Connect the power cords of the system and TV.
TV
A
FM antenna
MW antenna
3
AM
AERIAL
2
Speaker
(right)
FM
AERIAL
Speaker
VIDEO OUT
S-VIDEO
VIDEO
(left)
SUB WOOFER
OUT
DIGITAL
OUT
R LINE OUT L
RIGHT
LEFT
A To listen to the sound of this DVD Player
through your TV, use the audio cables (white/
red-not supplied) to connect LINE OUT
(L/R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV.
1
+
1
RSP-134V
–
SPEAKER 4Ω
AUDIO OUT
L
R
4
B
AC power cord
B To listen to the sound of your TV through
this DVD player, use a cinch cable (not
supplied) to connect AUX on the front
panel of the DVD player to the
corresponding AUDIO OUT jacks on the TV.
CLOCK
Setting up the TV
1
Press SOURCE (DISC on the remote) to select disc source.
2
Turn on the TV and set it to the correct Video In channel.
MCD196_98 QUG_Eng
2
13/2/07, 14:41
Setting the clock
1
M I C RO T H E AT R E M C D 1 9 6
STANDBY-ON
In standby mode, press and hold DISPLAY/CLOCK SET on the system.
SOURCE
DISPLAY/CLOCK SET
-
DBB
2
VOLUME
+
SET
DSC
iR
PRESET
When the hour digits flash, pressí/ëon the front panel or on the remote to set the
hours.
AUX
TUNING
PRESET
3
Press DISPLAY/CLOCK SET again and the minute digits flash. Then press í/ë on the
front panel or on the remote to set the minutes.
4
DVD/WMA-MP3-CD COMPATIBLE
PULL TO OPEN
Press DISPLAY/CLOCK SET again to confirm the time setting.
Setting system menu options
CLOCK
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
MCD196_98 QUG_Eng
3
13/2/07, 14:41
Playing a disc
1
Press OPEN•CLOSE 0 to open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜ Make sure the label side of the disc is facing up.
2
Playback will start automatically. If not pressÉÅ.
3
To stop playback, press 9.
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote) to select tuner source.
2
Press PROG/ANGLE for more than two seconds to program all available stations in
order of waveband.
3
Press PRESETí/ë until the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
C Royal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
MCD196_98 QUG_Eng
4
PDCC-JH/ZC-0708
13/2/07, 14:41
Download PDF

advertising