Radio Shack 10A02 User's Manual

Radio Shack 10A02 User's Manual
Remote Controlled A/B Switch
www.radioshack.comSM
OWNER’S MANUAL —
Please read before using this equipment.
15-1968 A
Thank you for purchasing a
RadioShack Remote Control A/B
Switch. Your switch lets you connect
two 75-ohm VHF/UHF/Cable
sources to your television with only
one 75-ohm jack without mixing the
signals. You can connect sources
such as broadcast TV, cable TV, a
VCR, or a video game system, and
switch between the sources without
leaving your seat. The high-isolation
design prevents interference
between the two sources, and the
electronic switching provides
reliable operation because there are
no mechanical parts to wear out.
The hand-held transmitter's
miniature design takes up very little
surface space.
CONNECTING
•
•
•
•
•
•
Cable TV
2nd VCR
TV Antenna
Satellite
Video Game System
Other RF Source
REMOTE CONTROL SWITCH
The remote control switch
has two 75-ohm input
terminals and one 75-ohm
output terminal.
Use 75-ohm coaxial cable
for the connections. Your
local RadioShack store
sells the proper cables and
connection accessories.
1. Connect the output
terminals of the two
75-ohm VHF/UHF/
Cable sources to the
switch's A IN and B IN
terminals.
2. Then, connect the
switch's TO TV output
terminal to your TV
monitor's input
terminal.
If you have a VCR
Hook up your VCR between the switch and your TV so you
can record programming from Source A and Source B.
RF Signal
Source A
THE
A IN
TO TV
B IN
12V DC 100 mA
Power Jack
If you do not have a VCR
Hook up the switch directly to your TV, or hook up a component
with an RF Tuner between your switch and your TV.
RF Signal
Source A
RF Signal
Source B
A-B Switch
•
•
•
•
•
Cable TV
TV Antenna
Satellite
Video Game System
Other RF Source
RF Signal
Source B
A-B Switch
Other Component with
RF Tuner
VCR
OR
! IMPORTANT !
© 2002 RadioShack Corporation.
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for
pertinent information.
! — Important
Ô — Note
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
INSTALLING BATTERIES
POWERING YOUR SWITCH
The transmitter requires two AA batteries
(not supplied). Batteries are available at your
local RadioShack store or online at
www.radioshack.com.
Connect the supplied AC adapter to the
power jack on the back of the switch. Then,
plug the other end of the adapter into a
standard AC outlet. The power turns on.
1. Slide the battery compartment cover
on the back of the transmitter in the
direction of the arrow to remove it.
USING YOUR SWITCH
OP
EN
2. Place the batteries in the
compartment according to the
polarity symbols (+ and –)
marked inside. Ô
To operate the
remote control A/B
switch, simply point
the transmitter at the
INFRARED
REMOTE window on
the front of the
remote control switch
and press A or B to
switch between the
two 75-ohm sources.
Or, press A-B on the
top of the switch.
Ô BATTERY NOTES Ô
A-B
A
B
INFRARED REMOTE
Window
Transmitter
3. Replace the battery
compartment cover.
When the switch stops operating properly,
replace the batteries.
After you complete all connections, place the
remote control A/B switch in a location that
exposes the switch's INFRARED REMOTE
window, on top of the TV, for example.
SPECIFICATIONS
Input ......................................................................................................................75 Ohms, F-Connector × 2
Output ...................................................................................................................75 Ohms, F-Connector × 1
•
Dispose of old batteries promptly and
properly.
Isolation .................................................................................................................... 5 – 216 MHz 80 dB Min;
216 – 550 MHz 65 dB Min;
550 – 900 MHz 50 dB Min
•
Do not burn or bury batteries.
Insertion Loss ............................................................................................................................1.5 dB (Max.)
•
Use only fresh batteries of the required size
and recommended type.
•
•
Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
Remote Control Range ................................................. 23 Ft (7 m) (At 0° Angle) 16 Ft (5m) (At ±15° Angle)
Power Source ..............Class 2, Regulated 120V AC, 60 Hz; 12V DC, 100 mA, Positive (+) Tip AC Adapter
Use of any other power source may cause damage.
Specifications are typical; individual units might vary. Specifications are subject to change and improvement
without notice.
If you do not plan to use the switch for a week
or more, remove the batteries. Batteries can
leak chemicals that can destroy electronic
parts.
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90)
days from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT
AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE
WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF
THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME,
DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF
RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date to
any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair without
charge for parts and labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price. All replaced
parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess voltage or
current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries;
(d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up service adjustment
or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99
RadioShack Corporation
Fort Worth, Texas 76102
15-1968 A
10A02
Printed in China
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement