PYLE Audio PWMA-840 User's Manual

PYLE Audio PWMA-840 User's Manual
 PWMA-840
OPERATING INSTRUCTIONS
Er LAA AR
SINGLE VHF LURELESS
BATTERY POWERED PR SYSTEM
WITH ECHO. AND CASSETTE
www.pyleaudio.com
ное м в
8.
yENERAD DESCRIPTIONS
|.
It is consist of one set of wireless and two wired microphone input cir-
cuits. both of them has separated volume control.
. VHF high band wireless transmitter and recerver
. It is equipped with built-in 7AH/12V rechargeable battery which can
be charged 6 hours continuously, also DC power can be used directly,
. One guitar input function and one audio input unit both are supplied.
. Treble and bass control are supplied.
Echo control is supplied.
With voltage selector switch for selecting a suitable one according to
different countries.
Radio cassette function is supplied.
REMARKS
He a e
SYSTEM FUNCTIONS FIGURE
1.
(1)
©)
Confirm the power
AC Power: Before operation, please confirm the voltage 1s same as
the specified one marked on the label. If not, the unit will be damaged.
Built-in Rechargeable Battery: You needn't plug-in the AC power
when the voltage for rechargeable battery is enough but use the battery
directly:
When the Low Voltage Indicator comes on yellow, it indicates the ba-
ttery voltage is not enough, please charge it in time.
) When the Low Voltage Indicator comes out, it indicates the voltage
Is standard now.
If the unit 1s not used for a long time, please charge the rechargeable
battery every 2 months, 8-10 hours for each time.
. Operation Instructions:
Plug the power cable into the socket and connect it with this amplifier
system.
Switch on the amplifier, the Power Indicator comes on red.
I Put a 9V battery into handheld microphone
push the Power Switch to middle, the Power Indicator will flash once,
RF Indicator comes on green, the speakers are quiet.
J Push the Power Switch of handheld microphone
to ON position, your sound can be heard from amplifier when
speaking. Adjust the Volume Control/Echo Control/Treble Control/
Bass Control to proper position to avoid feedback.
If the Power Indicator of handheld microphone
comes on at all times, it indicates the battery lack of power,
please replace the battery.
Connect relative cable of guitar with Guitar Input Jack on this system,
you can play wonderful music.
I ныы
NES Cali
3. Wireless Microphone:
(1) Two way wired microphone input jacks are supplied for two people
use simultaneously.
(2) Plug wireless microphones into the jacks separately.
3) Adjust Echo Control to get better sound.
(4) Adjust the volume of each microphone to make sure the sound is
satisfactory.
4. Radio Cassette
1) Normal play : First turn on the power switch/volume control for the
tape. press *STOP/EJECT” button to open the compartment. Then
put a cassette inside, press “PLAY " button to start playing. Finally
adjust main/tape volume control/Treble/Bass control to get perfect
Karaoke effect.
Tape recording . Furst open the compartment. put a vacant cassette
Inside, Then press “REC” and “PLAY” button together to start
recording, the signal from wireless'widred microphone and other
external audio devices Will be recorded on the cassette
2
Tem
AMPLIFIER
Power supply: 1 AC220V/50Hz AC110V/60Hz
including a built-in 12V7AH rechargeable battery
Frequency response: 35Hz-20KHz
SPL : 94dB (1W/M)
TH.D: <1%
Input wired mic: -58dBV 600
Speaker: 8" woofer, 3" tweeter
RMS power: 150
Input jack: 2 X 1/4" wired mic Jack, 1 X 1/4"GUITAR IN jack
1 X Audio/Video input jack
RECEIVER
Carrier frequency range:
RF sensitivity:
[mage rejection:
S/N ration:
Operation range:
TRANSMITTER
Carrier frequency range:
RF power output:
Modulation level:
Operation temperature:
Power supply:
Unit Battery Life:
Mic Battery Life:
177-205 MHz.
=-101dB
=60dB
=65dB
100 ft
177-205 MHz
=10mW
15K
-18 C-60 C
OV
Approx.5 Hours
Approx. 45 Hours
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement