PYLE Audio PLVWH1 User's Manual

WIRELESS INFRARED SURROUND HEADPHONE

PLVWH1

Overview

The PLVWH1 is a true wireless headphone system which uses latest

high frequency modulation infrared technology. You can enjoy music by simply connecting the supplied infrared transmitter to any of your audio/video equipment through either a line output jack or a headphone jack. This system is easy to set up within your car. It provides you with ultimate personal listening freedom.

Features

An optical transmission system with high frequency modulation guarantees excellent nd surround sound quality and wide effective transmission range.

The well designed transmitter and headphone with built-in receiver are omnidirectional in sending and receiving audio signals within a 7 meter radius, which are generally not susceptible to be blocked by objects between them.

True surround sound, elegant design and rich finish of the system add into the beauty of your expesive automobile entertainment systems.

The signal input level is automatically adjusted by the built-in Automatic

Input Level control Circuit (ALC).

Since this system uses infrared ray, if the headphones/receivers are placed too far from the transmitter, a hissing noise may increase. This is a characteristic of infrared systems and does not mean that the system is defective Do not use this system in the open air under direct sunlight as the infrared system will not work properly.

1

Precautions

* Operate the transmitter on 12V 100mA. Operate the headphone

system on3V DC (size AAA batteries x 2).

* Turn off the power of the transmitter and the system is not in use.

* Do not open the cabinet. Refer servicing to qualified personnel

only.

* Do not leave the system in a location near heat sources such as

radiators or airducts, or in a place subject to direct sunlight,

excessive dust, moisture, rain, mechanical vibrantion, or shock.

* Do not use alcohol, benzine or thinner to clean the cabinet.

Headphone

1. Infrared sensors

2. Power Switch

3. Stereo / mono

4. Volume Controls

5. Battery Compartment Door

6. Ear pad

7. Adjustable headband

IR Stereo Headphone

1. Open the battery compartment door on the right of the

headphone.

2. Insert two size AAA batteries with correct polarity.

3. Close the battery compartment.

2

How to use

1. Turn on the audio/video equipment

connected to the transmitter.

2. Turn on the power switch for

headphone.

3. Adjust volume control on the

left side. Do not cover the sensors

while adjusting volumes.

4. Turn on the stereo switch for

stereo effect. For Mono

audio/video equipment, turn

the switch to the mono position.

5. Receiving Positions

The headphon/Receiver receives audio signals omni-directionally

and in line-of-sight within certain effective ranges.

For best reception, use th headphone. within 5 meters from the emitter

of the transmitter.

Specifications:

* POWER REQUIREMENTS: 3VDC (1.5V AA x 2)

* TYPE: OPEN AIR DYNAMIC

* DRIVE UNIT: 40 mm MYLAR CONE

* IMPEDANCE: 32 OHM +-6.4 OHM

* FREQUENCY RESPONSE: 20 Hz ~ 23 KHz

* S.P.L.: 98 dB / NOM. DEV

* DISTORTION: 1 PERCENT THD AT NOM. DEV.

* BATTERY LIFE (AT 10mv OUTPUT): ABOUT 48 HOURS

WEIGHT: ABOUT 170 gr. (EXCLUDING BATTERIES)

3