Radio Shack | PLVWR900 | User's Manual | Radio Shack PLVWR900 User's Manual

INSTRUCTION MANUAL
PLVWR900
POWER
ON/OFF
OPEN/CLOSE
HD TFT LCD MONITOR
SEL
PLVWR900
9 INCH HIGH RESOLUTION TFT LCD MONITOR
WELCOME
Thank you for the purchase of this monitor.Before operating the unit,please read this
manual thoroughly and retain it for future reference.
Precautions
To prevent short-circuiting of the electrical system and cause serious damage to the
unit or the vehicle, you are advised to follow the instructions carefully.
Should there be requirement to replace blown fuse,do remember to disconnect all
power supply and switched off the unit before replacing it with a new one.Use only
correct rating fuse to avoid damage the unit.
During operation,if there is symptom of over-heating or system mal-function,do switch
off the unit and consult your dealer immediately.Please do not attempt to open up the
unit since there is no serviceable parts inside.
To avoid damaging the LCD panel and cause serious injury to you or others,please
observe the followings:
Do not drop the LCD display panel of subject it to direct impact.
Should the LCD panel is broken,do avoid all human contact to the broken glasses or
Fluid leaked out from the enclosure.If come into contact ,do flush and clean affected
areas with plenty of water.Seek medical attention immediately.
This unit is designed using high quality electronic components and manufactured
under stringent quality control system.The system unit will provide many hours of
quality performance if use correctly.Do follow the maintenance procedure below:
The battery life of the remote control unit is about six months long.To ensure effective
control,please replace the batteries regularly.Do not use new and used batteries at the
same time to avoid damaging the good battery.
Do not use any chemical solvent,cleaning agent or corrosive detergent to clean away
dirt on the surface of the screen.By doing so,you may cause irreversible damage to the
surface of the TFT screen.To clean off dirt or finger prints,we recommend the use of a
soft damp lens cleaning cloth.
PRODUCT FEATURE
High resolution full color TFT
Brand new LCD panel
Easy installation,compact size
provides VCR/VCD/DVD/Game player signal input
Two video inputs
With remote control
on screen display menu
Auto power off if no signal for 10 minutes
Low voltage autoalarm
FRONT PANEL
1
2
3
POWER
ON/OFF
OPEN/CLOSE
4 5 6
7
SEL
8
1.neon light power on/off
2.power indicator
3.open/close the monitor
4.negative adjustment
5.menu activate
6.positive adjustment
7.monitor power on/off
8.reset
A.The image will be shown 4 to 5 seconds later
after press (7).
HD TFT LCD MONITOR
PLVWR900
B.Press (1) for over 4 seconds to turn the neon off.
C.Reset to the factory default value by (8).
Note:Although the effective pixels for the liquid crystal is given as 99.98% or more,
0.02% of pixels may not light or may light incorrectly.It is a very common phenomenon
in active matrix display technology,do not indicate fault or broken of the unit.
REMOTE CONTROL
1
AV1/2
2
3
4
5
6
7
8
1.power on/off
2.V1/V2 switch
3.brightness 4.brightness +
5.color 7.color +
7.contrast 8.contrast +
SPECIFICATION
Screen size
9 inch(diagonal)
Display method
TFT active matrix system
Back light
Cold cathode fluorescent lamp
System
PAL & NTSC
Aspect ratio
16:9
Power source
DC 12V
Resolution
1024x532
Power consumption
10W
Max video input
1.0Vp-p
Input impedance
75 Ohm
Dimension
24.2x15.7x3.2cm
WIRING
RED: DC 12V
BLACK:GND
YELLOW:V1 INPUT
WHITE: V2 INPUT
Pyle ,Inc
1600 63rd Street
Brooklyn,NY 11204
www.pyleaudio.com
Download PDF